Planet Technology EV-401S инструкция обслуживания

Ethernet Over VDSL Converter EV-401M / EV-401S User’s Manual[...]

PLANET Ethernet over VDSL series 2 Trademarks Copyright  PLANET Technology Corp. 2001. Contents subject to revision without prior notice. PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective owners. FCC Warning This equipment has been tested and found to comply with the limits for a Class B [...]

EV-401M / EV-401S User's Manual 3 TABLE OF CONTENTS 1. INTRODUCTION ........................................................................ 5 1.1 C HECKLIST ................................................................................ 5 1.2 I NTRODUCTION T O E THERNET OVER VDSL C ONVERTER .........6 1.3 K EY F EATURES .....................[...]

PLANET Ethernet over VDSL series 4 This page intentionally left blank![...]

EV-401M / EV-401S User's Manual 5 1. INTRODUCTION 1.1 Checklist Check the contents of your package for following parts:  Ethernet over VDSL Converter  User's manual  Power cord  Telephone line If any of these pieces are missing or damaged, please contact your dealer immediatel y, if possible, retain the carton including the or[...]

PLANET Ethernet over VDSL series 6 1.2 Introduction To Ethernet over VDSL Converter General Description The converter is a switching architecture with four RJ45 10/100Mbps Fast Ethernet switching ports and one 10Mbps RJ11 symmetric Ethernet over VDSL port (symmetry means 10Mbps upstream and 10Mbps downstream data rate). it is ideal for signal conve[...]

EV-401M / EV-401S User's Manual 7 central side. If you want to se tup one pair of converters for point-to-point connection then one set must be client mode and the other one is master mode. The cable specifications of the connection are listed as following:  10BASE-T , Category 3, 4 or 5 UTP  100BASE-TX, Category 5 UTP  Ethernet over [...]

PLANET Ethernet over VDSL series 8 1.3 Key Features The converter provides the following key features:  Complies with IEEE802.3 10BASE-T standard  Complies with IEEE802.3u 100BASE-TX standard  Supports Ethernet over VDSL  Two RJ11 connectors for Et hernet over VDSL port, one for LAN connection and one for voice connection.  Supports [...]

EV-401M / EV-401S User's Manual 9 1.4 Specifications Protocols and Standards IEEE 802.3 (Ethernet)IEEE 802.3u (Fast Ethernet) IEEE 802.3x (flow control)Ethernet over VDSL Maximum Speed Full Duplex: 200Mbps (for 100Base-TX), 20Mbps (for 10Base-T) Half Duplex: 100Mbps (for 100Base-TX), 10Mbps (for 10Base-T) Cabling 10Base-T - 2-pair UTP Cat. 3, [...]

PLANET Ethernet over VDSL series 10 This page intentionally left blank![...]

EV-401M / EV-401S User's Manual 11 2. HARDWARE DESCRIPTION This product series provide 2 RJ-11 ports for voice connection (like telephone) and for network line connection. This product series also provide 4 RJ-45 ports for two different running speed –10Mbps, 100Mbps, in the same converter and automatically distinguish t he speed of incoming[...]

PLANET Ethernet over VDSL series 12 LED indicators SYSTEM LED Steady Green This indicator lights green when the converter is receiving power. PWR Off Not receiving power VDSL LED Steady Green If both ends of the VDSL devices are connected then the LED will blink for a while (in 10 seconds), this is the stage of speed auto-negotiation, after t he ne[...]

EV-401M / EV-401S User's Manual 13 Blinking Amber A collision occurs when tw o stations within a collision domain attempt to transmit data at the same time. Intermittent flashing amber of the collision LED is normal; the contending adapters resolve each collision by means of a wait-then-retransmit algorithm. Frequency of collisions is an indic[...]

PLANET Ethernet over VDSL series 14 Pow er Notice: 1. The device is a power-required device, it means, it will not work till it is powered. If your networks should active all the time, please consider using UPS (Uninterrupted Power Supply) for your devic e. It will prevent you from network data loss or network downtime. 2. In some area, installing [...]

EV-401M / EV-401S User's Manual 15 3. INSTALLING AND USING ETHERNET OVER VDSL CONVERTER 3.1 Install the Ethernet Over VDSL Converter The Converter does not require any software configuration. Users can imm ediately use any feature of this product simply by attached the cables and plug power on. There is some key limitation on the Ethernet over[...]

PLANET Ethernet over VDSL series 16 Therefore, most of the traffic will be limited on the local phone line network instead of flooding to the Internet. Another application for the converter is used for LAN to LAN extension through the normal telephone line. 3.2 LAN to LAN connection Two sets of the converters could be used to link two local Area ne[...]

EV-401M / EV-401S User's Manual 17  W ater or moisture can not enter the unit  Air flow around the unit and through the vents in the side of the case is not restricted (company recommend that you provide a minimum of 25mm inch clearance) T o prolong the operational life of your units:  Do not place objects on top of any unit or stack [...]

PLANET Ethernet over VDSL series 18 This page intentionally left blank![...]

EV-401M / EV-401S User's Manual 19 4. SWITCH OPERATION 4.1 MAC Address Table and Learning The converter built in with a MAC address table that is composed of many entries. Each entry is used to store the address information of network nodes on the network, including MAC address, port ID, etc. The information is the most important base to do pa[...]

PLANET Ethernet over VDSL series 20 This page intentionally left blank![...]

EV-401M / EV-401S User's Manual 21 5. TROUBLE SHOOTING SYMPTOM: VDSL link LED not lit after wire is connected to the VDSL port. CHECKPOINT: 1: Verify the length of the wire connected between EV-401M and EV-401S is not more than 1.5km. 2: Please note you must use 1 EV-401M and 1 EV-401S connect to each other to make it work. SYMPTOM : Switch Li[...]

[...]

EM-EV401V1 ISO9002[...]