Poulan Pro 414944 инструкция обслуживания

OWNER'S MANUAL MODEL NUMBER: PP13TEPH30 SNOW THROWER Always W ear Eye Protection During Operation IMPORT ANT MANU AL Do Not Throw Away WARNING: Read the Owner's Manual and fol low all W arnings and Safety In struc tions. F ail ure to do so can result in serious injury . 414944 Rev . 2 09.26.07 TH Printed in U.S.A.[...]

2 IMPORT ANT Safe Operation Practices for W alk-Behind Snow Throwers This snow thrower is capable of amputating hands and feet and throwing objects. F ailure to observe the following safety instructions could result in serious injury . WARNING: This snow thrower is for use on sidewalks, driveways and other ground level surfaces. Caution should be e[...]

3 MAINTENANCE ..................................................... 14-15 SERVICE AND AD JUST MENTS ........................... 16-18 STORAGE ................................................................... 18 TROU BLE SHOOT ING ................................................ 19 REP AIR P ARTS ...................................................[...]

4 P ARTS P ACKED SEP ARA TEL Y IN CARTON[...]

5 AS SEMBL Y / PRE-OPERA TION Read these instructions and this manual in its entirety before you attempt to assemble or operate your new snow thrower . Reading the entire manual will familiar- ize you with the unit, which will assist you in assembly , operation and maintenance of the product. Y our new snow thrower has been as sem bled at the facto[...]

6 AS SEMBL Y / PRE-OPERA TION INST ALL TRACTION DRIVE CONTROL ROD (See Figs. 3 and 4) The traction drive control rod has the long loop on the end of the spring as shown. 1. Slide rubber sleeve up rod and hook end of spring into pivot bracket with loop opening down as shown. 2. With top end of rod positioned under left side of control panel, push ro[...]

7 AS SEMBL Y / PRE-OPERA TION CHECK TIRE PRESSURE The tires on your snow thrower were overinflated at the fac- tory for shipping purposes. Correct and equal tire pres sure is important for best snow throwing performance. • Reduce tire pressure to 14-17 PSI (19-24.5 N-m). INST ALL CHUTE DEFLECTOR REMOTE CONTROL (See Figs. 8 and 9) 1. Install remot[...]

8 OPERA TION KNOW YOUR SNOW THROWER READ THIS OWNER'S MANUAL AND ALL SAFETY RULES BEFORE OPERA TING YOUR SNOW THROWER. Compare the illustrations with your snow thrower to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. These symbols may appear on your snow thrower or in literat[...]

9 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. FIG. 10 OPERA TION LH and RH turn triggers – used to steer the snow thrower . Drive speed control lever – used to select forward or reverse motion and speed of snow thrower . T raction drive control lever – used to eng[...]

10 TO CONTROL SNOW DISCHARGE (See Fig. 14) WARNING: Snow throwers have ex- posed rotating parts, which can cause severe injury from contact, or from ma- terial thrown from the discharge chute. Keep the area of operation clear of all persons, small children and pets at all times including startup. WARNING: If the discharge chute or au- ger become cl[...]

11 AUGER CONTROL LEVER FIG. 15 OPERA TION POWER STEERING OPERA TION (See Fig. 18) Steering triggers are used to assist in steering your snow throw- er . The triggers are located on the underside of each handle. When a trigger is squeezed, it disengages the drive wheel on that side of snow thrower and allows it to turn in that direction. • T o tur[...]

12 ADD GASOLINE (See Fig. 22) • Fill fuel tank to bottom of tank filler neck. Do not over - fill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Do not mix oil with gasoline. Purchase fuel in quan ti ties that can be used within 30 days to assure fuel freshness. WARNING: Wipe off any spilled oil or fuel. Do not store, sp[...]

13 30 days or longer . Empty the gas tank, start the engine and let it run until the fuel lines and carburetor are empty . Use fresh fuel next sea- son. See Storage In struc tions for ad di tion al information. Never use engine or car bu re tor cleaner products in the fuel tank or per ma nent damage may occur . TO ST ART ENGINE • Be sure fuel shu[...]

14 SNOW THROWER Always observe the safety rules when performing any main te nance. TIRES • Maintain proper air pressure in both tires (14–17 P .S.I. / 19-24.5 N-m). • Keep tires free of gasoline and oil, which can harm rubber . NOTE: T o seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your loca[...]

15 MAINTENANCE V -BEL TS Check V -belts for deterioration and wear after every 50 hours of operation and replace if necessary . The belts are not ad just able. Replace belts if they begin to slip from wear . (See “TO REMOVE BEL T COVER” in the Service and Adjustments section of this manual). The V -belts on your snow thrower are of special con [...]

16 WARNING: T o avoid serious injury , before performing any service or ad just ments: 1. Be sure throttle is in STOP position. 2. Remove safety ignition key . 3. Make sure the augers and all mov ing parts have completely stopped. 4. Disconnect spark plug wire from spark plug and place wire where it can not come in contact with plug. SNOW THROWER T[...]

17 1. REMOVE GASOLINE FROM FUEL T ANK - Drain gasoline from fuel tank into a suitable container , out- doors, away from fire or flame. Wipe up any spilled gasoline. 2. REMOVE DISCHARGE CHUTE - Loosen locknut se cur ing chute rotator head to mounting bracket only enough to allow chute rotator head to be raised and dis charge chute to be removed from[...]

18 STORAGE Immediately prepare your snow thrower for storage at the end of the season or if the unit will not be used for 30 days or more. WARNING: Never store the snow thrower with gaso line in the tank in side a build ing where fumes may reach an open flame, spark or pilot light as on a fur nace, water heater , clothes dryer or gas ap pli ance. A[...]

19 TROUBLESHOOTING Does not start 1. F uel shut-off valve (if so 1. T urn fuel shut-off valve to OPEN position. equipped) in OFF position. 2. Safety ignition key 2. Insert safety ignition key . is not inserted. 3. Out of fuel. 3. Fill fuel tank with fresh, clean gasoline. 4. Throttle in STOP position 4. Move throttle to F AST position (or ON/OFF sw[...]

20 REP AIR P ARTS SNOW THROWER - MODEL PP13TEPH30 (96198000900) AUGER HOUSING / IMPELLER ASSEMBL Y 6 6 5 9 9 12 7 7 8 6 11 57 10 10 13 4 14 16 15 36 37 50 47 42 42 44 27 27 43 43 46 38 45 41 40 39 34 32 49 19 48 51 33 35 30 31 28 19 55 28 19 55 22 18 26 25 20 58 25 26 29 20 24 18 10 24 54 52 53 53 21 54 58 21 52 17 17 56[...]

21 KEY P ART NO . NO. DESCRIPTION 4 191079 Pulley , Impeller 5 188909 Bearing Assembly , Flange 6 155377 Nut, Hex Flange 5/16-18 7 180355 Bolt, Flat Head, Carriage 5/16-18 x 5/8 8 72270505 Bolt, Carriage 5/16-18 9 163183 Bolt, Hex Head 5/16-18 x 5/8 10 404930X428 Housing, Auger 11 404933X479 Bar , Scraper 12 178675X008 Bracket, Corner Discharge 13 [...]

22 REP AIR P ARTS SNOW THROWER - MODEL PP13TEPH30 (96198000900) CONTROL P ANEL / DISCHARGE CHUTE 3 32 32 2 2 1 1 6 19 2 26 34 21 35 33 36 28 27 25 20 29 31 37 30 16 18 17 10 14 3 13 15 9 11 12 7 5 6 8 8 27 22 23 4 22 23[...]

23 REP AIR P ARTS SNOW THROWER - MODEL PP13TEPH30 (96198000900) CONTROL P ANEL / DISCHARGE CHUTE KEY P ART NO . NO. DESCRIPTION 1 414280 Knob, Lever , Black 2 17501010 Screw #10-24 x 5/8 3 198475 Control Assembly , Deflector 4 73800600 Nut, Lock 3/8-16 5 19131316 Washer , Flat 3/8 6 404974 Control Assembly , Chute Rotater 7 405784X479 Support, Pivo[...]

24 REP AIR P ARTS SNOW THROWER - MODEL PP13TEPH30 (96198000900) HANDLES 34 37 12 11 15 11 15 42 10 15 23 22 27 27 22 15 16 17 16 17 14 32 31 32 30 31 38 39 7 6 36 2 5 5 5 1 8 28 28 9 18 19 26 47 24 25 5 5 40 29 11 13[...]

25 KEY P ART NO . NO. DESCRIPTION 1 412682X479 Lever , Auger Control, RH 2 412681X479 Lever , T raction Drive Control, LH 5 169675 Retainer , Hairpin 6 17060408 Screw , Hex Head 1/4-20 x 3/4 7 412677 Rod, Interlock 8 196333X008 Arm, Impeller Rod 9 412679X008 Arm, T raction Rod 10 412683X479 P anel, Control 11 74780524 Screw , Hex Head 5/16-18 x 1-1[...]

26 REP AIR P ARTS SNOW THROWER - MODEL PP13TEPH30 (96198000900) DRIVE 11 8 3 3 4 23 1 1 5 5 2 2 7 9 10 6 14 12 18 19 20 13 13 13 13 15 16 22 21[...]

27 KEY P ART NO . NO. DESCRIPTION 1 17490508 Screw 1/4-20 x 1/2 2 187794 Spacer , Axle 3 174697 Washer , Thrust 4 74780632 Screw , Cap, Hex Head 3/8-16 x 2 5 179830 Bearing, Axle 6 73930600 Nut, Hex, Centerlock 3/8-16 7 187776 T ransmission Assembly 8 187787 Speed Control Arm, Hydro 9 700279 Retainer Clip 10 188101 T orque Strap 11 193255X479 Brack[...]

28 REP AIR P ARTS SNOW THROWER - MODEL PP13TEPH30 (96198000900) CHAS SIS / ENGINE / PULLEYS 30 29 31 31 44 49 50 51 52 5 44 45 58 6 19 17 10 21 22 23 2 1 4 6 42 8 9 12 13 15 27 26 25 24 18 7 20 14 10 21 28 57 6 3 35 34 46 11 47 16 53[...]

29 REP AIR P ARTS SNOW THROWER - MODEL PP13TEPH30 (96198000900) CHAS SIS / ENGINE / PULLEYS KEY P ART NO . NO. DESCRIPTION 1 192873 Spring, Traction Idler 2 180522 Pulley, Idler (2-1/4) 3 - - - Engine, Tecumseh, Model Number OH358SA (For engine service and replacement parts, call Tecumseh Products at 1-800-558-5402) 4 74780520 Screw, Hex Head 5/16-[...]

30 REP AIR P ARTS SNOW THROWER - MODEL PP13TEPH30 (96198000900) WHEELS / DECALS 31 2 7 8 4 3 4 4 4 10 32 30 32 30 15 18 17 19 13 20 11 21 33 22 23 24 25 26 28 27 28 27 26 25 24 23 22 33 19 21 16 20 11 14 10 10 9 7 5 6 5 6 1 2 3 15 12 13 18 14 10 12 1 2 3 4 5 6 1 9 10 8 7[...]

31 REP AIR P ARTS SNOW THROWER - MODEL PP13TEPH30 (96198000900) WHEELS / DECALS KEY P ART NO . NO. DESCRIPTION 1 196752X421 Wheel Assembly , 16", with Power Steering, LH 2 155443 Pin, Klik 1/4 3 405161 Cover , Power Steering 4 184471 Screw , Shoulder , Hex Head #10-24 x 1/2 7 17000616 Screw , Hex Head 3/8-16 x 1 8 185603X479 Bracket, Steering [...]

LIMITED W ARRANTY The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materials and work man ship. For a period of two (2) years from date of purchase by the original consumer pur - chaser , we will repair or replace, at our option, without charge for parts or labor incurred in repl[...]