Poulan Pro 530087857 инструкция обслуживания

1950 / 2025 / 2050 / 2075 2150 / 2175 / 2350 / 2375 Operator’s Manual Manual del Operador Manuel de L’utilisateur WAR NI NG : Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so c an result in serious injury. ADVERT ENCI A : Lea el manual del operador y siga todas las advertencias e enstruc- c[...]

2 SAFETY RULES WAR NI N G: Always disconne ct spark plug wire and p lace wire where it cannot contact spark plug to prevent accidental starting when setting up, transporting, ad- justing or making repa irs except c arburetor adjustments. Because a chain saw is a high-speed wood - cutting tool, special safety precautions must be observed to reduce t[...]

3 open flames, or work that could cause sparks. Allow engine to cool bef ore re- fueling. S Mix and pour fuel in an outdoor area on bare ground ; store fuel in a cool, d ry , well vent ilated place; and use an ap - proved, marked container for all fuel purposes. Wipe up all fuel spills before starting saw. S Move at le ast 10 fee t (3 meters) fro m[...]

4 MAINT AIN CONTROL Never reverse ha nd positions Stand t o the left of the saw Thumb on unde rside of handlebar Elbow locked S Keep a good, firm grip on the sa w with both hands when the engine is running and don’t let go. A firm grip will help you reduce k ickback and maintain control of the saw . Keep the fingers of your left hand encircling a[...]

5 SAFETY NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people p rone to circulation d isorders or abnormal swe llings. Prolonged use in cold weather has been linked to blood vessel damage in otherwis e healthy people. If symptoms occu[...]

6 S Replace the bar clamp nuts and tighten finger tight. Once the chain is ten- sioned you will need to tighten bar clamp nuts. Mount the Bar Proper cha in direction Tip of Bar Place chain onto the sprocket CHAIN TENSION (Including units with chain already installed) NOTE : When adjusting chain tension, make sure the bar nuts are finger tight only.[...]

7 ST ARTING WAR NI N G: The chain must not move when the engine runs at idle speed. If the chain m oves at idle speed refer to CARBURE - TOR ADJUSTMENT within this manual. Avoid contact w ith t he muffler. A hot muff ler can cause serious burns. To s t o p t h e e n g i n e m ove the switch to the STOP or OFF position. To s t a r t t h e e n g i n [...]

8 S Allow the chain to cut for you. Ex - ert only light downward pressure. If you force the cut, damage to the bar , chain, or engine can result. S Release the throttle trigger as soon as the cut is completed, al- lowing the engine to idle. If you run the saw at full throttle w ithout a cutting load, unne cessary wear can occur to t he chain, bar ,[...]

9 S Be alert to signs that the tree is ready to fall: cracki ng sounds, widening of the felling cut, or movement in the upper branch es. S As tree starts to fall, stop saw , put it down, and get away quickly on your planned retreat path. S Be extrem ely cautious with partially fall- en trees that may be poorly supported. When a tree doe sn’t fall[...]

10 1 st Cut 2 nd Cut Using a support stand 1 st Cut 2 nd Cut Using a support stand REMOVING A PINCHED SAW (A SAW HUNG IN THE L OG) S If saw becomes pinched or hung in a log, don’t try to force it out. Y ou can lose control of the saw resulting in pe rsonal injury an d/or da mage to the saw . Stop the saw and drive plastic or wooden wedge into the[...]

11 SERVICE We recommend all service and adjustments not listed i n this manual b e performed by an authoriz ed or Master Service Dealer . MAINTENANCE SCHEDULE Check: Fuel Mixtur e Level Before ea ch use .. Bar Lubricatio n Before each use .... Chain T ension Before each use ..... Chain Sharpness Before each use .. For damaged parts Befo re e ach us[...]

12 TROUBLESHOOTING Engine will not start. S Ignition switch off. S Engine flooded. S Fuel ta nk empty. S Spark plug n ot firing . S Fuel no t reaching carbu retor . Engine will not idle properly. S Air filter dirty . S Spark plug foule d. S Carburetor re quires ad justment. Engine will not accelerate, lack s power , or dies under a load. Engine smo[...]

13 POULAN/WEED EATER . OWNER’S WAR- RANTY RESPONSIBILITIES: As the lawn and garden equipment engine owner, you are responsible for the pe rformance of the required maintenance listed in your Own- er’s Manual. POULAN/WEED EATER rec- ommends that you retain all receipts cover- ing mainte nance o n your lawn and garden equipment engine, but P OULA[...]