PYLE Audio PLCD12MRKT инструкция обслуживания

OWNER’S MANUAL Mobile Audio System • PLL Synthesizer Ster eo Radio • Digital Compact Disc Player • Automatically Memory Storing • Full Detachable Panel • Pr ogram CD T racks • CD Changer Contr ol • Auxiliary Input Function PLCD12MRKT www .pyleaudio.com[...]

2 Installation ..................................................................................................... 3 DIN Front-Mount.................................................................................................... 3 Installing the unit .............................................................................................[...]

3 Notes: • The unit can be installed on the vehicle or the ships. • Choose the mounting location wher e the unit will not interfere with the normal driving function of the driver . • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly . • [...]

1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Screw (5x25mm) 5. Screw 6. Strap Be sure to use the strap to secur e the back of the unit in place. The strap can be bent by hand to the desired angle. 7. Plain washer Removing the unit 1. Before r emoving the unit, pr ess the OPEN button to slide down the front panel. 2. Lever Insert the levers supplie[...]

T o Detach the Front Panel 1. Press the OPEN button, the fr ont panel will slide down. 2. When the front panel slides down, press the bottom button of the fr ont panel upward and pull it out fr om the panel bracket. 3. For safekeeping, store the fr ont panel in the supplied protective case immediately after being removed. T o Reinstall the Front Pa[...]

6 WIRING CONNECTION GREEN GREEN/BLACK GREY GREY/BLACK VIOLET VIOLET/BLACK MAIN UNIT WHITE WHITE/BLACK FRONT Lch SPEAKER REAR Lch SPEAKER FRONT Rch SPEAKER REAR Rch SPEAKER Rch RED Lch WHITE (GREY) RCA CABLE ANTENNA SOCKET RED YELLOW BLACK BLUE POWER ANTENNA GROUND (B–) MEMORY BACK-UP IGNITION SWITCH (B+) CD CHANGER CONNECTOR SOCKET Rch RED Lch WH[...]

OPERA TION 7 CONTROL & FUNCTIONS KEYS This unit is a marine rated wired r emote contr ol made using a modified contr oller or similar layout. It is capable of operation specified functions on the marine AM/FM/CD receiver . The body , buttons, controls and display need to be UV and water -resistant. It includes and LCD and an illumination circui[...]

OPERA TION 8 4 MODE SELECTION button Press the MODE button (4) to step sequentially thr ough the following sour ces: e.g. radio mode to CD mode to CDC mode to AUX in mode. 5 BAND SELECTION button Press the BAND button (5) to step sequentially thr ough the following bands: FM1, FM2, FM3, AM1(MW1), AM2(MW2), L W . 6 TRACK/SEARCH/TUNE buttons • ST A[...]

INST ALLA TION 9 3. Align the screw holes on the holder with the screw holes on the base and the screw holes on the bracket, then use the two screws (ø4X50) and nuts to fix the bracket, the base and holder to the proper location. 4. Last install the remote contr ol to the holder . See below , align the four hooks on the holder with the four slots [...]

10 GENERAL OPERA TION • ON/OFF Switch on the unit by pressing PWR button (9). When system is on, press PWR button (9) again to turn off the unit. Press PWR button (9) for mor e than 2 seconds, the button is operated to initial volume control button. When system power turns on, the volume is set to initial volume level. • F ACEPLA TE RELEASE Pre[...]

11 display . If you select beep sound on, whenever press any button, beep sound output. • LOUDNESS Press LOUD (DIM) button (15) shortly to reinfor ce the bass output and display will show “LOUD”. Press it again to release this function. • ILLUMINA TION Press LOUD (DIM) button (15) for mor e than 2 seconds to adjust the brightness of the LCD[...]

RADIO OPERA TION • BAND SELECTION At tuner mode, press BAND button (18) shortly to select the desired band. The reception band will change in the following order: • ST A TION SELECTION Press button (16) or button (17) shortly to activate automatic seek function. Press for mor e than 3 seconds until “ MAN ” appeared on the display , the manu[...]

CD OPERA TION • SELECT TRACKS Press button (16) or button (17) to move to the previous track or the following track. T rack number shows on display . Hold press button (16) or button (17) to fast reverse or fast forwar d. Disc play starts from when you r elease the button. • P AUSE PLA YING Press /MUTE button (3) to pause CD player . Press it a[...]

14 CD CHANGER OPERA TION • SELECT TRACKS Press button (16) or button (17) to move to the previous track or the following track. T rack number shows on display . Hold press button (16) or button (17) to fast reverse or fast forwar d. Disc play starts from when you r elease the button. • P AUSE PLA YING Press /MUTE button (3) to pause CDC player [...]

15 SPECIFICATION GENERAL P ower Supply Requirements : DC 12 V olts, Negative Ground Chassis Dimensions : 178 (W) x 178 (D) x 50 (H) mm Tone Controls - Bass (at 100 Hz) : ± 10 dB - T reble (at 10 KHz) : ± 10 dB Maximum Output P ow er : 4 x 50 W atts Current Drain : 15 Ampere (max.) CD PLA YER Signal to Noise Ratio : More than 55 dB Channel Separat[...]

TROUBLE SHOOTING Before going thr ough the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer . Symptom Cause Solution No power . The car ignition switch is If the power supply is properly not on. connected to the car accessory circuits, but the engine is not movin[...]