PYLE Audio PLCD27 инструкция обслуживания

Car Audio Hifi System WNER'S MANU AL CD PL A YER R PLCD27[...]

1 Band Band tuner Direct access tuning Radio wiring Speaker wiring Install the unit Removing the unit Power V olume play/pause eject clock loud release V olume setting bass setting treble settting balance setting fader setting To p scan repeat random stop[...]

2 T o prev ent injur y of fire,take the follo wing pr ecautions: T o prev ent dama ge to the machine, tak e the following precautions: Insert the unit unitll it is firmly locked to the main unit, otherwise it may fall out of place when jolted When extending the ignition, memory back up or ground cable, use diameter of 0.75mm(AWG18) or more automoti[...]

Powe r T ur ning ON the power Press the [PWR]button. If a disc has already been loaded, CDIN would be shown on the display , press this button to start play disc even though the unit is in Radio mode. When disc is playing, press this button to pause the disc, press again to resume the normal play . V olume Play/pause Press to turn on the unit power[...]

Eject In beam mode, press the BD button can enter radio mode. If the disc in the slot, press the EJECT button to eject the disc form the slot and automatically be switched to the radio mode. In radio mode, if push a disc into slot, the disc will automatic insert and begins to play . If the disc in the solt, press PLA Y/P AUSE button to play the dis[...]

T r eble set mode Press SEL button third, display shows TRE ,then rotate the volume + button to adjust treble level up. Rotate the volume - buttonto adjust treble level down. Press SEL button fourth display shows BAL ,then rotate the volume + button to adjust left speaks level . Rotate the volume - button to adjust right speaks level . Balance set [...]

6 To p R epeat Random Scan Select the first track directly In CD mode,press this button, the first track will play . Press [TOP]button Press the button once to repeat the same track continuously , Press the button twice to repeat the disc continuously , RPT will appear on the LCD display . Press [RPT]button Press this button to play all the track i[...]

Band T une Press BAND button to select among three FM or two AM bands. (FM1-FM2-FM3-AM1-AM2) Selecting band the long press button it can automatically select frequency station. And the long press it can automatically select lower frequency station. higher In radio mode: manual tuning: short press button it can select higher frequency station. Short[...]

APS MONO LOUD CLK STOP TO P RPT SCAN RDM Basic operation Pull out Loading and replacing the batter y Use one lithium battery(CR2025) insert the batteries with the +and - poles aligned properly . Following the illustration inside the case. Store unused batteries out of the reach of children. Contact a doctor immediately if the battery is accidentall[...]

Exter nal view ........ Number of items Exter nal view ........ Number of items The use of any accessories except of those provided might result in damage to the unit .make sure only to use the accessories shipped with the unit ,as shown above. 9 1 2 3 5 6 ............ 1 ............ 1 ............ 1 ............ 1 ............ 1 ............ 1 7 .[...]

Follow this easy wiring diagram in order to enable you to install the new or existing RADIO and SPEAKER wring system. Be sure the unit is connected to a 12 volts battery with negative ground. Good ground connections eliminate most electrical noise problem and require tight with the metal vehicle chassis. remove plastic, paint or dust for good elect[...]

11 B efore installing the receiver permanently , fit it in the approximate place in your car Connect the equipment according to the speakers and electrical connections. When your system is operated properly ,(preferably with the car engine running), follow the instructions for permanent installation of your system. 1) Adapter (not supplied) 2)Bend [...]

Signal/Noise radio......................................................70dB Frequency response..............................20Hz-20KHz(+3dB) Channel separation..................................................>45dB Dual D/A converter .......................................................16Bit T uning range......................................[...]

W hat might seem to be a malfunction in y our unit may just be the result of slight misoperation or miswiring. Before calling ser vice, fir st chec k the following table for possible problems. ?The power does not tur n ON. The fuse has blown. Install half sleeve, can be with or ?NO Sound. The cable connect incorrectness. Exactitude connect of the c[...]

CD PLAYER Car Audio Hifi System[...]