Pyramid Car Audio CDR40DX инструкция обслуживания

OWNER’S MANUAL MANUALL Y TUNED STEREO RADIO WITH COMP ACT DISC PLA YER TON E COMPACT DISC P L AYER REP R L IN T MODE BAL VO L ST LO C FM AM LOC BND RND EJEC T PWR UP TU NE DN REL CDR40DX www .pyramidcaraudio.com[...]

2 CONTENTS Installation ..................................................................................................... 3 DIN Front-Mount (Method A) .................................................................................. 3 Installing the unit ..........................................................................................[...]

3 INST ALLA TION Notes: • Choose the mounting location where the unit will not interfer e with the normal driving function of the driver . • Before finally installing the unit, connect the wiring temporarily and make sur e it is all connected up properly and the unit and the system work pr operly . • Use only the parts included with the unit [...]

4 1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Scr ew (5 x 25mm) 5. Screw 6. Strap Be sure to use the strap to secur e the back of the unit in place. The strap can be bent by hand to the desired angle. 7. Plain washer Removing the unit 1. Frame 2. Insert fingers into the gr oove in the front of frame and pull out to remove the frame. (When reattac[...]

HOW TO REMOVE AND INST ALL THE FRONT P ANEL 1. Pr ess the release button and pull-of f the front panel. Keep the front panel into the case. 2. T o install the fr ont panel, insert the panel into the housing and make sure the panel is properly installed, otherwise, abnormalities occurs on the display or some keys will not function properly . REMOVIN[...]

6 WIRING CONNECTION GREY GREY/BLACK MAIN UNIT WHITE WHITE/BLACK LEFT SPEAKER RIGHT SPEAKER Rch RED Lch WHITE (FOR RCA LINE OUT VERSION ONL Y) (GREY) RCA CABLE ANTENNA CONNECTOR RED YELLOW BLACK BLUE POWER ANTENNA GROUND (B – ) MEMORY BACK-UP IGNITION SWITCH (B+) (FOR POWER ANT . VERSION ONL Y)[...]

OPERA TION 7 GENERAL OPERA TION ON/OFF Press PWR button (1) to turn on the unit. Press it again to turn it off. BALANCE Slide BAL button (2) to left or right to adjust sound balance between left and right speakers. VOLUME Slide VOL button (3) to left or right to adjust volume level. TONE CONTROL Slide TONE button (4) to left or right to obtain the [...]

8 RESET BUTTON RESET button (17) is placed on the housing and must be activated with either a ballpoint pen or thin metal object. The RESET button (17) is to be activated for the following reasons: • Initial installation of the unit when all wiring is completed. • All the function buttons do not operate. • Error symbol on the display . F ACEP[...]

9 CD OPERA TION DISC PLA Y Gently insert a compact disc with the label side facing up into the disc slot (13). The disc is then automatically loaded into the unit and starts playing with the first track of the disc. The digital display will indicate the track number and the time of the track. EJECT Press (eject) button (12) to stop CD play and ejec[...]

10 GENERAL P o wer Supply Requirements : DC 12 V olts, Negative Ground Chassis Dimensions : 178 (W) x 163 (D) x 50 (H) mm Tone Controls - Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) : ± 10 dB Maximum Output P ower : 7W x 2 (ch) Current Drain : 3 Ampere CD PLAYER Signal to Noise Ratio : More than 60 dB Channel Separation : More than 60 dB F re[...]

11 TROUBLE SHOOTING Before going thr ough the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer . Symptom Cause Solution No power . The car ignition switch is If the power supply is properly not on. connected to the car accessory circuits, but the engine is not mo[...]

88-C3191-11[...]