Razor 300001-SL инструкция обслуживания

OW NE RS M AN UA L Read and understand this e ntire manual before riding! Electric-P ower ed Go Kart Item Number 300001-SL ®[...]

NOTE: This manual contains many “Warnings” and “Cautions” concerning the consequences of failing to maintain, inspect or properly use your Ground Force. Because any incident can result in serious injury or even death, we do not repeat the warning of possible serious injury or death each time such a warning is mentioned. AN IMPORT ANT MESSAG[...]

• Always check and obey any loacl laws or regulations which may affect the locations where the Ground Force may be used on public property . The Ground Force is meant to be used only in controlled environments free of potential traffic hazards, and not on public streets or side - walks. Do not try to ride your Ground Force on public streets or i[...]

NOTE: Do not activate the speed control on the setting wheel unless you are in a safe, outdoor environment. Use this product only in areas free of potential traffic hazards and not on public streets or sidewalks. W ARNING: REGARDING USE OF NON-RAZOR PRODUCTS WITH YOUR RAZOR GROUND FORCE. The Ground Force has been built to certain Razor design spec[...]

W ARNING: Failing to properly adjust and tighten the screws, nuts and bolts that affix the steering wheel and seat can cause you to lose control and c rash. TOOLS REQUIRED FOR ASSEMBL Y • 5 mm hex key wrenches • 10 mm box wrench (spanner) • Razor recommends assembly by an adult with experience in mechanics Some tools may be supplied, however[...]

T ighten securely . Position the tie-rod control arm onto the steering axle as shown in Figure 3a and install the washers and fixing bolt. Using a 10 mm wrench, tighten securely . T ighten the tie-rod control arm using a 5 mm hex key wrench. Figure 3a Figure 3b W ARNING: Failure to use the washer and lock washer or failure to properly tighten the [...]

❏ 2 D. Optional attaching the seat with seat belt assembly . Locate the four (4) long seat attachment screw and seat-belt assembly in the parts bag. Position the seat over the frame and align it with the holes in the frame. Position the seat-belt anchors with the lap/shoulder assem- bly on the left side and the receiver latch on right side. Inser[...]

Figure 6a Figure 6b W ARNING: Practice in an open area free from obstacles until you are famil- iar with the brake function. A void skidding to a stop as this can cause you to lose control as well as cause damage in the rear tires. ❏ 2 F . Charging the battery prior to use. Y our Ground Force may not have a fully charged battery at the time of pu[...]

❏ 2 G. Circuit breaker . The circuit breaker (next to charger input port in Figure 7a) will automatically shut off the power to the motor in the event an overload condition is placed on the motor . An excessive overload, such as too heavy a driver or too steep a hill, could cause the motor to overheat. If the Ground Force suddenly stops running, [...]

❏ 4 A. ADJUSTING THE BEL T . The circuit breaker (next to charger input port in Figure 7a) will automatically shut off the power to the motor in the event an overload condition is placed on the motor . An excessive overload, such as too heavy a driver or to NOTE: T urn power switch off before maintenance procedures. If the drive system makes loud[...]

❏ 4 B. WHEEL REMOV AL PROCEDURE. Occasionally the wheels need to be replaced when worn out. The front and rear wheels are iden- tical and can be interchanged. The only difference is how the wheels at- tach. The rear wheels are keyed to the rear axle, while the front wheels have bearings (608ZZ = standard skateboard bearings). 4B -1 .) T o remove [...]

4B-3.) T o replace a rear wheel, make sure the keys are properly seated in the axle and aligned with the key ways in the wheel (Figure 11). T ighten the self-locking nut securely . NOTE: The razor logo on the tread must face out. ❏ 4 C. REPLACING THE BEL T . Occasionally the belt needs to be replaced when worn out. T ools required for rear wheel [...]

Figure 12a Figure 12b 4C-4.) Remove the brake guard and, using the small Allen key , loosen setscrew to release the brake drum. This may or may not require the loosening of the brake cable to gain access to the fixing screw . Loosen the drive pulley in the same manner . Slide the brake drum toward the drive pulley . 4 C-5.) Lightly tap the end of [...]

5. SAFETY THE FOLLOWING RECOMMENDA TIONS ARE EXPECTED FROM: ASTM F1928-98, “ST ANDARD SAFETY GUIDE FOR CONSUMER RECREA TIONAL Y USE OF FUN-CARTS” Go kart shall not be operated with any modifications to the kart or it’ s components. Go karts shall not be operated to perform racing, stunt riding, jumps, spin-outs, donuts or other maneuvers whi[...]

6. ADDITIONAL RAZOR SAFETY WARN INGS W ARNING: Maintain a hold on the steering wheel at all times. W ARNING : Never use near steps or swimming pools. W ARNING : T raffic can be fatal. Do not drive on streets or around cars. W ARNING: Keep your fingers, long hair and other body parts away from the drive system, rotating wheels, and all other movin[...]

7. ILLUSTRA TED P ARTS BREAKDOWN See Figure 14 (Specifications and parts list subject to change without notice) ITEM# DESCRIPTION QUANTITY 1 Wheel 2 Pindle, right 3 Bearing, 608ZZ 8x22 4 T ie-rod 5 Bushing, lower steering 6 Control arm, tie-rod 7 Protector , flexible steering, right 8 Pindle, left 9 Nut, nylock self locking & washer 10 T rigg[...]

ILLUSTRA TED P AR TS BREAKDOWN Figure 14[...]

8. RAZOR LIMITED WARRANTY & REGISTRA TION The manufacturer warranties this product to be free of manufactur - ing defects for a period of 90 days from date of purchase. This Limited Warranty does not cover normal wear and tear , crash damage, tire tread wear , cables, nor any damage, failure or loss caused by improper assem - bly , maintenance,[...]

SB 1918 (CALIFORNIA) DECLARA TION: YOUR INSURANCE POLICIES MA Y NOT PROVIDE COVERAGE FOR ACCIDENTS INVOL VING THE USE OF THIS SCOOTER/ELECTRIC VEHICLE. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONT ACT YOUR INSURANCE COMP ANY OR AGENT .[...]

IMPORT ANT! If your Razor has a problem call Razor USA toll free (866) 467-2967 QUESTIONS: Please read the owner’ s manual thoroughly . If you still have questions, check our website for updates and contact information. Spare tires and batteries are available! Keep your Razor Ground Force running for years with these and other genuine Razor parts[...]