Roberts Radio CR9935 инструкция обслуживания

CR9935 PLL RDS Dual Alarm Clock Radio Please read this manual before use ROBER TS Sound for Generations[...]

Important Information ......................................................... 1 Automatic plug and play setup .......................................... 2 Controls ........................................................................... 3-4 Display ............................................................................... 5 Mains Operatio[...]

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) Automatic Plug and Play setup When your Clock Radio is first connected to the mains supply or after a power failure (when backup battery is not installed), the Auto setup will proceed as follows:- • Automatically search all wavebands and store station[...]

3 Controls 1. Preset buttons 2. Display button 3. Sleep button 4. On/Off button (Top) 1 9. Snooze/Night Light button 10. Weekend cancel/Traffic button 11. Memory button 12. Alarm 2 button 5. Radio text button 6. Time button 7. Program type button 8. Light button 13. Alarm 1 button 14. Band button 15. Tuning up button 16. Tuning down button 2 3 4 56[...]

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 4 Controls (Left side) 17. Headphone socket 18. Volume control 17 18 (Right side)[...]

5 1. Waveband indicators 2. Auto time indicator 3. Traffic information indicator 4. Enhanced other networks indicator 5. RDS indicator 6. Memory indicator 7. Frequency, time and text display area 8. Weekend cancel indicator 9. Sleep time indicator 10. Radio text indicator 11. Programme type indicator 12. Alarm 2 indicators 13. Alarm 1 indicators 6 [...]

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 6 Mains operation 1. Place your radio on a flat surface. 2. Plug the mains plug into a wall socket and switch on the wall socket. Display backlight The display back light will be switched on for 10 seconds whenever any button is pressed. The display bac[...]

7 Setting the clock automatically The clock time and day of week can be set automatically when receiving an RDS station that transmits clock time (CT). The CT information is transmitted once every minute. If the station has sufficient signal strength the clock will set within one or two minutes. 1. Switch on the radio with the On/Off button . 2. Se[...]

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) Setting the clock manually 1. Ensure that the radio is switched off. 2. Repeatedly press the Time button until the auto time symbol is removed from the display. 3. Press and hold down the Time button . 4. Whilst the Time button is held down set the time[...]

Setting the alarm times 1. Press and hold down the Alarm 1 or Alarm 2 buttons . 2. Whilst the Alarm 1 or Alarm 2 button is held down set the alarm time by pressing the Up or Down buttons . The clock uses the 24 hour system e.g. 2:30pm is shown as 14:30. At this stage disregard symbols. 3. Release the Alarm button when alarm setting is complete. Dis[...]

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) Snooze control 1. The radio or buzzer alarm can be silenced for 5 minutes by pressing the Snooze button . This sequence can be repeated during the 90 minutes alarm period. Sleep timer Your clock radio can be set to switch off after a preset time has ela[...]

Operating your radio - search tuning 1. Switch on your clock radio by pressing the On/Off button. 2. Select the required waveband by pressing the Band button . The waveband selected will appear in the display. On FM fully extend the pigtail aerial from the rear of your clock radio. On MW rotate your radio for best reception. 3. Press and hold down [...]

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) Operating your radio - manual tuning 1. Switch on your radio by pressing the On/Off button . 2. Select the required waveband by pressing the Band button . The waveband selected will appear in the display. On FM fully extend the pigtail aerial from the r[...]

13 Pre-setting stations You may store up to 10 different stations on each of the two wavebands giving a total of 20 preset stations. 1. Switch on your radio using the On/Off button . 2. Select the desired waveband using the Band button . 3. Tune into the required station using one of the tuning methods previously described. 4. Press and release the[...]

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) Recalling a preset station 1. Switch on your radio using the On/Off button . 2. Select the desired waveband using the Band button. 3. Press one of the Preset buttons to recall the station. Presets 6 to 10 are obtained by pressing the Preset button twice[...]

15 Radio Data System ( RDS ) The R adio D ata S ystem ( RDS ) is a system in which inaudible digital information is transmitted in addition to the normal FM radio programme. RDS offers several useful features, the following are available on your radio:- Programme Identification (PI) This information consists of a code, which is assigned to each ind[...]

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) Operating your radio using RDS (Radio data system) 1. Switch on your radio and select the FM waveband. 2. Tune into a station, the display will indicate frequency for two seconds and then change to show the station name. The symbol will appear in the di[...]

17 Radio Text (RT) The RDS system provides a text message of up to 64 characters in length. It is displayed by scrolling the characters of the message from right to left. 1. Switch on your radio and select the FM waveband. Tune into a station carrying RDS information. 2. Press the Text button , the Radio Text symbol will appear in the display. 3. I[...]

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) Programme Type search (PTY) 1. To search for a station of a particular type, repeatedly press and release the PTY button until the required programme type is shown in the display. Press and release either the Up or Down buttons . 2. Your radio will now [...]

19 5. If the station carries Enhanced Other Network information the EON symbol will appear in the display. The radio will automatically tune to other stations transmitting traffic information. When the traffic announcement has finished the radio will re-tune to the previously selected station. e.g. If the radio is tuned to a national station such a[...]

Demonstration mode Your radio is equipped with a demonstration mode which when active highlights the main features available on your clock radio. 1. Press and hold down the Display button until the display enters Demonstration mode. 2. Press any key to cancel demonstration mode. Headphones 1. A Headphone Socket (3.5mm) located on the left hand side[...]

21 Fuse This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug (BS1363). If another type of plug is used a 5A fuse should be fitted in the plug, adaptor or distribution board. IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN. Back-up battery (not necessary for the unit to function) Slide the battery cover catch in the direction of the ar[...]

Specifications Power Requirements Mains AC 230 volts, 50Hz only Batteries 2 x LR6 (AA size) for clock/memory Frequency Coverage F M 87.5-108MHz M W 522- 1620kHz Circuit Features Loudspeaker 77mm 8ohms Output Power 500mW into 8ohms Headphone socket 3.5mm dia Aerial System F M Wire aerial M W Built-in Ferrite aerial The Company reserves the right to [...]

ROBERTS RADIO TECHNICAL SERVICES DEPARTMENT 97-99 Worton Road Isleworth Middlesex TW7 6EG Technical Helpline:- 020 8758 0338 (Mon-Fri) Issue 1 Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated bel[...]