Russound SP650 инструкция обслуживания

A/V DISTRIBUTION & CONTROL SYSTEMS Instruction Manual SP550.2 SP650.1[...]

Congratulations on selecting Russound W all-Mounted Speakers. Like all RUSSOUND speakers, they combine acoustic technology with dur ability and will provide years of musical enjoyment. T his manual is designed to make your SP550.2 & SP650.1 speakers as easy to install as they are to listen to. If you’ ve had any home “do-it-y ourself” exp[...]

3 Where T o Place Y our SPEAKERS Placement can make all the difference in how your RUSSOUND speaker system sounds. T here are at least three “WHERE’ s” and a “HOW” to factor into y our lay out: • HOW y ou intend to use your in-w all speakers • WHERE they’ll sound best (stereo imaging and acoustic considerations) • WHERE it’ s po[...]

O THER A COUSTIC CONSIDERA TIONS F or best fidelity , there are sever al other factors to keep in mind before you start actual installation. Concerns and reflections When an in-wall speaker is placed close to the corner of a room, bass frequencies are emphasized. T his can be okay if both speakers are mounted near corners (while maintaining stereo [...]

• Make sure that the entire path between speakers and amplifier is clear and not obstructed by a floor or ceiling joist or masonry wall w hich y ou won ’ t be able to drill through. • Remember that the other end of the wires has to come out somewhere to connect with the amplifier . Confirm ahead of time that you can drill an outlet hole easil[...]

1. Determine the location of your w all studs so that the speaker can be approximately centered between them. T here are several w a ys to go about this: * T ap on the w all and listen to the resulting “ THUMP ” . When it ’ s deeper , you ’ re between studs. When it ’ s sharper and more flat-sounding, you ’ re close to a stud. * Use a s[...]

2. A painted stripe or dotted line • Denote any of these as the POSITIVE (+) conductor for similar connections on both ends. NO TE: It is important that you label y our wires left and right when y ou run them to eliminate future confusion. A T THE SPEAKER END 1. Cut off excess wire, lea ving about 2 feet extending through the speaker cut-out hole[...]

FIN AL ASSEMBL Y 1. If you ha ven ’ t done so already during painting, remov e the perforated grilles from both Russound In-W all Speakers. Use the clamp (dog-ear) to push the grille out from the back side. 2. Center the speaker in the cut-out hole and tighten the screws until the clamps are drawn up snugly from behind, clamping the speaker in pl[...]

4. Defectiv e speaker - contact your Russound dealer or call our customer tech department at 603.659.5170. • Any other pr oblems not listed, discuss with your dealer or call Russound. T AKING C ARE OF Y OUR NEW IN-W ALL SPEAKERS RUSSOUND In-W all Speakers are designed to last the life of your home if you follow a few simple rules. T he main “ k[...]

If your other speakers are rated at 4-ohms, some amplifiers ma y experience difficulty driving both 4-ohm sets at once and shut off intermittently when the v olume control is turned up. In this case, you should operate only one set of speakers at a time or keep the volume extremely low . Another option is to purchase a speaker selector suc h as the[...]

RUSSOUND Speakers Fi ve Y ear Limited W arr anty All Russound Speaker products are fully guaranteed against all defects in materials and w orkmanship for five y ears from date of purchase. Proof of Receipt must accompany all claims. During the w arranty period Russound will replace any defecti ve part and correct any defect in workmanship without c[...]

A/V DISTRIBUTION & CONTROL SYSTEMS 5 F orbes Rd., Newmark et, NH 03857[...]