Samson PB9 инструкция обслуживания

® O WNERS MANU AL 1.5 3.0 4.5 6.0 7.5 9.0 10.5 12.0 13.5 15.0 85 95 105 110 115 117 120 124 127 130 LIGHT OUTLETS UNSWITCHED 15 AMPERES SAMSON PowerBrite Pro7 AMMETER VOLTMETER PUSH PUSH SAMSON OUTLETS UNSWITCHED 15 AMP SAMSON 15 A M P POWER DISTRIBUTION SYSTEM WITH AC LINE NOISE AND SURGE SUPPRESSION PowerStrip PS9 PBPRO7 PS9 Power B B r r i i t [...]

Produced by On The Right Wavelength for Samson Technologies Corp. Copyright 1997, 1998, Samson Technologies Corp. Printed March, 1998 Samson Technologies Corp. 575 Underhill Blvd. P.O. Box 9031 Syosset, NY 11791-9031 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 516-364-3888 T able of Contents Introduction 3 System Features 4 Guided Tour - PS9 Front [...]

Intr oduction Congratulations on purchasing your Samson PowerStrip, PowerBrite, or PowerBrite Pro! This manual covers three products: the PowerStrip PS9; the PowerBrite PB9; and the PowerBrite Pro7. All three of these single-space rack units provide multiple outlets for reliable power distribution with 3-point surge and peak protection, plus RF (Ra[...]

System Featur es The Samson PowerStrip PS9, PowerBrite PB9, and PowerBrite Pro7 all utilize state-of-the-art technology in power distribution and are engineered to the finest detail. Here are some of their main features: • Multiple switched rear-panel AC outlets (eight in the PowerStrip PS9 and PowerBrite PB9; six in the PowerBrite Pro7) that all[...]

Guided T our - PowerStrip PS9 Fr ont Panel 1: Outlets switch - Use this to turn the rear-panel outlets on or off. When on, the status light inside this switch is lit red. 2: Unswitched convenience outlet - This 3-pin AC outlet is active whenever the PS9 is plugged in, regardless of the setting of the Outlets switch (see #1 above). 3: Circuit breake[...]

Guided T our - PowerStrip PS9 Rear Panel 1: Switched AC outlets (horizontal mount) - Connect external equipment to these standard 3-pin AC outlets, which are turned on and off from the front panel Outlets switch (see #2 on the previous page). 2: Switched AC outlets (vertical mount) - Similar to the AC outlets described in #1 above, these are mounte[...]

7 Guided T our - PowerBrite PB9 Fr ont Panel 1: Light switch - Use this to turn the fluorescent light in the slide-out drawer on or off. When on, the LED inside this switch lights red. 2: Outlets switch - Use this to turn the rear-panel outlets on or off. When on, the LED inside this switch lights red. 3: Slide-out drawer - Contains the PowerBrite [...]

8 Guided T our - PowerBrite PB9 Rear Panel 1: Switched AC outlets (horizontal mount) - Connect external equipment to these standard 3-pin AC outlets, which are turned on and off from the front panel Outlets switch (see #2 on the previous page). 2: Switched AC outlets (vertical mount) - Similar to the AC outlets described in #1 above, these are moun[...]

Guided T our - PowerBrite Pr o7 Fr ont Panel 1: Light switch - Use this to turn the fluorescent light in the slide-out drawer on or off. When on, the status light inside this switch is lit red. 2: Outlets switch - Use this to turn the rear-panel outlets on or off. When on, the status light inside this switch is lit red. 3: Voltmeter - This ten-stag[...]

Guided T our - PowerBrite Pr o7 Rear Panel 1: Lamp switch - Used to turn on or off a connected Littlite ® - compatible lamp (see #2 below). 2: Lamp connector - If required, you can connect a Littlite ® - compatible lamp to this 12 VDC female XLR jack. 3: Switched AC outlets (horizontal mount) - Connect external equipment to these standard 3-pin A[...]

11 Setting Up and Using Y our PowerStrip or PowerBrite Setting up your PS9, PB9, or Pro7 is a simple procedure which takes only a few minutes: 1. Remove all packing materials (save them in case of need for future service) and install the unit in a standard 19" rack. We recommend that the PB9 and Pro7 be placed in the top slot so that its slide[...]

12 Changing the PowerBrite Bulb The 4-watt fluorescent bulb in your PowerBrite PB9 and Pro7 is rated to deliver approximately 3,000 hours of operation. That ’ s a long time, to be sure, but there will probably come a time when you ’ ll need to replace it. The good news is that the bulb itself is readily available at most hardware stores and ele[...]

13 Specifications Electrical: Number of Outlets PS9 and PB9 8 switched, 1 unswitched Pro7 6 switched, 1 unswitched Max. Current 15 Amp (circuit breaker protected) Input Voltage (RMS) 0 to 130 Vac continuous Spike Protection Mode Hot to Neutral, Hot to Ground, and Neutral to Ground Max. Clamping Voltage (@ 50 A) 340 Vac Response Time 1 nanosecond Ma[...]

Appendix A: Fluor escent Or Incandescent? There are numerous advantages to using the kind of fluorescent lighting provided by the PowerBrite PB9 and PowerBrite Pro7 over the incandescent lighting provided by competing rack light products. Here are the main points to consider when making your purchase: • Fluorescent bulbs generate almost no heat a[...]

Congratulations and thank you for purchasing the SAMSON P owerBrite Pr o ™ or P o werBrite ™ Get Y our Nameplate Customized! Illuminate any image that will fit within the available space—4 1/8 ″ wide x 3⁄4 ″ high. Personalize your front nameplate by following the instructions: YOUR L OGO 4 1/8" 4 1/2" 7/8" 3/4" 1.5 3[...]

Changing the PowerBrite Nameplate After you have received your new Neo-Rack film, it ’ s a simple matter to install it. Begin by unplugging your PowerBrite and then unplug all devices connected to the rear and/or front panel outlets. Remove the PowerBrite from your rack and use both fingers to press gently on the two “ Push ” squares on the s[...]