Samsung CLP-500N инструкция обслуживания

COLOR LASER PRINTER Setup Guide V ÄRVILINE LASERPRINTER Paigaldusjuhend[...]

S ETUP G UIDE 2 C ONTENTS Step 1. Unpacking ............................................. 3 Step 2. Understanding Your Printer ................... 5 Step 3. Installing the Imaging Unit, Transfer Belt and Toner Cartridges ............................. 7 Step 4. Loading Paper ..................................... 16 Step 5. Connecting a Printer Cable[...]

S ETUP G UIDE 4 2 Carefully remove all of the packing tapes from the printer . 3 Pull the paper tra y out of the printer and remov e the packing tapes from the tr ay . 4 Select a location for the printer: •Leave enough room to open the printer tr ays, covers, and allow for proper ventilation. •Provide the proper en vironment: – A firm, level [...]

S ETUP G UIDE 6 Optional Tray 2 Jam Cover (Open to remove jams in the optional tray 2.) Muti-purpose Tray (Open to load special print materials.) Right Cover (Open to remove paper jams.) Power Switch USB Port Power Receptacle Control Board Cover (Open to install optional accessories.) Wireless Network Antenna * Network Port ** Parallel Port *** * T[...]

S ETUP G UIDE 9 English 6 Hold the handle on the imaging unit with the green roller facing you. Align the imaging unit with the slots in y our printer so that the colors on both sides of the imaging unit slide into the corresponding colors of the slots. C AUTION : Insert the imaging unit carefully so as not to scratch and damage the surface of the [...]

S ETUP G UIDE 11 English 12 Hold the handle on the tr ansfer belt and align it with the slots in your printer . N OTE : K eep the transfer belt level, do not turn the transfer belt over otherwise looses toner may be spilled. 13 Slide the transfer belt down into the printer . Press it firmly to make sure that it latches into place. S ETUP G UIDE 10 [...]

S ETUP G UIDE 13 English 16 T ake the toner cartridges out of their packages. C AUTION : Do not use sharp objects, such as a knife or scissors, to open the toner cartridges packages. Y ou could damage the surface of the toner cartridges. 17 Holding both sides of the cartridges, gently roll them from side to side to distribute the toner . 18 Place t[...]

S ETUP G UIDE 15 English 21 Close the left cover . Make sure that it is securely latched. If you hav e installed the toner cartridges wrongly , the left cover will not close properly . Check again to make sure the cartridge colors correspond to those mark ed on the right hand side. Never use force to close the co ver . N OTE : When printing text at[...]

S ETUP G UIDE 17 English 4 Load paper with the print side facing up . Make sure that all four corners are flat in the tr ay and under the corner brack ets as shown below . 5 Do not exceed the maximum stack height. Ov erfilling the tray ma y cause a paper jam. S ETUP G UIDE 16 Step 4. Loading Paper The tray (T ra y 1) can hold a maximum of 250 sheet[...]

S ETUP G UIDE 19 English Step 5. Connecting a Printer Cable Y ou need to connect y our printer to the computer with either a parallel interface cable or a Univ ersal Serial Bus (USB) cable. If you are a Macintosh user , you can use only a USB cable. N OTE : The CLP-500N does not support printing from a Macintosh using a network connection. Using a [...]

S ETUP G UIDE 21 English For Networking Printing Y ou can attach y our CLP-500 or CLP-500N printer to a network using an Ethernet cable (UTP cable with RJ .45 connector). CLP-500N has a built -in network interface card. If you are a CLP-500 user , you need to install an optional network interface card. If you want to use the printer in both a wired[...]

S ETUP G UIDE 23 English Step 7. Printing a Demo Page Print a demo page to make sure that the printer is oper ating correctly . 1 In ready mode, press and hold the Upper Level button ( ) on the control panel for 2 seconds to print a demo page. A demo page showing the printer’ s features and capabilities prints out. Step 8. Changing the Display La[...]

S ETUP G UIDE 25 English All applications should be closed on y our PC before beginning installation. 1 Place the CD-ROM in the CD-ROM driv e. Installation will start automatically . If the CD-ROM drive does not automatically run: Select Run from the Start menu, and t ype x:cdsetup.exe in the Open box (where x is the drive letter for the CD-ROM dr[...]

S ETUP G UIDE 27 English Step 10. Viewing the User’s Guide The Samsung CLP-500 Series User’ s Guide, which is in the software CD-ROM, is in Adobe Acrobat PDF format. The manual will give you flexibility and conv enience when you have to access information. Y ou can view the manuals on-screen in different formats (viewing a single page, continuo[...]

S ETUP G UIDE 28 In Linux 1 When the Administrator Login window appears, t ype in “ root ” in the login field and enter the system password. 2 Insert the printer software CD-ROM. 3 Click the icon at the bottom of the screen. When the terminal screen appears, type in: [root@local /root]# cd /mnt/cdrom (the CD-ROM directory) [root@local cdrom]# g[...]