Samsung SSA-R2001 инструкция обслуживания

RFID Reader User Manual SSA-R2001 imagine the possibilities Thank you for purchasing this Samsung product. To receive more complete service, please visit our website. www.samsungsecurity.com[...]

2_ Safety information safety information CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol indicates that dangerous voltage consisting a risk of electric shock is present within this u[...]

English 3 SAFETY INFORMATION Keep out of direct sunlight and heat radiation sources. It may cause fi re. Install it in a place with good ventilation. Avoid aiming the controller directly towards extremely bright objects such as sun. Apparatus shall not be exposed to dripping or splashing and no objects fi lled with liquids, such as vases, shall b[...]

4_ Contents contents PRODUCT INTRODUCTION 5 5 Features 5 What’s included 6 At a Glance 7 Cable Color Scheme 7 Cable Selection INSTALLATION AND EXTERNAL CONNECTION 8 8 Installation 9 Precautions on installation 10 External Connection INITIALIZATION 11 11 Output Format 12 Basic Operations OUTPUT FORMAT 13 13 WIEGAND Output 14 RS-232 Output 15 4/8 B[...]

English 5 PRODUCT INTRODUCTION FEATURES This product is an elegant-looking proximity reader equipped with the built-in keypad, which has the maximum of 10cm (4”) read range. It is also supported by backlighting on the keypad, enabling stable operation at night. This product permits user access through authentication of the contactless card and pe[...]

6_ Product Introduction product introduction AT A GLANCE Front/Rear 1 LED Displays the status of the system operation. 2 Keypad Used to enter the ID/password. 3 2-PIN Connector Can be connected to the power cable. 4 6-PIN Connector Can be connected to Wiegand, RS-232 communication cables. 5 8-PIN Connector Connected to the tamper, LED and buzzer co[...]

English 7 PRODUCT INTRODUCTION CABLE COLOR SCHEME 2-PIN Connector I/O Pins Signal Cable Color Power (+12V) DC +12V Re d Earth-grounding GND (-) Black 6-PIN Connector I/O Pins Signal Cable Color Wiegand Data Output 0 WI K_D ATA0 G reen Wiegand Data Output 1 WIK_DATA1 White Not Used Not Used Orange RS-232 TX TX OUT Purple Not Used Not Used Brown RS-2[...]

8_ Installation and External Connection installation and external connection INSTALLATION Attach the provided rear panel to the wall and drill two 6-32 holes and one 1/2 inch hole on it. (See [Figure 1]) Refer to [Figure 2] below on how to secure the rear panel to the wall using the provided screws. Apply each of 5 O-rings to the corresponding poin[...]

English 9 INSTALLATION AND EXTERNAL CONNECTION PRECAUTIONS ON INSTALLATION IF INSTALLING ON A METAL WALL If you install the reader on a metal wall, the read range may be reduced. To avoid this problem, it is recommended to insert the spacer between the metal wall and the reader as shown below. IF INSTALLING MORE THAN ONE READER SIDE BY SIDE OR FRON[...]

10_ Installation and External Connection installation and external connection EXTERNAL CONNECTION WIRING DIAGRAM Category Cable Color Power Supply Unit Connect the DC+12V to the red line. Connect GND to the black line. Wiegand Connection Connect the green line of the product to the Wiegand D0 input port of the controller. Connect the white line of [...]

English 11 INITIALIZATION initialization OUTPUT FORMAT You can adjust the output format of the numeric values from the keypad. You can select 4/8 bit Burst or 34bit Wiegand. Adjust the format according to the controller receiving the keypad input. To change the output format, use the switch on the rear of the product. See the table below to make ad[...]

12_ Initialization initialization BASIC OPERATIONS Initial State (when the power is supplied) When you apply power to the product, it will sound beep three times before entering Standby with the red indicator turned on. Using the card Present the card to the product until you hear a beep and the green indicator turns on. The reader keeps the green [...]

English 13 OUTPUT FORMAT output format WIEGAND OUTPUT Timing Diagram Data Format (34-bit) Bit 1 : Even Parity (bit 2 ~ bit 17) Bit 2~Bit33 : 4-byte ID Number Bit 34 : Odd Parity (bit 18 ~ bit 33) • • • 100us 1ms DATA-0 DATA-1 12 3 5V 0V 0V 5V 0 LOGIC 1 1 1 0 0 n-2 n-1 n *n : 34 or26[...]

14_ Output Format output format RS-232 OUTPUT Output Waveform Data Type START (0X02H) DATA (10 Char) END (0x03H) LRC START(0X02H) DATA (10 Char) END (0x03H) LRC Check the following settings: Baud Rate : 9600bps Data Bit : 8 Parity Bit : None Stop Bit : 1 LRC : This is the result of XOR operation of each byte from Start to End. M   Mark(=1) Sp[...]

English 15 OUTPUT FORMAT 4/8 BIT BURST OUTPUT FORMAT 4Bit Burst Output Format Keypads Binary Hexa Keypads Binary Hexa 0 0000 0 6 0110 6 1 0001 1 7 0111 7 2 0010 2 8 1000 8 3 0011 3 9 1001 9 4 0100 4 ESC 1010 A 5 0101 5 ENT 1011 B 8Bit Burst Output Format Keypads Binary Hexa Keypads Binary Hexa 0 11110000 F0 6 10010110 96 1 11100001 E1 7 10000111 87[...]

16_ troubleshooting troubleshooting TROUBLESHOOTING If the product does not function properly, please see the below for trouble shooting. If the trouble persists, please contact the SAMSUNG Customer Service near you. PROBLEM SOLUTION My card is not read properly. 1) Check the rated voltage specifi ed in the user manual and the catalog. 2) Ensure t[...]

English 17 product specifi cations PRODUCT SPECIFICATIONS Item SSA-R2001 Power / Current DC 12V / Max.75mA Reading Time (Card) 30ms Input Port 2 ea : External LED Control, External Buzzer Control Output Port 34bit Wiegand, 4/8bit Burst for PIN (Selectable) LED Indicator 3 LED Indicators (Red, Green and Orange) Beeper Piezo Buzzer Keypad 12 Key Num[...]

AB82-02555A Correct disposal of batteries in this product (Applicable in the European Union and other European countries with separate battery return systems.) This marking on the battery, manual or packaging indicates that the batteries in this product should not be disposed of with other household waste at the end of their working life. Where mar[...]