Scott SRX 210 Drift инструкция обслуживания

USER MANUAL AND INST ALLA TION INSTRUCTIONS FM Stereo Radio RDS (Radio Data System) Function Anti-Shock Mechanism T elephone Mute Function 4x40 W High Power Output CD/MP3/WMA/SD/USB/AUX CAR RADIO SX R 210 EQ AMS MODE BAND RPT SCN SHF 12 3 4 5 6 TA AF PTY DISP REG AUX IN VOL/ PUSH SEL[...]

GB-1 CONTENTS CONTENTS...............................................................................................................................................GB-1 ACCESSORIES........................................................................................................................................GB-2 PRECAUTION..................[...]

ACCESSORIES Mounting Bracket (Half Sleeve) X1 Removable Trim Ring equipped on the unit X1 Small metal Strip X1 Plain Washer X1 Spring Washer X2 T apping Screw X1 Screw X4 Hex Nut X1 Mounting Bolt X1 Release Key X2 ISO Wire Connector X1 Protective Case X1 Removable Control Panel X1 User Manual X1 ACCESSORIES USER MANUALAND INST ALLATION INSTRUCTIONS[...]

This unit is designed and manufactured with the user’s safety in mind, however any improper use or operation may result in certain dangers. It is therefore highly recommended to read this manual thoroughly and adhere to the following precautions. T o prevent an electrical shock, do not open the housing of the unit. In any case of malfunctioning, [...]

Installation Notes: - Choose the mounting location where the unit will not interfere with the normal driving function of the driver . - Before finally installing the unit, connect the wiring and make sure that the unit works properly . - Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the ve[...]

Installing the unit Be sure you test all connections first, and then follow these steps to install the unit. 1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal. 2. Disconnect the wire harness and the antenna. 3. Press the OPEN ( ) button to remove the control panel (For detai[...]

9. Slide the unit into the sleeve until it locks into place. Ensure that you install the short part of the threading to the back of the unit and the long part to the metal strap. 10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the unit's front panel (see the steps of &ap[...]

USING THE DET ACHABLE FRONT P ANEL REMOVING AND PROTECTING DET ACHABLE FRONT P ANEL The front panel of the unit may be removed as a theft deterrent. After removing the front panel, use the case provided to keep the front panel from getting damaged. 1 Press the OPEN button to flip down the front panel. . 2 Grasp the right side of the front panel, th[...]

Wiring Diagram ANTENNA Socket L R FUSE ISO CONNECTOR GB-8 ISO connector: Part A: A1: A2: A3: A4: A5: A6: A7: A8: Part B: B1: B2: B3: B4: B5: B6: B7: B8: No Connect No Connect No Connect Battery B+ (Y ellow) Antenna (Blue) No Connect Accessory (Red) Ground B- (Black) Rear Right + (Violet) Rear Right - (Violet/Black) F r o n tR i g h t+(G r e y ) Fro[...]

Operations Location and Function of Keys Front panel : The front facet after removing the front panel: Descriptions of Function Controls GB-9 (1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (1 1) (12) (13) (14) (15) (16) (17) (18) (19) (20) (21) (22) (23) (24) (25) (26) (27) (28) Power on/off ( ) Button LCD display Button Open ( ) Button Disc slot Eject ([...]

Reset the unit Power on/off 1.T urn off the unit power . 2.Press the ( ) button and remove the front panel, then press the button with a ballpoint pen or similar object to restore the unit to the original factory settings. In power of f mode, switch on the unit by pressing any button except the button and the ( ) button or inserting a disc into the[...]

“T A SEEK or T A ALARM” (search for traffic announcement/traffic announcement alarm) - T A SEEK (traffic announcement search) mode: - T A ALARM mode: Note: “PI SOUND or PI MUTE”: “RETUNE L or RETUNE S” (long/short retune): RETUNE L mode: - RETUNE S mode: “MASK DPI or MASK ALL”: - MASK DPI mode: MASK ALL mode: When a newly tuned stat[...]

"BEEPS 2 ”, “BEEP ALL”, “BEEP OFF” EQ “ BAND - When receiving an RDS station: When ND - The car audio device is equipped with 4 preset equalizer modes. Press the button to select one of the following EQ modes: FLA T” “CLA S ” “ ” “ ” “DSP . Press and hold down the button to turn the loudness on or of f. If the unit [...]

TEL Mute The audio system automatically mutes whenever a telephone call comes in. Note: the function will not work if a cable is not connected to the car phone. When a call is received, 'TEL CALL' is displayed and all the unit functions are temporarily interrupted. Hang up the phone. 'TEL CALL' disappears from the display . 1. W[...]

Radio Operations Press the button to select the radio mode. one of the three Y ou can store up to a total of 18 radio stations in the memory (18 FM), manually or automatically . - Select a band (if needed) - Select a station by or buttons, refer to auto / manual tuning. - Hold a Preset button ( - ) for at least 2 seconds. - Select a band (if needed[...]

The RDS data are the PI, PS, TP , PTY , T A and AF data. SETTING AF MODE Regional Program Operation Some broadcasting stations change their program from normal broadcasting to regional broadcasting for a certain time period. When region is on, the current listening program remains unchanged. When region is off, it allows the reception moved to the [...]

Using PTY to select a program The PTY function allows you to search for a particular program type. T o select a program type, press the button. “POP M” (pop music) or “NEWS” will appear on the LCD display . Y ou can then select a program type using the preset buttons to . The program types are divided into two groups: the music PTY group an[...]

CD/MP3/WMA Disc Operations Press the button to select the disc mode. 1. Press the ( ) button on the front panel to flip down the front panel and then insert a disc into the disc slot with the printed side facing upward; and close the front panel, the player will play the disc automatically . 2.T o eject the disc, press the ( ) button to open the fr[...]

GB-18 How to select a file in MP3/WMA mode: There are four ways to access a file in MP3/WMA mode: a Press the button once to access the track number search mode. The message “MP3 T ” will be shown on the LCD display and the “ ” symbol will blink b Rotate the volume/select button to select a file number . Then press the button to confirm and[...]

GB-19 d After you have press the button to confirm. The unit searches for files and directories which have the same character as the one which you entered. e the volume/select button to select a file. Finally , press the button to confirm and play the selected track. Press the button three times to access the root directory . The first directory na[...]

GB-20 Using the SD/MMC card: MODE Note: When you insert a SD/MMC card into the memory card slot, the player will read the SD/MMC card automatically . If you insert a disc into the disc slot while reading the SD/MMC card, the unit will play the disc. Y ou can press button to select SD/MMC mode. SD/MMC memory card playback operation is the same with [...]

Using the USB stick: MODE Note: When you insert a USB stick through the port, the unit will search for the MP3/WMA files and start to play them automatically . If you insert a disc into the disc slot while reading the USB stick, the unit will play the disc. Y ou can press button to select USB mode. - Use the USB adaptor cable, if necessary . - The [...]

GB-22 2. The unit cannot play a CD-R and CD-RW that is not finalized. (Please refer to the manual of your CD-R/CD-RW recorder or CD-R/CD-RW software for more information on finalization process). 3. Depending on the recording status, conditions of the disc and the equipment used for the recording, some CD-Rs/CD-RWs may not be played on this unit (s[...]

3. Near car heaters. 4. On the seats or dashboard. Use a dry soft cloth to wipe the surface. If the disc is quite dirty , Use a soft cloth slightly moistures with isopropyl (rubbing) alcohol. Never use solvents such as benzene, thinner or conventional record cleaners as they may the surface of the disc. Disc Cleaning damage Note: A disc may become [...]

1. GENERAL 2. CD PLA YER 3. RADIO FM 4.USB/SD/MMC card Power Supply Requirements.............................DC 12 V olts, Negative Ground Unit Dimensions...................................................178(W)x160(D)x 50(H) mm T one Controls.........................................................- Bass (at 100 Hz) ±10 dB - Treble (at 10 KHz) ±[...]

Symptom Cause Solution No power The car ignition switch is not on. T urn the ignition key to “ACCESSORY” in order to switch the unit on. The fuse at the back of unit has been blown. Check the connections. Presence of CD disc inside the player. Remove the disc from the player , and insert a new one. Disc can not be loaded or ejected. Inserting t[...]

If at any time in the futu e you should need to dispose of this product, please note that waste electrical product should not be disposed of with household waste. Please recycle where facilities exist. Check with Y our Local Authority or retailer for recycling advice. (W aste Electrical and Electronic Equipment Directive) r[...]