Sears 200.71223 инструкция обслуживания

OWNER'S MANUAL DieHard, Battery Charger 12/2 Amp Fully Automatic Microprocessor Controlled Engine Starter 75 Amp Model No. 200.71223 CAUTION: Read all Safety Rules and Operating instructions, and follow them with each use of this product. Sears_ Roebuck and Co, Hoffman Estates_ IL 60179 U.S.A. 0099000311-602[...]

WARRANTY .............................................................................................................. 2 IMPORTANT SAFETY INSTRUCTIONS .................................................................. 3 PERSONAL SAFETY PRECAUTIONS .................................................................... 4 BEFORE USING YOUR BA'n&ap[...]

WARNING: To reduce the risk of explosion, explosive gases, or injury while using your battery charger, follow the precautions listed below: • Read all instructions and cautions printed on the battery charger, battery, and vehicle or equipment using battery. • Use charger only on lead-acid type rechargeable batteries, such as those used in cars,[...]

For your own personal safety, please follow the following precautions: • Wear complete eye and clothing protection when working with lead- acid batteries, • Be sure that someone is within range of your voice to come to your aid if needed while you work with or are near a lead-acid battery. • Have plenty of fresh water and soap nearby for use [...]

It is important to understand your charger's requirements. This section will tell you about your charger's electrical requirements and how to prepare a battery for charging. ASSEMBLING YOUR CHARGER Included with your battery charger are two cord wrap cleats for storage of the clamp cables. To install, align the three tabs to corre- spond [...]

It is important that you read and follow these guidelines while you are preparing to charge your battery. • Make sure that you have a 6 volt or 12 volt lead-acid battery. • Clean the battery terminals. Be careful to keep corrosion from getting in or around your eyes. • For batteries with removable vent caps, if required, add distilled water t[...]

For best results from your battery charger, learn to use it properly. This section tells how to set the controls and how to charge a battery in and out of a vehicle. TOUCH PAD / L _ _ CONTROL _ BATTERY TYPE BUTTONS _ _ _ _ 12VOLT _-V_] r nVnlT'_ TYPE1 l TYPE2 J L ..... J BATTERY STATUS r-] I--I I--I I--I r--I I--]_ CHECK CHARGED LEDs 2 Amp cha[...]

NOTE: The charger defaults to Type 1 when first plugged in or when discon- nected from a battery. The 6 VOLT button must then be pressed before charging a 6 volt battery. With the exception of AGM and gel cell batteries, all other battery types may or may not have vent caps. Vent caps are located on top of the battery and provide a means to add dis[...]

t.D MODEL 71223 X indicates panel lights that continuously glow. B indicates panel lights that blink on and off. Initial power up Battery REVERSED or NOT connected Normal battery detected, charge started Sulfated battery detected, charge started Charging 0% to 25% completed Charging 20% to 50% completed Charging 35% to 90% completed Charging 75% to[...]

IMPORTANT: Follow all safety instruc- tions and precautions when charging your battery. Wear complete eye protection and clothing protection. Charge your battery in a well-ventilated area. Charging your battery in the vehicle: 1. Avoid personal injury by keeping clear of fan blades, belts, pulleys and other engine parts. 2. Avoid damaging the charg[...]

Charging your battery removed from the vehicle: POSITIVE NEGATIVE II 24", 6 GAUGE II U U GROUNOEO POWER OILrFLET 1. Note the poladty of the battery posts by checking the identification marks on the battery: POSITIVE (POS, P or +) and NEGATIVE (NEG, N or -). The positive post is usually larger than the negative post. 2. Attach at least a 24-[...]

This charger adjusts the charging time in order to charge the battery completely, efficiently, and safely. The microprocessor automatically makes all necessary calculations. However, this section includes guidelines that can be used to estimate charging time. The duration of the charging process de- pends on each of three factors. 1. Battery state:[...]

A minimal amount of care can keep your battery charger working properly for years. 1. Clean the clamps each time you are finished charging. Wipe off any battery fluid that may have come in contact with the clamps to prevent corrosion. 2. Coil the input and output cords neatly when storing the charger. This will help prevent accidental damage to the[...]

Performance problems often result from little things that you can fix yourself. Please read through this chart for a possiblesolution if a problem occurs. PROBLEM POSSIBLE CAUSE SOLUTION Indicator lights are lit in The charger may be Return to place an erratic manner not defective, of purchase for a explained in the "Using replacement. Your Ba[...]

This section shows an illustration of your battery charger. Use it to become familiar with part locations and appearance. Item Description Part Number Item Description Part Number 1. Transformer 93026558 7. ACPowerCord 90026135 2. SCRControlModule 2299001160 8. Handle 3599000270 3. Screw 8-18 xY2" (4) 5199000274 9. Faceplate 0899001725 4. Touc[...]

For information about troubleshooting, call toll-free from anywhere in the U.S.A. 7 am to 4:30 pm CT Monday through Friday. 1-800-SEARS-64 (1-800-732-7764). 16[...]