Sears 200.71226 инструкция обслуживания

OWNER'S MANUAL Microprocessor Controlled, Fully Automatic Operation Battery Charger with Engine Starter Plus Battery and Alternator Tester 2=AIVlP SLOW CHARGE 15=AMP FAST CHARGE 40-AMP RAPID CHARGE 125=AMP ENGINE START FOR 12=VOLT BATTERIES Model No. 200.71226 CAUTION: Read all Safety Rules and Operating Instructions, and follow them with each[...]

WARRANTY ................................................................................................................ 2 IMPORTANT SAFETY INSTRUCTIONS ................................................................... 3 PERSONAL SAFETY PRECAUTIONS ...................................................................... 4 BEFORE USING YOUR BATTERY[...]

WARNING = RISK OF EXPLOSIVE GASES WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BAT- TERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR CHARGER, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY. To reduce risk of battery explosion, follow t[...]

Never place charger directly above battery being charged. The gases from the battery wilt corrode and damage the charger. Never touch the battery clamps together when the charger is on. You could cause a spark. Never operate charger ifit has received a hard blow, been dropped, or otherwise damaged. Take itto a qualified profes- sional forinspection[...]

PLUGGING IT IN Your charger requires a 120V AC 2-prong wall outlet receptacle installed according toalllocal codes and ordinances. It is important tounderstand your charger's requirements. This section will tell you about your charger's electrical requirements and how to prepare a battery forcharging. Wrap clamp cables after unplugging th[...]

NOTE: A marine (boat) boat battery must be removed and charged on shore. To charge it on board requires equipment specially designed formarine use. IMPORTANT: Follow all safety instructions and precautions when charging your bat- tery. Wear complete eye protection and clothing protection. Charge your battery in a welt-ventilated area. CHARGING BATT[...]

CHARGING BATTERY REMOVED FROM THE VEHICLE: POSITIVE NEGATIVE BATTERY BATTERY _CHARGER POWER 24", 6 GAUGE CABLE GROUNDED POWER OUTLET 1. Note the polarity of the battery posts by checking the identification marks on the battery: POSITIVE (POS, P or +) and NEGATIVE (NEG, N or-). The positive post is usually larger than the negative post. 2. Atta[...]

in seconds. It starts at 5 and counts down to 0. 3. Cool Down - After cranking, the char- ger enters a mandatory 3-minute (180 second) cool down state. During this period, no settings can be changed. The buttons are ignored. The digital display indicates the remaining cool down time in seconds. It starts at 180 and counts down to 0. The 125A START [...]

If the charge mode is changed after charg- ing has started (by pressing the CHARGE RATE or CHARGE TYPE button), the charging process wilt berestarted. The voltage displayed during charging is the charging voltage and usually will be higher than the battery's resting voltage. 71226 CONTROL PANEL DISPLAY MODE SWITCH Use this switch button to set[...]

71226 CONTROL PANEL GUIDE MODE OF OPERATION Initial power-up, battery not detected No battery or reversed battery detected Battery tester activated Battery tester with charged battery Battery tester with no battery Voltage meter activated Alternator tester activated Alternator tester on good alternator Alternator tester on bad alternator 2 Amp char[...]

OVERVIEW This battery charger has a built-in battery tester that displays either an accurate battery voltage or an estimate of the battery's relative charge based on the battery voltage and the Battery Council International scale. TESTING SEQUENCE There are four basic steps required to use the 71226 as a battery tester. 1. Connect the charger [...]

This battery charger has a built-in alter- nator tester that displays either an accu- rate alternator voltage or an estimate of the alternator's relative output compared tonormal alternators. The Alternator % values displayed should be taken as general reference, not precise diagnosis. The alternator tester functions the same as the battery te[...]

This charger adjusts the charging time in order to charge the battery completely, efficiently and safely. The microproces- sor automatically makes the necessary decisions. However, this section includes guidelines that can be used to estimate charging times. The duration of the charging process depends on three factors: 1. Battery State - If a batt[...]

Read this entire manual before using your charger. The tips below serve only as a guide for specific situations. If your vehicle won't start: You don't need to fully charge a battery to start your vehicle. If the charger won't start your vehicle using the 125A START rate, try charging the battery using the 40A rate for 10 or 15 minut[...]

Performance problems often can be corrected by the user. Please read through this chart for a possible solution to common problems. PROBLEM POSSIBLE CAUSE SOLUTION The battery is connected The charger is in tester and the charger is on, mode, not charger mode. but isn't charging. Indicator lights are tit in an erratic manner not explained in t[...]

This section shows an illustration of your battery charger. Use it to become familiar with part locations and appearance. Replacement Parts List Sears 71226 iTEM DESCRIPTION PART NUMBER 1 Handle Assembly 2299001477 2 Case, Top 3799004060 3 Faceplate 0899002635 4 ControlBoard Assembly 2299001463 5 OutputCablesand 3899001198 Clamps 6 PowerCord 900261[...]