Sherwood RX-4105 инструкция обслуживания

  RX-4105 AM/FM STEREO RECEIVER OPERA TINGINSTRUCTIONS[...]

1. Read Instructions - All the safety and operating instructions should be read before the product is operated. 2. Retain instructions - The safety and operating instructions should be retained for future reference. 3. Heed Warnings - All warnings on the product and in the operating instructions should be adhered to. 4. Follow Instructions - All op[...]

2 Introduction Congratulations on Your Purchase! Your new high fidelity receiver is designed to deliver maximum enjoyment and years of trouble free service. Please take a few moments to read this manual thoroughly. It will explain the features and operation of your unit and help ensure a trouble free installation. Please unpack your unit carefully.[...]

FOR U.S.A AND CANADA .................................. 120 V Units shipped to the U.S.A and Canada are designed for operation on 120 V AC only. Safety precaution with use of a polarized AC plug. However, some products may be supplied with a nonpolarized plug. CAUTION : To prevent electric shock, match wide blade of plug to wide slot, fully insert.[...]

4 CONTENTS SAFETY INSTRUCTIONS ............................................................................................................ 1 Introduction UNPACKING AND INSTALLATION ............................................................................................. 2 READ THIS BEFORE OPERATING YOUR UNIT ...................................[...]

5 System Connections • Do not plug the AC input cord into the wall AC outlet until all connections are completed. • Be sure to connect the white RCA pin cords to the L(left) and the red RCA pin cords to the R(right) jacks when making audio connections. • Change the position of the FM indoor antenna until you get the best reception of your fav[...]

6[...]

7 Front Panel & Remote Controls  [...]

8 POWER BUTTON Each time the POWER button is pressed, this unit is turned on to enter the operating mode or off to enter the standby mode. STANDBY INDICATOR HEADPHONE JACK Stereo headphones with a standard 1/4 inch plug can be plugged into this jack for private listening. SPEAKER A, B SELECTOR BUTTONS These buttons allow you to select various combi[...]

9   LOADING BA TTERIES REMOTE CONTROL OPERA TION RANGE 1 Use the remote control unit within a range of about 7 meters (23 feet) and angles of up to 30 degrees aiming at the remote sensor. Remove the cover. 2 Remove the batteries when they are not used for a long time. Do not use the rechargeable batteries(Ni-Cd type). Load two batteries match[...]

10 LISTENING TO A PROGRAM SOURCE Operations Operate the selected component for playback. 4 Adjust the volume to a comfortable listening level. 5 Each time this button is pressed, this unit is turned on to enter the operating mode or off to enter the standby mode. In the standby mode, the STANDBY indicator lights up. This means that the receiver is [...]

11 “TON DIR” is displayed and the sound that bypasses the tone circuitry will be heard. To cancel the tone direct function, press this button again to display “TON CTRL”. To listen to a program source without the tone effect. 10 Each time this button is pressed, the corresponding tone mode is selected and shown for 3 seconds as follows: Ent[...]

12 LISTENING TO RADIO BROADCASTS Presetting radio stations Auto tuning • Each time this button is pressed, the mode changes as follows: • The tuner will now search until a station of sufficient strength has been found. The display shows the tuned frequency and “TUNED”. • If the station found is not the desired one, simply repeat this oper[...]

13 Repeat the above steps 1 to 3 to memorize other stations. 4 After selecting the tuner as an input source, select the preset mode. 1 Listening to FM stereo broadcasts • When using the NUMERIC buttons on the remote control. Examples) For “3” : For “15” : For “30” : • The station has now been stored in the memory. • When using the[...]

Operating the sleep timer The sleep timer allows the system to continue to operate for a specified period of time before automatically shutting off. To set the receiver to automatically turn off after the specified period of time. Each time this button is pressed, the sleep time changes as follows: Each time this button is pressed, the brightness o[...]

15 T roubleshooting Guide PROBLEM POSSIBLE CAUSE REMEDY If a fault occurs, run through the table below before taking your receiver for repair. If the fault persists, attempt to solve it by switching the receiver off and on again. If this fails to resolve the situation, consult with your dealer. Under no circumstances should you repair the receiver [...]

16 AMPLIFIER SECTION Power output, stereo mode, 8 Ω , THD 0.08 %, 40 Hz~20 kHz ............................................................... 2X105 W Total harmonic distortion, 8 Ω , 100 W, 20 Hz~20 kHz ............................................................................. 0.04 % Intermodulation distortion 60 Hz : 7 kHz= 4 : 1 SMPTE, 8 [...]

RX-4105 AM/FM STEREO RECEIVER OPERA TINGINSTRUCTIONS 5707-04740-004-1[...]