Smeg ALFA135BE инструкция обслуживания

Table of Contents 1. PRECAUTIONS FOR SAFETY AND US E _____________________ 19 2. INSTALLING THE OVEN __________________________________ 21 3. DESCRIPTION OF CONTRO LS ____________________________ 23 4. USING THE OVEN _______________________________________ 24 5. CLEANING AND MAINTENANCE ___________________________ 29 6. EXTRAORDINARY MAINTENANCE __[...]

Introduction 1. PRECA UTIONS FOR SAFETY AND USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. TAKE GOOD CARE OF IT AND KEEP IT TO HAND THROUGHOUT THE OVEN'S LIFE CYCLE. WE URGE YOU TO READ T HIS MANUAL AND ALL THE INFORMATION IT CONTAINS CAREFULLY BEFORE USIN G THE OVEN. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED STAFF IN COMPLIANCE WIT[...]

Introduction THE APPLIANCE BECOMES VERY HOT DURING USE. OVEN GLOVES SHOULD ALWAYS BE WORN. THE NAMEPLATE WITH THE TECHNICAL D ATA, SERIAL NUMBER AND MARK IS IN A VISIBLE POSITION ON THE SIDE OF THE OVEN. THIS NAMEPLATE MUST NEVER BE REM OVED. THE APPLIANCE IS DESIGNED FOR PROFESSIONAL USE BY TRAINED STAFF . KEEP CHILDREN AT A SAFE DISTANCE AND NEVE[...]

Instructions for the Installer 2. INST ALLING THE O VEN The oven is designed for free-standi ng installation on a horizontal w ork- top. It must be far enough from the wa ll behind it to allow easy access to the terminal board for conne ction of the power supply lead. Installati on must be carried out by a qualified engineer in comp liance with the[...]

Instructions for the Installer 22 In case of connection to the electrical mains by means of so cket and pin, the connection must be compl eted with a three-pi n plug of suitable rating (25A), or, for operation at 380-415V2N ∼ or 380-415V3N ∼ , a five-pin plug (16A). The power supply plug and w all socket must be of the same type (in compliance [...]

Instructions for the User 3. DESCRIPTION OF CONTROLS START BUTTON Use this button to set th e time when turn ing on the appliance for the first time or after a p ower failure, edit programs and start cooking cycles. It also selects the operating power. STOP BUTTON Use this button to set th e time when turn ing on the appliance for the first time or[...]

Instructions for the User 24 4. USING THE O VEN 4.1 Precautions and General Advice When the oven is us ed for the first time, it should be heated to the maximum t emperature for lon g enough to burn off any oily residu es left by the manufacturing process. If you have to carry out any procedures on foods, leave the door open for as short a time as [...]

Instructions for the User 4.4 Program selection This oven has 15 different cooking program s, including: 14 user-editable programs for fan-mod e cooking (P1 to P14); 1 manual editable program for fan-mode cooking ( ). The following table shows the parameters for each program. Uprh preheating temperature Ut °C cooking temperature U Ct cooking time [...]

Instructions for the User 26 Press START to confirm the start of the program. The program starts, performing the pr eheating stage; the displ ay shows "PrEh". When the preheating is complete, a "BE EP" sounds to indicate that cooking can start, and the message "PrEh" flashes o n the display. Keep START pressed for a fe[...]

Instructions for the User The display shows U Ct . Press START to display the cooking time. Press START or keep it pressed to increase the cooking time (from 1 min . to 99 min.). Press STOP to complete the program editing procedure. The display shows UEnd . The parameters set are now saved i n the chosen program. 4.8 Manual cooking Use the knob to [...]

Instructions for the User 28 4.9 Rapid cooling The oven has a s pecial function whic h allows its inter ior to be cool ed quickly. To activate this function, turn the function selector to "0", open t he door and press the START key for at l east 2 seconds. The fans inside the oven will come into oper ation with the heating el ements off. [...]

Instructions for the User 5. CLEANING AND MAINTENANCE Important: never point jets of water str aight at the oven and do n ot use high- pressure water cleaners. Before carrying out any operation, disconnect the oven from the electricity supply. 5.1 Cleaning stainless steel To keep stainless steel in good condit ion, it must be cleaned regularly a t [...]

Instructions for the User 30 5.2 Cleaning the inside of the oven To keep the oven in g ood condition, it must be cl eaned regularly at th e end of each day, after allowing it to cool. Remove all rem ovable parts. Remove the side runners by removing the hook " C " from the hole or pin " D " (depending on the model) and the pin &q[...]

Instructions for the User 6. EXTRA ORDINAR Y MAINTENANCE Occasionally, the oven will require mi nor servicing proc edures or the replacement of parts subject to wear and tear, such as gaskets, light bulbs, etc. The specific oper ations fo r each pr ocedure of this kind are provided below. Before carrying out any operation, disconnect the oven from [...]

Instructions for the User 32 6.2 Removing the door Open the door completely and insert the pins (supplied) into the holes from the inside. Close the door to an angle of about 45° and lift it off. To reassemble, fit the hinges into their grooves, then lower t he door into place and extract the pins. 6.3 Oven door gasket To allow thorough cleanin g [...]