Smeg SUK61MBL5 инструкция обслуживания

Contents 1. INSTRUCTIONS FOR SAFE AND PROPER USE _______________________________4 2. INSTALLATION OF THE APPLIANCE_________________________________________6 3. ADAPTATION TO DIFFERENT TYPES OF GAS ________________________________9 4. FINAL OPERATIONS _____________________________________________________12 5. DESCRIPTION OF CONTROLS ________________[...]

Introduction 1. INSTR UCTIONS FOR SA FE AND PR OPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFOR E MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANU AL AND ALL TH E INSTRUCTIONS THEREIN BEFORE USING THE COOKER. ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. [...]

Introduction DURING USE THE APPLIAN CE BECOMES VERY HOT . TAKE CARE NOT TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN. DO NOT USE CONTAINERS OR BROI LERS THAT EXTEND BEYOND THE OUTE R PERIMETER OF THE HOB. THE APPLIANCE IS DESIGNED FOR USE BY ADULTS . DO NOT ALLO W CHILDREN TO GO NEA R OR PLAY WITH IT. WHEN OPERATING THE GRILL ALL ACCESSIBLE PARTS [...]

Instructions for the installer 2. INST ALLA TION OF THE A PPLIANCE It is the law that all gas applia nces are installed by competent persons . Corgi gas installers ar e approved to work to safe and satisfactory standards . All gas installation, servicing and repair wor k must be in accordance with the gas safety regul ation s 1984 (installation and[...]

Instructions for the installer 2.1 Electrical connection Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment. This rating plate must never be removed. If the appliance is connected to the supply by means of a fixed connection, install a multipolar cut-out device on th[...]

Instructions for the installer 8 2.3 Connecting to natural and LPG gas FOR THE GAS CONNECTION, SEE THE TYPE OF APPLIANCE SUPPLY TUBE • Free hexagonal connector Make the connection to the appliance using flexible ba yonet style hose in accordance to B.S. 669. The hose connection at the rear of the appliance has a ½” BSP internal thread. Please [...]

Instructions for the installer 9 3. AD APT A TION T O DIFFERENT TYPES OF GAS Before performing any cleaning or maintenanc e work, disconnect the appliance from the mains. The cooker hob is preset for natural gas G20 (2H) at a pressure of 2 0 mbar. In the case of operation with other types of gas the burner nozzles must be changed and the minimum fl[...]

Instructions for the installer 10 3.2 Burner and nozzle characteristics tab le (Mod. 90 cm.) Burner Rated heating capacity (kW) LPG – G30/G31 28/37 mbar Nozzle diameter 1/100 mm By-pass mm 1/100 Reduced flowrate (W) Flowrate g/h G30 Flowrate g/h G31 Auxiliary 1.0 50 30 350 73 71 Semi rapid 1.75 65 33 450 127 125 Rapid 3.0 85 45 800 218 214 Triple[...]

Instructions for the installer 11 3.4 Burner and nozzle characteristics tab le (Mod. 60 cm.) Burner Rated heating capacity (kW) LPG – G30/G31 28/37 mbar Nozzle diameter 1/100 mm By-pass mm 1/100 Reduced flowrate (W) Flowrate g/h G30 Flowrate g/h G31 Auxiliary 1.0 50 30 350 73 71 Semi rapid 1.75 65 33 450 127 125 Rapid 3.0 85 45 800 218 214 Triple[...]

Instructions for the installer 1 4. FINAL OPERA TIONS After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids. Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the appliance with the one corresponding to the new gas. This label is in the packet together with [...]

Instructions for the installer 1 4.4 W all fixing • Stretch out the chain attached to the cooker horizontally so that the other end touches the wall. • Mark the wall in the position where the hole is to be drilled. • Drill the hole, insert a wall plug and attach the ch ain. • Move the cooker up against the wall. 3[...]

Instructions for the installer 14 5. DESCRIPTION OF CONTR OLS 5.1 Front contr ol panel All the cooker controls and commands are on the front panel. If the cooker is equipped with an electronic programmer, before using the oven make sure that the symbol ; appears on the display. See paragraph “8. ELECTRONIC PROGRAMMER”. DESCRIPTION OF SYMBOLS CE[...]

Instructions for the user 1 VARIABLE GRILL KNOB This allows to vary heat intensity w hen cooking with the grill. The knob can be set with continuity between “ 0 ” and the st op release position, which corresponds to maximum heat. ELECTRIC OVEN CONTROL K NOB Each of the functions listed below can be use d (except the oven light and the small gri[...]

Instructions for the installer 1 6. USE OF THE HOB 6.1 Lighting of the hob b urners Before lighting the hob burners check that the flame caps are in the correct position and that their burner caps are in place, making sure that the holes A in the flame caps correspond to the spark plugs and thermocouples. The optional grid B is for use with “woks[...]

Instructions for the user 17 6.3 Diameter of the vessels to be used on each b urner BURNERS Ø min. and max. (in cm) 1 Auxiliary 12-14 2 Semi rapi d 16-24 3 Rapi d 18-26 4 Triple crown 18-26[...]

Instructions for the installer 18 7. USE OF THE O VEN For the models with electronic programmer, before using the oven make sure that the display shows the symbol . 7.1 W arnings and general advice Using the oven and the grill for the first time, heat them to the maximum temperature ( 260° C) for as long as it takes to burn off any production oil [...]

Instructions for the user 1 7.2.2 Using the rotisserie in cookers with maxi oven Fit the supporting frame onto the se cond runner up from the bottom so that the seat to take the rod projects outside the o ven. Place the rod as shown in the diagram (1 ) and push the frame into the oven until the end of the rod reaches the hole in the rotisserie moto[...]

Instructions for the installer 2 7.3 Using the pIzza function (only on some models) This appliance Is equipped with a function spe cially developed for cookin g pizza. This function is identified by the symbol on the oven functions knob. To cook a pizza, proceed as described b elow. With the oven cold, remove the round cove r from the bottom of the[...]

Instructions for the user 21 8. ELECTRONIC PR OGRAMMER (ONL Y ON EQUIPPED MODELS) LIST OF FUNCTIONS MINUTE-COUNTER KEY COOKING TIME KEY END-OF-COOKING KEY DECREASE TIME KEY INCREASE TIME KEY 8.1 Cloc k adjustment When using the oven for the first tim e, or after a power failure, the di splay flashes re gularly and indicates . Press the keys and at [...]

Instructions for the installer 22 8.4 End of cooking When cooking is over, the oven will automatically swit ch off and, at the same time, an intermittent alarm will sound. After swit ching off the alarm, the display will once again show the rig ht time together with the symbol , indicating that the oven has returned to manual operation mode. 8.5 Mi[...]

Instructions for the user 23 9. A V AILABLE A CCESSORIES The oven has 4 support for positioning pla tes and racks at various heights. Oven grill: for cooking food on plates, small cakes, roasts or food requiring light grilling. Plate grill: for placing above plate for cooking foods that might drip. Oven plate: useful for catching fat from foods on [...]

Instructions for the installer 24 10. CLEANING AND MAINTENANCE 10.1 Cleaning stainless steel and enamelled versions To maintain stainless steel in good condition clean it regularly after each use, once it has cooled down. 10.1.1 Ordinary daily cleaning To clean and preserve the stainless steel surfaces, always use only sp ecific products that do no[...]

Instructions for the user 2 10.3 Cleaning of oven For best oven upkeep clean regularly after having allowed to cool. Take out all removable parts. • Clean the oven grill with hot water and non-abrasive detergent. Rinse an d dry. • Do not allow residues of sugary foods (such as jam) to set inside the o ven. If left to set for too long, they migh[...]

Instructions for the installer 2 11. EXTRA ORDINAR Y MAINTENANCE The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations. Before any intervention, disconnect the power supply of the device. 11.1 Rep[...]