Snapper ELBX10152BV инструкция обслуживания

A A S S S S E E M M B B L L Y Y I I N N S S T T R R U U C C T T I I O O N N S S O O P P E E R R A A T T O O R R ’ ’ S S M M A A N N U U A A L L P P A A R R T T S S L L I I S S T T European Extreme Series Walk-Behind Leaf Blower Series 2 Actual product may differ slightly from product pictured above Manual No. 7043324 (I.R. - 02/28/05) Models Co[...]

2 1 preliminaries Congratulations! Y ou have just purchased one of the finest pieces of outdoor power equipment on the market today . If properly cared for , your new blower will provide years of dependable service. Please read and follow this instruction manual carefully in order to get the most out of your new equipment. As you carefully unpack y[...]

TRAINING • Read, understand, and follow all instructions in the manu- al and on the unit before starting. If the operator(s) or mechanic(s) can not read English it is the owner ’s responsi- bility to explain this material to them. • Become familiar with the safe operation of the equipment, operator controls, and safety signs. • All operator[...]

CHILDREN T ragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the unit and its activity . Never assume that children will remain where you last saw them. • Keep children out of the blowing area and under the watch- ful care of another responsible adult. • Be alert and turn unit of[...]

5 3 unit assembly Note: Please refer to Part s List for correct part identification and placement. FRONT WHEEL ASSEMBL Y • Place Mounting Bracket against lower right corner of Blower Housing, aligning holes in bracket with threaded holes in housing. Secure with three 3/8-16 x 1 hex bolts, split lock washers and flat washers. Tighten securely . ?[...]

6 4 unit operation ST ARTING THE ENGINE IMPORT ANT NOTE: The procedures outlined within this section are general guidelines, and are in no way meant to replace or supercede engine manufacturer ’s operating instructions. In order to obt ain optimum performance from your engine, refer to your engine manual. W ARNING! IMPELLER IS MOUNTED DIRECTL Y T[...]

7 4 unit operation (cont.) T O SHUT ENGINE DOWN: • Move engine speed control to slow “T urtle” position. • Allow engine to idle for 2-3 minutes before shutting down. • Move engine speed control to “STOP” position. Turn fuel valve to closed position. IMPORT ANT NOTE : If you experience problems with your engine that cannot be satisfact[...]

8 4 unit operation (cont.) GENERAL RULES TO OBSERVE BEFORE AND DURING OPERA TION: • Inspect your unit before each and every use. Check for worn, bent or broken components, loose fasteners, low or flat tires, etc., and repair or replace prior to operation. DO NOT OPERA TE A MACHINE THA T IS WORN OR DAMAGED – SERIOUS INJUR Y OR DEA TH CAN RESUL T[...]

9 5 maintenance GENERAL: • Follow implicitly the engine manufacturer ’ s recommendations for maintenance. • Always keep your machine clean – especially the engine. Check all adjustments periodically . Also, periodically check that all fasteners are secure. • Never make any adjustments to the unit until the engine is off and the spark plug[...]

10 5 maintenance (cont.) TROUBLESHOOTING: • UNIT WILL NOT ST ART : • Check fuel and oil levels. • Check to make sure choke is set when engine is cold, off when hot. • Check throttle for proper operation. • Check intake baf fle for jammed debris or accumulation of debris. • If condition persists, cont act dealer . • UNIT ST ALLS: • C[...]

11 • THROTTLE CABLE ADJUSTMENT : Correct cable adjustment allows for full range of movement of throttle body on engine in conjunction with throttle control on handle. T o adjust, loosen cable clip screw on engine, then slide cable housing in or out in approximately 1/8- 1/4” increments. Retighten screw , recheck, and read- just as needed. • F[...]

12 6 illustrated parts list[...]

13 6 illustrated parts list (cont.) Item Part No. Qty Description 1 7043267 1 WELDMENT , Housing- Extreme Blower , LBX10152BV 2 75892 1 DECAL - Danger-Flying Material - See DECAL IDENTIFICA TION 3 30391 1 1 1 ENGINE, B&S 10HP Intek OHV -- 3071815 1 SCREW , Clamp Casing, Briggs Intek Engine (Not Shown) -- 3071814 1 CLAMP , Casing, Briggs Intek E[...]

14 6 illustrated parts list (cont.) Item Part No. Qty Description 43 90391 4 W ASHER, 5/16" Internal T ooth Lock 44 3071800 1 THROTTLE CONTROL, Briggs 45 7078169 2 BEARING , 3/8” Clip 46 90505 1 SCREW , 1/4-20 x 2" Hex Head Cap, GR5 47 90188 14 W ASHER, .34 x .69 x .08 Flat 48 76978 1 NUT ,1/4-20 Hex Nyloc 49 91298 4 NUT , 5/16-18 Hex N[...]

15 7 decal identification 75893 - EAR/EYE/BREA THING PROTECTION REQUIRED - LOCA TED ON SIDE OF BLOWER HOUSING 75892 - DANGER-FL YING MA TERIAL - LOCA TED ON SIDE OF BLOWER HOUSING 29776 - EUROPEAN CERTIFICA TION - LOCA TED ON REAR OF BLOWER HOUSING 22841 - W ARNING-CUT FINGER - LOCA TED ABOVE BLOWER DISCHARGE 701 1279 - MODEL YEAR 2005 - LOCA TED O[...]

16 7 decal identification (cont.) 73462 - W ARNING COMBO - LOCA TED ON T OP OF BLOWER HOUSING EUROPEAN PERFORMANCE: Maximum level of vibration measured at the operator ’ s hand 16 m/sec2 27255 - SNAPPER LOGO - LOCA TED ON MID- HANDLE P ANEL (ON APPLICABLE MODELS) 1722551 - SIMPLICITY LOGO - LOCA TED ON MID-HANDLE P ANEL (ON APPLICABLE MODELS) 707[...]

17 notes[...]

18 notes[...]

19 notes[...]

20 A A S S S S E E M M B B L L Y Y I I N N S S T T R R U U C C T T I I O O N N S S O O P P E E R R A A T T O O R R ’ ’ S S M M A A N N U U A A L L P P A A R R T T S S L L I I S S T T European Extreme Series Walk-Behind Leaf Blower Series 2 Manual No. 7043324 (I.R. - 02/28/05) McDonough, GA 30253 USA[...]