Tascam CD-A700 инструкция обслуживания

» CD - A 7 0 0 Compact Disc P la yer/ Re verse Cassette Dec k 3D0027500A D This appliance has a serial number located on the rear panel. Please record the model number and serial number and retain them for your records. Model number Serial number W ARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. The excla[...]

_ 2 _ IMPORT ANT SAFETY INSTRUCTIONS CA UTION: O Read all of these Instructions. O Save these Instructions f or later use. O Follow all W arnings and Instructions marked on the audio equipment. 1) Read Instructions — All the safety and oper ating instructions should be read before the product is oper ated. 2) Retain Instructions — The safety an[...]

_ 3 _ SAFETY INFORMA TION O CAUTION O ACHTUNG O OBSERVERA O ADV ARSEL This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a class 1 laser product. There is no hazardous invisible laser r[...]

_ 4 _ Before Use O Choose the installation location of your unit carefully . Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibra- tions and excessive dust, heat, cold or moisture. Keep away from such sources that hum, such as transformers or motors. O Do not open the cabinet as this might result i[...]

_ 5 _ O Before connection, turn off all compo- nents and pay special attention to left (L) and right (R) channel indications. O Read the owner's manual of each com- ponent you intend to use with this unit. ∑ Signal cords LINE INPUT/OUTPUT terminals (Balanced/Unbalanced) Use these terminals to connect the deck to a mixer , cassette tape recor[...]

_ 6 _ Name of Each Control 1 POWER switch 2 REMOTE SENSOR 3 Multi-function display window a REPEA T indicator b Auto space indicator (A. SP ACE) c DELETE indicator d T ime mode indicator e Program indicator (PGM) f SHUFFLE indicator g CD input indicator (IN) h T APE/CD indicator i REC indicator j T ape PLA Y indicator k Level meter l T ape counter [...]

CD Player ∑ Music search using SKIP but- tons ( Ú / Æ ) The beginning of any track can be easily located using the Ú / Æ SKIP buttons. This operation is indicated clearly in the TRACK display . O This operation is possible even in the Program Playback mode. However , only programmed tracks will be detected. ∑ T o skip to the next track Pres[...]

∑ T o display the total program time In the Program mode, press the TIME but- ton to display the total program time. Pressing the TIME button again will return the CD player to the Program mode. ∑ T o review the program contents 1. Press the CHECK button in the Program mode. The first programmed track number will light and "P-01" will[...]

_ 9 _ The repeat function allows repeat playback of any single track, the entire disc, or any desired portion on the disc designated by two (start and end) points. O The repeat functions can be released by pressing the repeat button again. ∑ T o repeat one track (Single Repeat mode) 1. Press the REPEA T 1/ALL button. The REPEA T and SINGLE indica[...]

The time counter shows various time read- outs, as follows. 1 T otal disc playback time After the disc tray is closed with a disc loaded, the total disc playback time and total number of tracks on the disc are displayed. 2 Elapsed time display When playback begins, the elapsed time of the track being played is displayed in minutes and seconds. 3 Re[...]

_ 11 _ 1. Press the POWER switch ON. 2. Set the REV MODE switch to the required tape travel mode. 3. Load a pre-recorded cassette with its open edge facing down and side A fac- ing toward you. 4. Select ON/OFF of the DOLBY NR system. 5. Press the ” or ∏ button to start play- back. 6. Adjust the volume with the amplifier's volume control. O[...]

_ 12 _ Y ou can change the tape speed during playback, allowing to change the pitch of the reproduced sound. By turning the PITCH CONTROL to the right, the tape speed becomes faster , resulting in a higher pitch. By turning it to the left, the tape speed becomes slower , resulting in a lower pitch. O At the fully clockwise position, the tape speed [...]

Using the CD SYNC function, a CD-to-tape copy can be done easily and simply . 1. Load a compact disc. 2. Load a recordable cassette. 3. Select ON/OFF of the DOLBY NR system. O In the CD SYNC mode, the INPUT level control has no effect, as the recording level is automatically adjusted internally . ∑ T o record from the beginning of the tape Press [...]

The unit has a timer controlled function. This lets you start playback or recording operations at any desired time when an optional audio timer is used. ∑ T imer playback of CD or cassette 1. Connect the unit and your stereo system to an audio timer as shown in the dia- gram. 2. Set the power switches of all compo- nents to ON. 3. Load a disc or [...]

Problem Probable cause Remedy General No power when POWER is pressed. Power plug not inserted securely . Plug in securely . Hum. Pin-cord plug not connected securely . Re-connect plug securely . Noise in tuner . T oo close to tuner . Keep a reasonable distance between them or switch off the power of this unit. No audio output. Connection to stereo [...]

CD player section (Audio) Number of channels: 2 Frequency response: 20 - 20,000 Hz ± 0.5 dB Signal-to-noise ratio: 90 dB T otal harmonic distortion: 0.02% (1 kHz) Wow and flutter: Unmeasurable (quartz accuracy) Channel separation: 75 dB Pitch control: Approx. ±12 % Output (RCA): 2 Vrms Output (XLR): +20 dBu Digital filter: 4-times oversampling An[...]

PRINTED IN CHINA 0799U . M-1529A TEA C CORPORA TION 3-7-3, Nakacho , Musashino-shi, T okyo 180-8550, J apan Phone: (0422) 52-5082 TEAC AMERICA, INC . 7733 T elegraph Road, Montebello , California 90640 Phone: (323) 726-0303 TEAC CANAD A L TD . 340 Brunel Road, Mississauga, Ontario L4Z 2C2, Canada Phone: 905-890-8008 TEAC MEXICO , S.A. De C .V Priva[...]