Telex BTR-24 инструкция обслуживания

BTR-24 TR-24 Wireless Intercom System Operating Manual Bosch Communications Systems[...]

Table of Contents Section 1 Introduction ................................................................. 1-1 General Description ..................................................................... 1-1 System Features ........................................................................ 1-1 Section 2 BTR-24 Base Station ......................[...]

General Description The Telex BTR -24 System is a full duplex ( simult aneous talk and listen), multi-ch annel, wireless inter com system. The system offers a com plete soluti on for up to 10, full duplex use rs per base station, m any m ore if in push-to-tra nsmit m ode. With fast and ea sy set-up, durable bel tpacks, 64 bit audi o encrypti on, an[...]

1. On/Off Switch – Turns the power on/off to t he base stati on. 2. Power / Low Batte ry Light – Indicates the base stati on has power, either from the inter nal battery or external power connected t o the unit. Battery Indicat ion: • GREEN = Battery O K • RED = Battery Low ( » 30 m inutes left ) • No Light = Battery D epleted 3. AP Acti[...]

1. Volume Control and Po wer Switch – Turns the beltpac k power on/off and cont rols headset volum e. 2. Battery Light /Power Light – Indicates the belt pack has power, either from the inter nal battery or AC power connected t o the unit. • GREEN = Battery I ndication : battery OK • RED = Battery Low ( » 15 minutes l eft) • NO Light = Ba[...]

Section 4 - Specifications RF Technology ............................................................................................................IEEE 802.11 (WiFi) Frequency Band of Operation ......................................................................................2.412 to 2.462 GHz FCC License .....................................[...]

Wireless Mode Description The TR-24 has the ability t o be booted in one of thre e modes. These modes are wireless, wired and master wireless. Th is section will discu s the w ireless mode. The wireless m ode is the m ost used m ode of the bel tpack. The wireless m ode is set by holding the <TALK> but ton down as the unit boots. Then re lease[...]

Set-up Below are i nstructions for the set-up and operati on of a single BTR-24 wit h up to ten TR-24's. 1. Prior to use t he TR-24 and BTR-24 should have their bat tery packs fully charged . Refer to the “Battery Charging Instructions” ne ar the end of this s ection. 2. Plug the BTR-24's external power supply into an AC out let if av[...]

Figure 5-5 Top View of TR-24 The sidet one (amount of your own voic e fed back to your earphones) and m icrophone gain of the beltpacks m ay need adjusted fro m the factory defaults. The defau lts are: • Microphone Level = 4 • Sidetone Level = 2 Microphone Level Adj ust – Press <1> + <TALK > until a voice prompt i ndicates m icrop[...]

Up to ten bel tpacks, in full duplex ( simult aneous talk and li sten), may comm unicate with each other o ver a Ethernet netwo rk. In fact do to the f lexibility of th e BTR-2 4 system, wired beltpacks connected vi a a hub to a network coul d communica te to a BT R-24 connected t o the same net work. This base sta tion could then be connected wire[...]

The sidet one (amount of your own voic e fed back to your earphones) and m icrophone gain of the beltpacks m ay need adjusted fro m the factory defaults. The defau lts are: • Microphone Level = 4 • Sidetone Level = 2 Microphone Level Adj ust – Press <1> + <TALK > until a voice prompt i ndicates m icrophone adjust m ode has been en[...]

2. Plug the m aster TR-24’s ext ernal power supply i nto an AC outlet i f desired. If external pow er is not desire d then run off internal battery. 3. Place the TR-2 4’s in a lo cation wh ere it will hav e the best visibility to the o ther TR-2 4s. 4. Plug a headset i nto the m aster TR-24 bel tpack. 5. Power-up the master TR-24 beltpack in ma[...]

The sidet one (amount of your own voic e fed back to your earphones) and m icrophone gain of the beltpacks m ay need adjusted fro m the factory defaults. The defau lts are: • Microphone Level = 4 • Sidetone Level = 2 Microphone Level Adj ust – Press <1> + <TALK > until a voice prompt i ndicates m icrophone adjust m ode has been en[...]

Encryption Code The BTR/TR-2 4 system uses a 64 b it DES (Dig ital Encryptio n Standard) encrypt ion algorit hm to encrypt all audio in the s ystem . The beltpacks in the system have a “key” that th e algorith m uses as the basis for t he encrypt ion. The same “ke y” must be used in all beltpacks on the system for comm unication to occ ur. [...]

10. Plug the othe r end of the Ethernet cable into the be ltpack. 11. Type, telnet 192.168.1.X at the com puter’s com mand prompt, then p ress <ENT ER>. Fill in f or X th e last digit of the IP address t hat is on the back l abel on the TR-24. 12. After about 20 sec onds the beltpack wi ll respond with a l ogin request. Enter the following:[...]

Battery Care To ensure the long l ife and safe handl ing of the Li-Ion bat tery within the BT R-24 and TR-24 pleas e following the f ollowing precautions: 1. Store the TR-24s a nd BTR-24 in a cle an, cool, dry l ocation away from heat. 2. Do not store for extende d periods of ti me in direct sunlight. 3. Do not disassem ble the bat tery packs wit h[...]

Please rerea d the operation and e ncryption/pas sword section of this m anual to make s ure you have com pleted sy stem set -up properly. The fol lowing contains t roubleshooting ti ps that m ay be helpful in solvi ng the problem . Section 8 If you are unabl e to solve the probl em, contact the manufac turer or dealer from whom you purchase d the [...]

Section 8 - Trouble shooting co ntinued 8-2 Problem Possible Cause Solution When the BTR-24 power switch was turned on nothing happens. The power light does not light. • Internal batte ry is completely exhausted • Plug the AC power pl ug into the BTR-24. A llow the u nit at least 5 minutes for the in ternal batte ry to receive an initial charge[...]

802.11 RF Channels The BTR-24 syst em has t he ability to operate on any one of eleven RF channels. Althoug h there are several d ifferent frequency cha nnel settings, t here is overlap bet ween the channels. T here are three non-overla pping channels avai lable in the FCC regul atory dom ain. When choosing frequency cha nnels for system s in the v[...]

Regulatory I nformation The TR-24 and BTR -24 comply with Part 15 of FCC rules and Canada RSS-210 . Operation is s ubject to the fol lowing conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired op eration. 3. Use only the m anufacture r or[...]

Section 11 - Accessories and Replacement Items Model Number Part Number Description TR-24 PRD000065000 TR-24 Beltpack and US Power Supply. NOTE: User must provide the IP address of all TR-24/ BTR-24s in system with order. RPT-3 302054007 3 ft. coax with TNC reverse polarity plug connector. RPT-10 302054008 10 ft. coax with TNC reverse polarity plug[...]

Model Number Part Number Description BTR-24 PRD000066000 BTR-24 Base Station a nd US power supply. NOTE: User must provide IP address of all TR-24/BTR-24's in system with order. SYS-243 SYS000007000 System includes Carry Case, 3 TR-24 Beltpacks, 1 BTR-24 Base Station, Omni antennas, rack mounts, 3' Ethernet c able, and US power supplies. [...]

8601 East Cornhusker Highway, Lincoln, NE 68507 Made in U.S.A. PN LIT000078TX Rev. A Bosch Communications Systems[...]