Toshiba 27WL56 Series, 32WL56 Series, 37WL56 Series инструкция обслуживания

27/32/37WL56 Series Owner's manual TOSHIBA gg[...]

? For television operation queries, please ring the helpline… Remember… 2 Contents SETTING UP Safety precautions – Some do’s and don ’ts for you to be aware of 3 Installation and important information 4 The remote control – an at-a-glance guide 5 Connecting external equipment – a guide to connecting equipment to the back of the televi[...]

3 Safety P recautions This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken to obtain the best results and for safety to be assured. Please read the points below for your own safety . They are of a general nature, intended to help with all electronic consumer [...]

4 Installation and important information Where to install Locate the television away from direct sunlight and strong lights, soft, indirect lighting is recommended for comfortable viewing. Use curtains or blinds to prevent direct sunlight falling on the screen. Place on a sturdy platform, the mounting surface should be flat and steady . It should t[...]

5 The remote control UP Remove the back cover to reveal the battery compartment and make sure the batteries are inserted the right way round. Suitable battery types for this remote are AAA, IEC R03 1.5V . Do not combine a used, old battery with a new one or mix battery types. Remove dead batteries immediately to prevent acid from leaking into the b[...]

HDMI HDMI 6 Connecting external equipment Before connecting any external equipment, turn off all main power switches. If there is no switch remove the mains plug from the wall socket. HDMI™ (High-Definition Multimedia Interface) is for use with a DVD , decoder or electrical equipment with digital audio and video output. It is designed for best pe[...]

7 Connecting a computer or component video source the back of your television Computer Audio cable from PC or component video audio source to television (not supplied) Conversion adaptor if required (not supplied) RGB PC cable (not supplied) Mini D- sub 15p connector Mini D- sub 15p connector Component video connector ( not supplied ) Before connec[...]

8 Side connections and controls If the red LED is unlit check that the mains plug is connected to the power supply . If the picture does not appear press a number button on the remote control, it may take a few moments. T o put the television into Standby press i on the remote control. T o view the television press i again. The picture may take a f[...]

9 T uning the television using Quick Setup, P rogramme sorting Before switching on the television put your decoder and media recorder to Standby if they are connected. T o set up the television use the buttons on the remote control as detailed on page 5. 1 2 3 5 6 7 8 9 4 Connect the television to the mains power . The Quick Setup screen will appea[...]

4 Press R to select System and use P or Q to change ( if required, see page 9 ). Then press R to select Search . Press P or Q to begin the search. The search symbol will flash. 10 Manual tune Press OK to select. If the programme is skipped, Programme skip must be removed before storing. The television can be tuned-in manually using Manual tuning . [...]

Manual tuning Prog. Sys. Channel Station 0 I C60 VCR 1 I C22 BBC1 2 I C28 BBC2 3 I C25 ITV 4 I C32 CH4 5 I C69 OK Select MENU Back EXIT Watch TV 11 Manual tune continued P rogramme skip Press MENU and repeat from Step 2 or press EXIT . Each programme position has to be individually selected. T o turn Programme skip off, repeat the procedure for eac[...]

12 Auto tune, general controls, time display , stereo/bilingual transmissions Using Auto tuning 1 2 3 4 T o set up the television using Auto tuning , press MENU and use S or R to select the SET UP menu. Y ou must allow the television to complete the search. When the search is complete the television will automatically select programme position 1. T[...]

13 Sound controls, WOW™ sound effects, dual, stable sound ® V olume Press j — ( S ) or j + ( R ) to adjust the volume. Sound Mute Press k once to turn the sound off and again to cancel. Bass Boost – to enhance the depth of sound Press n then S or R to adjust the effect. The difference will only be noticeable on sound with a strong bass. Pres[...]

14 Widescreen viewing SUPER LIVE This setting will enlarge the image to fit the screen by stretching the image horizontally , holding the correct proportions at the centre of the image. Some distortion may occur . SUBTITLE Depending on the type of broadcast being transmitted, programmes can be viewed in a number of formats. Press the { button repea[...]

SE T U P Picture position OK Quick Setup OK MENU Back EXIT Watch TV 2/2 15 Picture controls This television offers the choice of personalising the picture style. Press m to view the different styles available: Picture mode-1 to 3 are preset options and Picture mode-M stores your own settings: Use S or R to adjust the Contrast , Brightness , Colour [...]

FUNCTION T eletext Auto. Panel lock Off Auto format On Grey screen On Side Panel 1 MENU Back EXIT Watch TV 16 Picture controls continued In the Picture settings menu press Q until Colour T emperature is highlighted. Press S or R to select between Normal , Warm and Cool to suit your preference. 1 2 Colour T emperature increases the ‘warmth ’ or [...]

The Side Panel feature lightens or darkens the band each side of the screen when in 4:3 or 14:9 format. This helps prevent image retention of the band and can also make viewing in bright or dark conditions more comfortable. 17 Picture controls continued , panel lock, the timer Press Q to select On or Sleep timer . Use the number buttons to set the [...]

18 PC settings – picture position, clock phase, sampling clock, reset 3 3 Use S or R to adjust until the picture clears. In the SET UP menu press Q until PC Setting is highlighted. Press OK to select, then Q to highlight Clock phase . Use S or R to adjust until the picture clears. 1 2 The Clock phase matches the PC signal with the LCD display . A[...]

Input selection and A V connections 19 Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6 for a clear view of the back connection recommendations. Most media recorders and decoders send a signal through the SCART lead to switch the television to the correct Input socket. Alternatively press the e[...]

20 T ext services – setting up, general information, Auto and LIST modes This television has a multi-page text memory , which takes a few moments to load. It offers two Modes of viewing text – Auto will display Fastext , if available. LIST will store your four favourite pages. If Fastext is available four coloured titles will appear at the base[...]

Auto. Press T to access index pages. The one displayed is dependant on the broadcaster . LIST Press T to return to the page currently stored on the RED button. Remember to cancel te xt before changing channels – press the 6 / 7 button twice. ☛ 21 T ext services continued – control buttons Below is a guide to the functions of the remote contro[...]

Below are the answers to some of the most common queries. For more information go to www .toshiba.co.uk A Check the mains switch is on and check all connections. Check the television is not in standby mode. Why is there no sound or picture? Q A Check the volume has not been turned down or that sound mute has not been selected. Why is there a pictur[...]

23 Q uestions and A nswers continued A Good performance of text depends on a good strong broadcast signal. This normally requires a roof or loft aerial. If the text is unreadable or garbled, check the aerial. Go to the main index page of the text service and look for the User Guide . This will explain the basic operation of text in some detail. If [...]

Specifications and accessories Broadcast systems/channels P AL-I UHF UK21-UK69 P AL-B/G UHF E21-E69 VHF E2-E12, S1-S41 SECAM-L UHF F21-F69 VHF F1-F10, B- Q SECAM-D/K UHF R21-R69 VHF R1-R12 Video Input P AL, SECAM, NTSC 3.58/4.43 External connections EXT1 Input 21-pin SCART RGB, A/V EXT2 Input/Output 21-pin SCART A/V , S -video EXT3 Input (Side) 4 p[...]