TRENDnet TEG-224WSplus инструкция обслуживания

[...]

FCC Warning This equipment has been tes ted and found to comply with t he regulations for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limi t s are d esigned to pro vide re asonab le protectio n against harmful interference when the equipment i s operated in a commercial environment. This eq ui pment ge nerates, uses, and c[...]

i TABLE OF CONTENT About This Guide.... ............................................................................. 1 Purpose .............. ....................................... ....................................... 1 Terms/Us age ............................................. ...................................... . 1 Introductio n .........[...]

1 ABOUT THIS GUIDE Congratulations on your purchase of th e 26-Port 10/100/1000Mbps Gigabit Ethernet Web Smart Switch. This device integrates 10 00Mbp s Gigabit Ethernet, 100 Mbps Fast Ethernet and 10Mbps Ethernet network capabi litie s in a highly flexible pa ckage. Purpose This guide discusses how to install your 26-Port 10/100/1000Mbps Gigabit E[...]

3 INTRODUCTION This chapter describes the features of the 26-Port 10/100/1000Mbps Gigabit Ethernet Web Smar t Switch and some backgroun d information about Ethernet/Fast Ethernet /Gigabit Ethernet switching technology . Gigabit Ethernet Technology Gigabit Ethernet is an extension of IEEE 802.3 Ethernet uti lizing the same packet structure, format, [...]

5 Switching Technology Another approach to pushing beyond the limits of Ethernet technology is the development of switching technology. A switch bridges Ethernet packets at the MAC addre ss level of t he Ethernet protocol transmitti ng among connected Ethernet or Fast Ethernet LAN segm ent s. Switching is a cost-effective way of in creasing th e to[...]

7  Up to 8K unicast addresses entit ies per device, self-learnin g, and table aging  256Kbytes packet buffer  Supports IEEE 802.3x f low control for fu ll-duplex mode ports  Supports Back-pressure flow control for half-duplex mode ports  Supports Port-bas ed VLAN  Supports Port-bas ed QoS / IEEE 802.1 P ba sed QoS  Supports Por[...]

9 UNPACKING AND INSTALLATION This chapter provides unpacking and installation information for the Switch. Unpack in g Open the shipping car tons of th e Switch and carefully unpacks its contents. The carton should contain the following i tems:  One 26-Port 10/100/1000Mbps Gigabit Web Smart Switch  One Multi-La ngua ge Quick Inst a llation G u[...]

11 Connecting Network Ca ble The Switch supports 10Mbps Ethernet or 100Mbps Fast Ethernet and it runs both in half and full duplex m ode using two pair of Category 5 cable. The Switch also supports 2-Ports 1 000Mbps Gigabit Ethernet that runs in Auto-negotiation mode and 10Mbps Ethernet or 100Mbps Fast Ethernet that runs both in half and full duple[...]

13 IDENTIFYING EXTERNAL COMP ONENTS This chapter describes the front panel, rear panel, and LED indicators of th e Switch . Front Panel The figure below shows th e front panels of the Switch. Figure 3. Front panel o f 26-port Gi gabit Ethe rnet Switch LED Indicator: Comprehensive LED indicators displa y the status of the switch an d the network (se[...]

15 UNDERSTANDING LED INDICATORS The front panel LEDs provides instant status feedback, and, helps monitor and troubleshoot when needed. Figure 5. LED indicators of the Sw itch Power and System LEDs POWER: Power Indicator On : When the Power LED lights on , the Switch is receiving power. Off : When the Power turns off or the power co rd has im prope[...]

17 1000Mbps On : When the 1000Mbps L ED lights on, the respective port is conne cted to a 1000Mbps Gigabit Et hernet network. Off : When the respe ctive po rt is connecte d to a 10Mbps Ethernet o r 100Mbps Fast Ethernet network 100Mbps On : When the 100Mbps LED lights on , th e respective port is connected to a 100Mbps Fast Ethernet ne twork. Off :[...]

19 Figure 6. Web M anagement Utility The Web Management Utility was divided into four parts, Disco very List, Monitor List, Device Setting and Toolbar f unction , for deta ils instruction, follow the below section. Disc over y L ist This is the list where you can discover all the Web management devices in the entire network. By pressing the “Disc[...]

21 View Trap : The Tr ap function can receive the events that happen from the Web Management Swit ch in the Monitor List . There is a light indicator behind th e “View Trap” button , when the light indicates in green, it means that there is no trap transmitted, and else when it indicate s in red, it means that ther e is new trap transmitted, th[...]

23 Firmware Upgrade: When the device has a new function, there will be a new firmware to update the device, use this function to update. Figure 11. Web Access: Double click the device in th e Monitor List or select a device in the Monitor Lis t and press this “Web Access” button to access the device in Web browser. Tool bar The toolbar in the W[...]

25 Logi n Before you configure this device, note that when the Web Smart Switch is configured through an Ethernet connection, make sure the manager PC must be set on same the IP network . For example, when the default network address of the de fault IP address of the Web Smart Switch is 192.168.0.1 , then the m anager PC should be set at 192.168.0.[...]

27 Setup Menu When the main page appears, find the Setup me nu in th e left side of the screen (Figure 15). Clic k on the setup item that you want to configure. There are eleven options: Port Setti ngs, VLAN Settings, Trunk Setting, Mirror Setting, QoS Settin g, Device Status, System Settings, Trap Setting , Password Setting, Backup Setting and Res[...]

29 To change the port setting, click on the ID parameter to enter to the selected port to configure it s Spee d/Disable, F low control and Port Bandwidth Ra te Cont rol Ingr ess and Egr e s s. Figure 17. Speed/Disable: This setting has six modes— 100M Full , 100M Half , 10M Full , 10M Half, Auto and Disable —for speed or p ort disa ble selecti [...]

31 Trunk Setting The Trunk function enable s to cas cade two or more devices with a larger bandwidths. There are three Trunking groups to be set; and there are default ports in each member. Chec ked “Enable” to use the trunk fun ction, selec t the ports in each member to be trunk, and clic k “Apply” to activate the selected trunk group. Fig[...]

33 QoS Setting There are two selections in QoS setting, Port Based and IEEE 802.1p Based. Figure 22. Port Based: to set the Switch QoS b y port based, select the p orts which need to higher the quality by changing Normal to High. Figure 23. IEEE 80 2.1p Ba sed: to set the Switch QoS based on IEEE 80 2.1p, Figure 24. 34 Device Status Click on the ?[...]

35 System Setting The System Setting includes the System name, Location name, Login Timeout, IP Address, Sub net Ma sk and Gatew ay. Through the Web Management Utility, you can easily recognize the dev ice by using the System Name and the Location Name. The Login Timeout is to set the idle time-out for security issue, when there is no action wh en [...]

37 Set Passwo rd Password i s the inval uable tool for the mana ger to sec ure W eb Management Switch, use this function to change the pass word. If you forget the password, press th e “Reset” bu tton in the rear pane l of the Switch, the current setting in cludes VLAN, Po rt Setting… et c. will be lost and the Swi tch will restore to the def[...]

39 TECHNICAL SPECIFICATIONS General Standards IEEE 802.3 10Base-T IEEE 802.3u 100Base-TX IEEE 802.3ab 1000 Base-T IEEE 802.3z 1000Bas e-SX/LX (Mini-GBIC) IEEE 802.3x Full Duplex Flow Control Protocol CSMA/CD Data Transfer Rate Ethernet: 10Mbps ( half duplex), 20Mbps (f ull-duplex) Fast Ethernet: 100 Mbps (half duplex), 200Mbps (full-duplex) Gigabit[...]

41 Limited Warranty TRENDware warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. TEG-224WSplus – 5 Year Warranty If a product does not operate as warranted above during the applicable warranty period, TRENDware shall, at its option an d expe[...]

43 PERSON’S MISUSE, NEGLECT, IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED A TTEMPTS TO REPAIR O R MODIFY, OR ANY OTHER CA USE BEYOND THE RANG E OF THE INTENDED USE, OR BY ACCIDENT, FIRE, LIGHTNING, OR OTHER HAZARD. LIMITATION OF LIABILITY: TO THE FULL EXTEN T ALLOWED BY LAW TRE NDWARE ALSO EXCLUDES FOR ITSELF AN D ITS SUPPLIERS AN Y LIABILITY, [...]