Ultra Start 45xx Series инструкция обслуживания

-The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for accidental starting of the vehicle. - CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc..[...]

Page 2 This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved[...]

2WAY R EMOTE ST ARTER/ ALARM OWNER ’S GUIDE Page 3 R emote Star t - A u t o m a t i c T r a n s m i s s i o n 1. Press and release button #3. 2. The park light s will flash and the siren will chirp one time. 3. The vehicle will then remote start. The p ark light s will flash four times then remain on while the vehicle is running. The run timer on[...]

Page 4 Idle Mode 1. While the vehicle is running with key , press button #3 . 2. The park light s will turn on and the siren will chirp once. 3. T urn the ignition key off and the vehicle will continue to run. 4. Exit the vehicle and leave it running safely without leaving the keys in the Ignition. Note: Always lock the doors while the vehicle is l[...]

Manual transmission remote st arters must be set into Reservation Mode before the remote st arter will activate. There are two different ways to place the system into Reservation Mode. The activation type of Reservation Mode is determined when the system is inst alled. The default setting is Auto Reservation Mode. Auto Reservation Mode St ep 1 - Wh[...]

Page 6 1. Press and hold button #2 and the doors will unlock, continue holding button #2, the trunk release will activate. The trunk release will be confirmed by one park light flash and one siren chirp. Note: The trunk release output will not activate when the ignition key is in the “On” position. 1.Press and release button #1 on the remote tr[...]

Page 7 Car Finder is a feature that can be used to find your vehicle in a crowded parking lot. 1. Press and release button #4 twice within 3 seconds. 2. The park light s will flash and the siren will chirp five times to draw attention to the location of the vehicle. 3. The remote will beep and display the systems current status. Car Finder Mode Act[...]

Page 8 Auxiliary Output 1 (Optional) Sir en On/Of f Auxiliary Output 2 (Optional) Auxiliary Output are optional output s from the system. These output s Can be used to activate such things as power window roll-up/ down modules or to open and close a power sun roof. T o Activate Auxiliary # 1 1. Press and hold buttons #1 and #3. 2. The park light s [...]

Page 9 Cold S tart Mode will st art the vehicle at a user selectable st art interval or temperature setting. The vehicle can be set to start once every 1, 2, 3 or 4 hours in T imer Mode or to st art at 0,-5,-15 or -25 Celsius in T emperature Mode (L T Models Only) for a maximum 12 start s. The vehicle will start at the selected st art interval/ tem[...]

Page 10 KEY ICON- This icon will begin to flash when the remote st arter button is first pressed. Af ter the vehicle has st arted this icon will stay on solid. SIREN ICON- This icon indicates that the alarm has been triggered. The remote will st art to beep and the siren icon will come on solid at the same time as the icon for the violated zone. AN[...]

Page 1 1 TIMER ICON- When this icon is displayed in the left program column if confirms that the T imer Mode has been programmed ON. When this icon is turned on in remote program mode the Cold S t art feature will be activated. Cold S t art will default to the last time or temperature setting. KEY ICON- When this icon is displayed the remote starte[...]

Page 12 1 2 3 4 1 2 3 4 1st 2nd This feature can be used if the vehicle is p arked in an area with above average noise or vibrations. (Airport s, construction zone...) T o T emporally Byp ass The Shock Press the button #1 to arm the alarm then press button #3 within three seconds. The system will chirp once when the lock button is pressed and once [...]

Page 13 1) Press and hold buttons #1 and #4 until the minute portion of the clock begins to flash. 2) T o set the minute, press button #3 to increase and button #2 to decrease the minute. 3) T o set the hour , press button #1 and the hour portion of the clock will begin to flash. 4) T o set the hour , press button #3 to increase and button #2 to de[...]

Page 14 A TTENTION: T O A VOID SERIOUS INJUR Y , this remote st art system must be set into Service Mode before any under hood servicing is st arted. Service Mode will prevent the vehicle from st arting while the vehicle is being serviced. It is the sole responsibility of the vehicle’ s owner to place the system into Service Mode. The manufacture[...]

Page 15 Being that the installer does not always see when the system shut s down or fails to start, Diagnostic Memory will store in memory up to four shut down codes. This information can then be accessed to determine the source of the shut down. T o Enter Diagnostic Mode: St ep 1 - T urn the ignition on then off. Press the Program Button and relea[...]

Limited Lif etime W ar r anty The manufacturer warrants to the original purchaser of their remote starters and alarms, that the product shall be free from defects in material and workmanship. However , should this product be proven to be defective, within a two year period from the original date of purchase, the manufacturer will, without charge to[...]