Whirlpool W10130752A инструкция обслуживания

To the installer: Please leave this instruction book with the unit. To the consumer: Please r ead and keep this book for future r eference. INST ALLA TION INSTRUCTIONS 30" (76.2 CM) FREEST ANDING GAS RANGE with standard clean oven W10130752A T able of Contents..................................................2[...]

2 You can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don't follow All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. Your safety and the safety of others ar[...]

3 WA R N I NG: If the information in this man ual is not follo wed exactl y , a fire or explosion may result causing pr oper ty damage, personal injury or death. – Do not store or use gasoline or other flammable vapor s and liquids in the vicinity of this or any other appliance. – WHA T T O DO IF Y OU SMELL GAS: • Do not tr y to light any app[...]

4 INST ALLA TION REQUIREMENTS T ools and P arts Gather the requir ed tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. T ools needed Parts supplied Check that all parts are included. ■ Anti-tip brackets must be securely mounted to subfloor . Thickness of flooring may requir e longe[...]

Installation Clearances Cabinet opening dimensions shown are for 25" (64 cm) counter- top depth, 24" (61 cm) base cabinet depth and 36" (91.4 cm) countertop height. If the cabinet depth is greater than 24" (61 cm), the oven frame must extend beyond cabinet fronts by ¹⁄₂ " (13 mm) minimum. NOTE: 24" (61 cm) minimum[...]

Gas Supply Requirements Observe all governing codes and ordinances. IMPORT ANT : This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1 - latest edition. T ype of Gas Natural Gas: This range is design-certified b[...]

7 †®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company . Flexible metal appliance connector: ■ If local codes permit, a new CSA design-certified, 4-5 ft (122-152.4 cm) long, ¹⁄₂ " (1.3 cm) or ³⁄₄ " (1.9 cm) I.D., flexible metal appliance connector may be used for connecting range to the gas supply line.[...]

8 INST ALLA TION INSTRUCTIONS Unpack Range 1. Do not use oven door handle to lift or move the range. 2. Remove shipping materials, tape and protective film fr om range. Keep cardboar d bottom under range. Remove oven racks and parts package from inside oven. 3. T ake 4 cardboard corners from the carton. Stack one car d- board corner on top of anoth[...]

9 Ve r ify Anti-T ip Bracket Location 1. Make sure the anti-tip bracket is installed: ■ Look for the anti-tip bracket securely attached to the floor . ■ Slide the range back so the rear range foot is under the anti-tip bracket. 2. If installing the range in a mobile home, you must secure the range to the floor . Any method of securing the range[...]

10 Check Operation Electronic Ignition System Cooktop and oven burners use electronic ignitors in place of standing pilots. When a cooktop control knob is turned to the “LITE” position, the system creates a spark to light the burner . This sparking continues until the control knob is turned to the desired setting. When the oven control is turne[...]

11 5. Tu rn the oven back on and check for proper flame. If the flame is still not properly adjusted, turn the oven off, wait for the oven burner to cool down and repeat step 4 until flame is properly adjusted. 6. When the flame has been properly adjusted, turn the oven off, wait for the burner to cool down. 7. Tighten the shutter screw . 8. Reinst[...]

12 2. Unplug or disconnect power . 3. Open broiler door and r emove broiler pan. The gas pr essure r egulator is located in the back right hand corner of the broiler compartment. IMPORT ANT : Do not remove the gas pr essure r egulator . NO TE: Do not remove the spring beneath the cap. 4. Remove the cap from the gas pr essure r egulator using a flat[...]

2. Locate LP gas orifice spuds for top burners in the bag con- taining literature included with the range. Thr ee L P gas spuds are stamped “88” and one “96.” 3. Remove natural gas orifice spuds using a 7mm combination wrench. 4. Install L P gas orifice spuds. NOTE: Depending on model, the range cooktop may be equipped with 4 standard burne[...]

14 5. Tu rn the cap over so that N or NA T is visible. 6. Reinstall the cap. To Con vert Surface Burners 1. Remove burner grates, bur ner caps, and burners. 2. Locate the natural gas orifice spuds for the top burners in the bag containing literature included with the range. Thr ee natural gas spuds are stamped “149” and one “165.” 3. Remove[...]

15 4. Install natural gas orifice spuds. NOTE: Depending on model, the range cooktop may be equipped with 4 standard burners or 3 standard burners and 1 power burner . Spud size/location remain the same. 5. Place L P gas orifice spuds in the plastic parts bag for future use and keep with the bag containing literature. 6. Reinstall burners, bur ner [...]

W10130752A ©2007 Whirlpool Cor poration All rights reser ved. Printed in Mexico 03/2007[...]