Wolf Pro Wall инструкция обслуживания

I NST ALLA TION I NSTR UCTIONS P RO W ALL C HIMNEY V ENTILA TION H OODS READ AND SA VE THESE INSTRUCTIONS[...]

As you follow these instructions, you will notice W ARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Wolf equip- ment. There are two types of potential hazards that may occur during installation. Another footnote we would like to identify is IMPORT ANT NOTE: This highlights informa- tion t[...]

3 W OLF PRO W ALL CHIMNEY VENTILA TION HOODS Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION REQUIREMENTS IMPORT ANT NOTE: This installation must be completed by a qualified installer or W olf authorized service center technician. Installer: Please read the entire Installation Instructions prior to installati[...]

4 W OLF PRO W ALL CHIMNEY VENTILA TION HOODS LIST OF MA TERIALS The following is a list of materials shipped with the W olf Pro wall chimney hood. Stainless steel wall chimney hood T ransition with backdraft damper — attached inside hood (needs to be removed) Decorative stainless steel rail and installa- tion components — (R) model hoods only T[...]

5 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS ELECTRICAL REQUIREMENTS W olf Pro wall chimney ventilation hoods require a separate, grounded 110 / 120 V AC, 60 Hz power supply . The service should have its own 15 amp circuit breaker . Locate the electrical supply through the top of the hood as[...]

6 W OLF PRO W ALL CHIMNEY VENTILA TION HOODS INST ALLA TION SPECIFICA TIONS The illustration and chart below provides dimensions specific to each Pro wall chimney hood model. These dimensions are critical for proper installation. Pro Wall Chimney Hoods Model (A) (B) (C) (D) PWC362418(R) 36" (914) 18" (457) 7" (178) 9" (228) PWC4[...]

7 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS DUCTWORK INST ALLA TION THROUGH ROOF 24" (610) DEPTH OF HOOD ROOF CAP OR REMO TE BLOWER 10" (254) ROUND DUCT SOFFIT OR CABINET OR DUCT CO VER NOTE: VERTICAL DISCHARGE ONL Y FOR PRO WALL CHIMNEY HOODS . VERTICAL DISCHARGE TRANSITION 14&qu[...]

Existing W all Studs 2 x 4 Bloc king Back of W all Hood Outline 2" (51) 14" (356) 16" (406) 16¾" (425) Wood Mounting Strip 8 W ALL FRAMING IMPORT ANT NOTE: There must be a minimum 10" (254) opening in the ceiling to accommodate the ductwork necessary for proper ventilation. Layout the dimensions of the back of the wall chi[...]

9 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS HOOD PREP ARA TION Follow these steps to prepare the wall chimney hood for installation: Remove the filters by pressing up at the angle the filters are placed in, then rotate the bottom of the filter down. Gloves should be worn to provide proper g[...]

10 W OLF PRO W ALL CHIMNEY VENTILA TION HOODS A CCESSORIES Optional acces- sories are available through your Wolf dealer . T o obtain local dealer information, visit the Locator section of our website, wolfappliance.com. DUCT CO VER INST ALLA TION Option a l D u ct Cov er Mo u nting S crew s Duct cover installation Installing a duct cover assembly [...]

11 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS HOOD INST ALLA TION IMPORT ANT NOTE: If an optional duct cover is to be used with the Pro wall chimney hood, it must be installed before installing the hood — except for the 36" (914) and 42" (1067) wide hoods with an internal blower [...]

12 W OLF PRO W ALL CHIMNEY VENTILA TION HOODS Do not remove the control knob bezel to access hood wiring; this will damage the bezel assembly . Location of wiring IMPOR T ANT NO TE Y ou must follow all National Electrical Code regulations. In addition, be aware of local codes and ordinances when installing your service. INST ALL WIRING Risk of elec[...]

13 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS INST ALL WIRING IN-LINE OR REMO TE BLOWER WIRING Remove the hood electrical box cover . Run power cable to the installation location. Insert the power cable into the electrical box by running it through the wire clamp previously installed. T ight[...]

14 W OLF PRO W ALL CHIMNEY VENTILA TION HOODS FIL TER INST ALLA TION Follow these instructions to install filters and grease cups for W olf Pro wall chimney hoods: Reinstall the internal frame. Refer to Hood Preparation on page 9. Remove all packaging material from the filters and grease cups. Slide the grease cups along the bottom edge of the hood[...]

15 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS Thre a ded S t u d s T op of Hood Intern a l Blower Hex He a d N u t s Pow e r Cord Thre a ded S t u d s T op of Hood Intern a l Blower Hex He a d N u t s Pow e r Cord s CTBLOWER-60INT Threaded Studs T op of Hood Internal Blower Hex Head Nuts P o[...]

Be sure that there is enough space for any transitions that may be needed between the blower and the connecting ductwork. For best performance, locate transitions nearest the blower . Refer to the illustrations below and on the following page for overall dimensions of W olf in-line and remote blowers. Also refer to the specific installation instruc[...]

17 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION INSTRUCTIONS BLO WER ASSEMBLIES W olf Pro wall chimney ventilation hoods are shipped without the blower assembly . Wolf internal, in-line and remote blower assemblies are available as sales accessories through your W olf dealer . IMPORT ANT NOTE: Blower optio[...]

18 W OLF PRO W ALL CHIMNEY VENTILA TION HOODS The information and images are the copyright property of Wolf Appliance, Inc., an affiliate of Sub-Zero, Inc. Neither this book nor any information or images contained herein may be copied or used in whole or in part without the express written permission of Wolf Appliance, Inc., an affiliate of Sub-Zer[...]

19 CUT -OUT FOR LOGO PLACEMENT BO TT OM EDGE OF HOOD FOLD LINE FOR LOGO PLACEMENT LEFT OUTER EDGE OF HOOD[...]

810482 6 / 2007 WOLF APPLIANCE, INC. P . O . BO X 44848 MADISON, WI 53744 800-332-9513 WOLF APPLIANCE.COM[...]