Yamaha CX-1 инструкция обслуживания

CX-1 CX-2 OWNER’S MANUAL CONTENTS Safety Instructions ..................... 2 Features ................................... 3 Supplied Accessories ................ 3 Connections ............................. 4 Operations ............................... 7 Remote Control T ransmitter ...... 11 Specifications ......................... 16 T roubleshoo[...]

2 7 Wall or Ceiling Mounting – The unit should be mounted to a wall or ceiling only as recommended by the manufacturer. 8 Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, the unit should not be situated on a bed, sofa, rug, or similar surface, that may block [...]

3 Caution: Read this bef ore operating your unit 1 To ensure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2 Install your unit in a cool, dry, clean place – away from windows, heat sources, and too much vibration, dust, moisture or cold. Avoid sources of hum (transformers, motors). To pre[...]

4 CONNECTIONS ● Before attempting to make any connections to or from this unit, be sure to first switch OFF the power to this unit and to any other components to which connections are being made. ● When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left) to L , R (right)[...]

5 < CX-2 > * : Refer to “ ABOUT THE ACCESSORY COMPONENTS ON THE REAR PANEL ” on page 6. AC OUTLETS REMOTE CONTROL L R L L R R L R MC/MM PHONO POWER AMP GND TAPE 1 TAPE 2 LD IN CD TUNER PB REC OUT PB REC OUT PB REC OUT PB REC OUT 200W MAX. TOTAL SWITCHED I20V 60Hz I.7A MAX. TOTAL VCR 1 VCR 2 VCR 1 VIDEO SIGNAL AUDIO SIGNAL VCR 2 MON OUT PR[...]

6 If your video cassette recorder, LD player, etc. and your monitor are equipped with “S” (high-resolution) video terminals, connect them to this unit’s S video terminals, and connect this unit’s S MON OUT terminal to the “S” video input of your monitor. Otherwise, connect the composite video terminals from your video cassette recorder,[...]

7 OPERA TIONS T O PLA Y A SOURCE 1 Set to the “ ∞ ” position. 2 3 Select a desired input source. * If you select turntable as an input source (PHONO position), you should confirm that the PHONO switch on the rear panel is set to the position corresponding to the type of cartridge being used by the turntable. (Refer to page 6.) 4 Play the sour[...]

Notes ● If you want to enjoy another source while recording, select it with the INPUT selector. ● LOUDNESS (for CX-2 only), BASS , TREBLE , BALANCE , VOLUME controls and PURE DIRECT switch settings have no effect on the material being recorded. T O RECORD A SOURCE T O T APE (OR DUB FROM A T APE T O ANO THER) 1 Select the source to be recorded. [...]

9 REC OUT selector setting on tape dubbing < CX-1 >< CX-2 > To dub from tape deck 1 to tape deck 2 or 3 (or both tape deck 2 and 3 at the same time) To dub from tape deck 2 to tape deck 1 or 3 (or both tape deck 1 and 3 at the same time) To dub from tape deck 3 to tape deck 1 or 2 (or both tape deck 1 and 2 at the same time) OPEN/CLOSE [...]

10 When y ou listen with headphones When listening with headphones privately, connect the headphones to the PHONES jack. Sounds from the speakers are cut off. Adjusting the B ASS and TREBLE controls Adjusting the B ALANCE control Adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused from spe[...]

11 REMO TE CONTROL TRANSMITTER NO TES ABOUT THE REMO TE CONTR OL TRANSMITTER Battery installation < CX-1 > < CX-2 > (Australia, U.K. and Europe models) < CX-2 > (U.S.A., Canada and General models) Battery replacement If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Repla[...]

12 < CX-1 > < CX-2 > (A ustralia, U .K. and Europe Models) < CX-2 > (U .S.A., Canada and General models) * When you operate this unit and/or other YAMAHA components with this remote control transmitter, set the YPC-USER-LEARN switch to the YPC (Yamaha Preset Code) position. The remote control transmitter provided with this unit is[...]

13 For Other Component Contr ol Identify the remote control transmitter keys with your component’s keys. If these keys are identical, their function will be the same. On each key function, refer to the corresponding instruction on your component’s manual. ➊ Tuner keys Controls tuner + : Selects higher preset station number. – : Selects lowe[...]

14 REMO TE CONTR OL “LEARNING” FUNCTION (U .S.A., Canada and General models of CX-2 only) The keys on this remote control transmitter can be programmed to “learn” key-functions from other remote control transmitters without losing the preset key functions. By using this feature, this unit can then be used in place of one or more other remot[...]

15 1 Set to the “ LEARN ” position. 2 Press a key on this unit where a new function will be learned. 3 Press and hold the key (on the other remote control transmitter) where the desired new function is. * When the TRANSMIT/LEARN indicator stops illuminating, the learning is finished. 4 Repeat step 2 and 3 until all desired functions are success[...]

16 1 Set to the “ USER ” position. 2 Press and hold the CLEAR button using the point of a mechanical pencil, etc. 3 Press and hold the key where the learned function to be deleted is until the indicator flashes 3 times. To clear two or more functions, repeat step 2 and 3. Note If a key is not pressed soon after the CLEAR button is pressed, this[...]

17 Power Supply [U.S.A. and Canada models] ............................................AC 120V, 60 Hz [Australia and U.K. models] ............................................AC 240V, 50 Hz [Europe model] ....................AC 230V, 50 Hz [General model] ..................AC 110/120/220/240V, 50/60 Hz Power Consumption .............................[...]

18 SYMPTOM The unit fails to turn on when the POWER switch is pressed. No sound or no picture. Only one side speaker outputs the sound. Sound “hums”. Sound level is low. The sound from the MC cartridge is too low Using the BASS, TREBLE, BALANCE and LOUDNESS (for CX-2 only) controls does not affect the tone. The remote control transmitter does n[...]

YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A. YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA YAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, D-2084 RELLINGEN BEI HAMBURG, F.R. OF GERMANY YAMAHA ELECTRONIQUE FRANCE S.A. 17 RUE DES CAMPANULES, LOGNES 77321 MARNE LA VA[...]