Yamaha RX-V300K инструкция обслуживания

O WNER’S MANU AL Natural Sound A V Receiver R X- V300K Thank you f or selecting this Y AMAHA A V receiv er . R[...]

1 Read Instructions – All the safety and operating instructions should be read before the unit is operated. 2 Retain Instructions – The safety and operating instructions should be retained for future reference. 3 Heed Warnings – All warnings on the unit and in the operating instructions should be adhered to. 4 Follow Instructions – All oper[...]

1 English Note to CATV system installer: This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practica[...]

2 Saf ety Instructions ............... Inside the Front Cover Supplied Accessories ......................................2 F eatures ..........................................................3 Caution ............................................................4 Profile of This Unit ...........................................5 Speaker Setup .......[...]

3 English ● 5 Speaker Configuration < U .S.A. model > Main: 60W + 60W (8 Ω ) RMS Output P ower , 0.04% THD , 20–20,000 Hz Center: 60W (8 Ω ) RMS Output P ower , 0.1% THD , 1 kHz Rear: 20W (8 Ω ) RMS Output P ower , 0.7% THD , 1 kHz < Singapore and General models > Main: 55W + 55W (8 Ω ) RMS Output P ower , 0.04% THD, 20–20[...]

4 1. To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2. Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, d[...]

5 English PR OFILE OF THIS UNIT You are the proud owner of a Yamaha AV receiver — an extremely sophisticated audio component. The Digital Sound Field Processor (DSP) built into this unit takes advantage of Yamaha’s undisputed leadership in the field of digital audio processing to bring you a whole new world of listening experiences. Follow the [...]

6 SPEAKER SETUP SPEAKERS T O BE USED This unit is designed to provide the best sound-field quality with a 5 speaker configuration. The most effective speakers to use with this unit are main speakers, rear speakers and a center speaker. You can use one rear speaker only instead of using two rear speakers, and omit the center speaker. (Refer to the ?[...]

7 English CONNECTIONS Never plug in this unit and other components until all connections are completed. CONNECTIONS WITH O THER COMPONENTS When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left) to L , R (right) to R , “ + ” to “ + ” and “ – ” to “ – ”. [...]

8 CONNECTING SPEAKERS REAR REAR CENTER CAUTION SEE INSTRUCTION MANUAL FOR CORRECT SETTING. MAIN SPEAKERS A B REAR SINGLE SINGLE:6 Ω MIN. /SPEAKER :3 Ω MIN. /SPEAKER :6 Ω MIN. /SPEAKER A OR B:4 Ω MIN. /SPEAKER A B:8 Ω MIN. /SPEAKER IMPEDANCE SELECTOR SET BEFORE POWER ON REAR REAR CENTER MAIN SINGLE:8 Ω MIN. /SPEAKER :4 Ω MIN. /SPEAKER [...]

9 English For connecting to the MAIN SPEAKERS terminals Red: positive (+) Black: negative (–) ➀ Unscrew the knob. ➁ Insert the bare wire. [Remove approx. 5mm (1/4”) insulation from the speaker wires.] ➂ Tighten the knob and secure the wire. Banana Plug connections are also possible (except Singapore model). Simply insert the Banana Plug c[...]

10 Be sure to switch this only when the power of this unit is turned off. Select the position whose requirements your speaker system meets. WARNING Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged. IF THIS UNIT FAILS TO TURN ON WHEN THE POWER SWITCH IS PRESSED The IMPEDANCE S[...]

11 English ANTENNA CONNECTIONS ● Each antenna should be connected to the designated terminals correctly, referring to the following diagram. ● Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal strength. Nevertheless, a properly installed outdoor antenna will give clear[...]

12 CONTR OLS AND THEIR FUNCTIONS FR ONT P ANEL POWER SPEAKERS PHONES A ON B OFF BASS TREBLE BALANCE VOLUME 55 4 3 2 l 0 l 2 3 4 55 4 3 2 l 0 l 2 3 4 LR l6 20 28 40 60 l2 8 4 2 0 –dB 55 4 3 2 l 0 l 2 3 4 FM / AM MAN'L / AUTO FM TUNING MODE AUTO / MAN’L MONO ONE TOUCH KARAOKE DOWN TUNING UP VOCAL AID MEMORY EDIT KEY CONTROL A / B / C / D / E[...]

13 English B PHONES jack When you listen with headphones, connect the headphones to the PHONES jack. You can listen to the sound to be output from the main speakers through headphones. When listening with headphones privately, set both the SPEAKERS A and B switches to the OFF position and switch off the digital sound field processor by pressing the[...]

For Contr ol of This Unit 1 DELAY/KEY and TIME/KEY – ( )/+ ( ) keys Adjust the delay time (DELAY) and key level of the currently playing tune (KEY). Select the item which you want to adjust by pressing the DELAY/KEY key and adjust its time or level by pressing the TIME/KEY – ( )/+ ( ) key. * The key level cannot be changed when a normal DSP pro[...]

15 English Notes about the remote contr ol transmitter Battery installation Battery replacement If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes ● Use only AA, R6, UM-3 batteries for replacement. ● Be sure the polarities are correct. (See th[...]

16 DISPLA Y P ANEL PRESET kHz MHz MEMORY AUTO TAPE MON STER EO 0 20 l00 ms PRO LOGIC 3 STEREO HALL VOCAL AID LIVE HOUSE ONE TOUCH KARAOKE SLEEP NORMAL WIDE PHANTOM EFFECT OFF 12 3 5 6 9 B 0A 78 4 1 Multi-information display Displays various information, for example station frequency, preset station number and name of selected input source. 2 STEREO[...]

17 English 1 Set to the “ ∞ ” position. 2 Turn the power on. 3 Select the main speakers to be used. * If you use two main speaker systems, press both the A and B switches. 4 Set to the “0” position. 5 6 Select the center channel output mode suitable for your speaker configuration. (Refer to “ SPEAKER CONFIGURATION ” on page 6.) On the[...]

7 Turn up the volume. You will hear a test tone (like pink noise) from the left main speaker, then the center speaker, then the right main speaker, and then the rear speakers, for about two seconds each. The display changes as shown below. * The test tone from the left rear speaker and the right rear speaker will be heard at the same time. 8 Adjust[...]

19 English 1 Set to the “ ∞ ” position. 2 Turn the power on. 3 Select the desired input source by using the input selector buttons. (For video sources, turn the TV/monitor ON.) * The name of the selected input source will appear on the display. 4 Select the main speakers to be used. * If you use two main speaker systems, press both the A and [...]

20 1 Select the source to be recorded. 2 Play the source and then turn the VOLUME control up to confirm the input source. (For detailed information on the tuning operations, refer to the page 22.) 3 Begin recording on the tape deck (or MD recorder etc.) or VCR connected to this unit. 4 If the tape deck (or MD recorder etc.) is used for recording, y[...]

21 English Selecting the SPEAKER system Because one or two speaker systems (as main speakers) can be connected to this unit, the SPEAKERS switches allow you to select speaker system A or B , or both at once. Adjusting the B ALANCE contr ol Adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance cause[...]

22 1 Select “TUNER” as the input source. 2 Select the reception band (FM or AM) confirming it on the display. 3 4 Tune to a desired station manually. * To continue tuning search, press and hold the button. 1 Select “TUNER” as the input source. 2 Select the reception band (FM or AM) confirming it on the display. 3 4 To tune to a higher frequ[...]

23 English 1 Tune to a desired station. (Refer to the previous page for tuning procedure.) 2 Select a desired group (A – E) of preset stations confirming it on the display. 3 4 Select a preset station number where you want to program the station before “MEMORY” goes off from the display. * In the same way, program other stations to A2, A3 ...[...]

24 1 2 3 To tune to higher frequencies, press right side once. To tune to lower frequencies, press left side once. * If the TUNING button is not pressed, in a while, the automatic preset tuning begins automatically toward higher frequencies. The automatic preset tuning begins from the frequency currently displayed. Received stations are programmed [...]

25 English EXCHANGING PRESET ST A TIONS You can exchange the places of two preset stations with each other as shown below. Example) If you want to shift the preset station on E1 to A5, and vice versa. 1 Recall the preset station on E1 (by following the method of “To recall a preset station” on page 23). 2 3 Next, recall the preset station on A5[...]

26 FEATURE This program is used for playback of sources encoded with Dolby Surround. The application of a sophisticated digital signal processing system reduces crosstalk and directs or steers the sound source more smoothly and precisely, as compared to conventional types. This program is effective not only for playback of sources encoded with Dolb[...]

27 English 1 Follow steps 1 – 6 shown in “ BASIC OPERATIONS ” on page 19. 2 Select the desired program that is suitable for the source. The selected program name is shown on the display. 3 If desired, adjust the delay time and the output level of each speaker. (For details, refer to the corresponding descriptions on page 28.) Notes ● If you[...]

28 Adjustment of the CENTER LEVEL Adjustment of the REAR LEVEL If desired, you can adjust the sound output level of the center speaker even if the output level is already set in “ SPEAKER BALANCE ADJUSTMENT ” on page 18. Note This adjustment is useful only when the digital sound field program DOLBY PRO LOGIC or DOLBY 3 STEREO is selected. If de[...]

1 Connect one or two microphones to the MIC jack(s) on the front panel. 2 Follow steps 1 to 7 of “ BASIC OPERATIONS ” on page 19. 3 Select a desired DSP program for Karaoke ( BALLAD , POPS , JAZZ or ROCK ) or turn the DSP off (so that no DSP program is selected). 4 If you play a normal music source with vocals or a multisound source for Karaoke[...]

Turning the MIC LEVEL control clockwise increases the level, and counterclockwise decreases the level. Turning the ECHO level control clockwise increases the level, and counterclockwise decreases the level. If you need no echo effect, set this control to the “MIN” position. The following functions are useful when you sing Karaoke by using a nor[...]

31 English Adjusting key of the tune currentl y pla ying Recor ding your v ocal mixed with the sour ce onto a tape (adding effects of a selected DSP pr ogram for Karaoke and other Karaoke functions) Pressing the KEY CONTROL button changes key of the tune currently playing. The current key level is shown on the display. Whenever a tune changes, its [...]

32 1 Whenever the SLEEP key is pressed, the SLEEP time will change as follows. After a while, the display returns to the indication before the SLEEP timer is set. 2 The unit will be turned off automatically at the selected SLEEP time. SETTING THE SLEEP TIMER If you use the SLEEP timer of this unit, you can make this unit turn off automatically. Whe[...]

33 English If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help. General FM AM R[...]

34 AUDIO SECTION Minimum RMS Output Power per Channel Main L, R 8 ohms, 20 Hz to 20 kHz, 0.04% THD [U.S.A. model] ..........................60W + 60W [Singapore and General models] .................................................55W + 55W Center 8 ohms, 1 kHz, 0.1% THD [U.S.A. model] .....................................60W [Singapore and General [...]

35 English AM SECTION Tuning Range [U.S.A. and General models] .............................................530 to 1,710 kHz [ Singapore model] ...............531 to 1,611 kHz Usable Sensitivity .............................100 µ V/m Selectivity ...............................................32 dB Signal-to-Noise Ratio ............................[...]

VY88670 Y AMAHA ELECTRONICS CORPORA TION, USA 6660 ORANGETHORPE AVE., BUENA P ARK, CALIF . 90620, U.S.A. Y AMAHA CANADA MUSIC L TD. 135 MILNER A VE., SCARBOROUGH, ONT ARIO M1S 3R1, CANADA Y AMAHA ELECTRONIK EUROP A G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F .R. OF GERMANY Y AMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZA T BP70 C[...]