Zanussi DA 4342 инструкция обслуживания

INST R UCTION BOOK 152977 35/2 UK DISHW ASHER D A 4342[...]

2 The control panel Description of the appliance 1. W ater hardness adjustment 2. Levelling spacers 3. Upper basket stop 4. Upper spray arm 5. Salt container 6. Detergent dispenser 7. Control panel 8. Rinse aid dispenser 9. Filters 10. Lower spray arm 11 . Upper basket 12. Worktop IN115 1. ON-OFF indicator light 2. ON-OFF push button 3. ECONOMY 50?[...]

3 T ype of load Degree of soil Starting position of the programme selector dial Required push button Recommended quantity of detergent wash prewash Cycle description W ashing programmes INTENSIVE 65°C * ECONOMY 50°C NORMAL 65°C RINSE & HOLD Cold prewash Main wash up to 65°C 1 cold rinse 1 hot rinse Active drying Cold prewash Main wash up to[...]

4 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning" - Instruction book part 1). 2. Check that there is rinse aid and salt (See "Instruction book - part 1") 3. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. [...]

5 Loading your appliance Before placing dishes in the machine, remove any scraps of food, to avoid clogging the filters and consequently reducing the performance. Do not load very small items which can fall through the baskets. The lower basket The lower basket is designed to take saucepans, lids, plates, salad bowls, cutlery etc. Serving dishes an[...]

6 The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items so that water can reach all surfaces. Light items (plastic bowls etc.) should be loaded in the upper basket and arranged so they do not move. Before closing the door , ensure th[...]

7 Adjusting the worktop Y ou can move the worktop forward or backward by 25 mm in order to align the machine with other kitchen units. Simply unscrew the two front retaining screws, move the top to the required position and then retighten the screws. Fitting under a counter (kitchen worktop or sink) By removing the machine’s worktop, you can inst[...]

Service and spare parts In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Zanussi Service Centre by telephoning: 08705 929 929 Y our telephone call will be automatically routed to the Service Force centre covering your post code area. The addresses are listed on the following pages. B[...]

Service and spare parts In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Zanussi Service Centre by telephoning: 08705 929 929 Y our telephone call will be automatically routed to the Service Force centre covering your post code area. The addresses are listed on the following pages. B[...]

From the Electrolux Group. The world’ s No.1 choice. The Electrolux Group is the world’ s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. 14 billion U[...]

Instruction Book - Before use - Maintenance - Installation 1 Contents Important safety information 2 Before use 3 Setting the water softener 3 Filling with salt 4 Filling with rinse aid and adjusting the dose 5 Use of detergent 6 Hints and tips 7 Maintenance and cleaning 8 Internal cleaning 8 Cleaning the filters 8 External cleaning 8 Prolonged per[...]

Installation ● This appliance is heavy . Care should be taken when moving it. ● It is dangerous to alter the specifications or attempt to modify this product in any way . ● Care must be taken to ensure that the appliance does not stand on the electrical supply cable. ● Any electrical work required to install this appliance should be carried[...]

3 Before use Before using your dishwasher for the first time: 1. Ensure that the electrical and water connections comply with the installation instructions 2. Remove all packaging from inside the appliance 3. Set the water softener 4. Pour 1 litre of water inside the salt container and then fill with salt 5. Fill the rinse aid dispenser . Setting t[...]

4 Filling with salt Attention! Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in dishwasher , especially table salt, will damage the water softener . Only fill with salt just before starting a washing programme. This will prevent any grains of salt or salty water , which may hav[...]

5 Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser , which is positioned inside the door , holds about 1 10 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. Filling with rinse aid 1. Open the containe[...]

6 Use of detergent Only use detergents specifically designed for use in dishwashers. We recommend the use of Finish detergents which are available in the following options: Finish Double Action T ablets. Each tablet has the exact amount of detergent required, simply place in the dispenser . Finish Powder recommended for every day use. Finish Liquid[...]

7 T o save energy Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. If necessary run the Rinse and Hold programme (see "W ashing Programmes" chart) so that any food scraps do not become caked on the dishes while you are waiting to run the complete wash programme. Do not prewash [...]

8 Internal cleaning Ensure that the seals around the door , the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend the use of Finish Dishwasher Cleaner every 3 months or run a 65°C wash without dishes using detergent. Regular use of Finish Dishwasher Cleaner cleans inaccessible parts, eliminates unpleasant foo[...]

9 External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: [...]

10 Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer . Before contacting your local Service Force Centre, please carry out the checks listed below . Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorr[...]

11 If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number . This information can be found on the rating plate located on the right hand side of the dishwasher door . This product should be serviced by an authorised Service engineer , and only genuine spare parts should be used. [...]

12 Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. Remove all packaging before positioning the machine. If possible, position the machine next to a water [...]

13 min 30 cm max 100 cm max 100 cm + 2 m max CS10 Ø 18 Ø 21 W ater outlet hose connection The end of the drain hose can be connected in the following ways: 1. T o the sink outlet spigot, securing it if necessary with a clip. 2. Hooked over the edge of the sink using the special curved plastic guide ( if provided ). 3. T o a stand pipe provided wi[...]

14 Electrical connection This appliance must be earthed. The manufacturer declines any responsibility should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for the socket, it must be cut off and the appropriate plug fitted. Important The wires on the mains lead are coloured in accordance with the f[...]

[...]

1 09/01[...]