Zanussi ZHC 950 инструкция обслуживания

C OOKER HOOD ZHC 950 INSTRUCTION BOOKLET[...]

[...]

Customer Care Department Zanussi 55 - 77 High S treet Slough Berkshire SL1 1DZ T el: 08705 727 727 T o register ownership, please ensure you complete and return the guarantee card supplied with the appliance. Thank you for buying a Zanussi product. T o enable you to use your appliance effectively and safely , please read this instruction book caref[...]

These warnings are provided in the interests of safety . Ensure that you underst an d them all before installing or using this appliance. Y our safety is of paramount impor- tance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. • Installation • Any installation work must be undertaken by a qu[...]

3 YOUR APPLIANCE OPERA TING INSTRUCTIONS This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Cooker Hood Controls The cooker hood functions are controlled by four push button switches located centrally in the control fascia. L Turns the worktop lighting On and Off S Mains light - illumination indic[...]

T o Operate Select the required fan speed and light if required. The appliance can be installed to recirculate or extract contaminated air . The cooker hood is more effective when used in the extraction mode. Recirculation The cooker hood is supplied specified for use in the recirculation mode with the charcoal filter fitted. In the recirculation m[...]

Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply . The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent. Never use scouring pads or abrasive cleaners. Never use excessive amo[...]

Position the new charcoal filter in the position marked and while holding the filter replace the fixing hooks as illustrated. This appliance can be a possible fire hazard if the grease and charcoal filters are not cleaned and replaced as recommended. Changing the Light Bulb Remove the screw fixing the lighting support. Pull the lighting support dow[...]

If, having followed these instructions carefully , your cooker hood fails to work properly please carry out the following checks. SOMETHING NOT WORKING Symptom The cooker hood will not start The cooker hood is not working effectively • Check the hood is connected to the electricity supply . • Make sure the switch is in the ‘ON’ position. ?[...]

8 GUARANTEE CONDITIONS We, Zanussi, undertake that if within twenty four months of the date of the purchase this Electrolux built-in product or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same FREE OF ANY CHARGE for labour , materials or carriage[...]

INST ALLA TION INSTRUCTIONS It is dangerous to alter the specifications or attempt to modify this product in any way . T echnical information DIMENSIONS HEIGHT OF CANOPY : (incl glass visor) 52mm HEIGHT OF CHIMNEY : (UPPER SECTION) 465mm (LOWER SECTION) 740mm WIDTH OF CANOPY : (incl glass visor) 898mm DEPTH OF CANOPY : (incl glass visor) 520mm ELEC[...]

INST ALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood. Installation Requirements Before [...]

11 Clearance Heights The cooker hood is designed to be fitted over a cooking appliance at the clearance heights stated, providing the maximum output of the appliance beneath does not exceed the maximums quoted in the T echnical Specifications. If the output of the appliance below the cooker hood exceeds the maximum outputs quoted, please refer to t[...]

Fix the lower bracket item 7.2.1 using two 4.2x44.4 wall fixing screws item 12a . Fix the upper fixing bracket item 7.2.1 and the recirulation outlet support item 7.3 together using two 4.2x44.4mm wall fixing screws item 12a as illustrated. Insert two 4.2x44.4mm wall fixing screws item 12a into the two holes 1 16mm either side of the vertical line [...]

Fitting the Hood Body Before starting to fix the hood body , tighten the two screws Vr located on the top of the hood body . Hook the hood body onto the two 4.2x44.4mm screws item 12a . Fully tighten the screws item 12a . Using a screw driver and spirit level, adjust the screws item V r until the hood body is level. Extraction The cooker hood is mo[...]

Extraction The charcoal filter is not required in this mode and should be removed. Ducting The ducting used must be Ø150mm (6ins), or Ø125mm (5ins) in diameter . If possible duct through the wall immediately above the hood body . For the best performance use the shortest possible duct run and the minimum number of bends. Where flexible ducting is[...]

15 Fitting the Chimney Stack The chimney consists of two sections. The lower chimney measures 740mm and the upper chimney (with the recirculation grilles on either side) measures 465mm. The overall installed measurement is min. 870 - max 1200mm. UPPER CHIMNEY T o fit the upper chimney section item 2.1 expand the chimney slightly to allow it to be f[...]

[...]

[...]

43600 1681 0 1 - 0 30210 © Electrolux plc 2002[...]