Zanussi ZHI 600 инструкция обслуживания

INTEGRA TED COOKER HOOD ZHI 600 INSTRUCTION BOOKLET[...]

2 Thank you for buying a Zanussi product. T o enable you to use your appliance effectively and safely , please read this instruction book carefully before using the appliance and retain for future reference. If you require guidance in the use of the appliance or require further information on Zanussi Products, please contact our Customer Care Depar[...]

3 IMPORT ANT SAFETY INFORMA TION These warnings are provided in the interests of your safety . Ensure that you understand them all before installing or using this appliance. Y our safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Installation • Any installation w[...]

4 YOUR APPLIANCE OPERA TING INSTRUCTIONS This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. T o obtain the best performance it is advisable to switch on the hood a few minutes before you start cooking and leave it running for approximately 15 minutes after finishing. Cooker Hood Controls S. Automa[...]

5 Extraction The contaminated air enters the hood passing through the grease filter and out through the ducting into the atmosphere. Recirculation A charcoal filter enables the cooker hood to recirculate the air back into the kitchen. When the extraction mode is selected the charcoal filter is not required. Never do flamb é cooking under this cook[...]

6 MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply . The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent. Always wear protective gloves when cleanin[...]

7 The synthetic paper grease filter cannot be cleaned. It must not be washed. Charcoal Filter (for use in recirculation mode) The charcoal filter cannot be cleaned, it should be replaced approximately every three months or more often if the hood is used for more than three hours per day . T o Remove the Charcoal Filter 1. Remove the thumb screw thr[...]

8 SOMETHING NOT WORKING SERVICE AND SP ARE P ARTS If, having followed these instructions carefully , your cooker hood fails to work properly please carry out the following checks. Symptom The cooker hood will not start The cooker hood is not working effectively The cooker hood has switched off during operation If after all these checks, the problem[...]

9 PEACE OF MIND FOR TWENTY FOUR MONTHS ST ANDARD GUARANTEE CONDITIONS We, Zanussi Ltd., undertake that if within twenty four months of the date of the purchase this Zanussi built-in appliance or any part there of is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same F[...]

10 INST ALLA TION INSTRUCTIONS It is dangerous to alter the specifications or attempt to modify this product in any way . T echnical Information DIMENSIONS HEIGHT : 35 cm WIDTH: 60 cm DEPTH: 27-36 cm DEPTH WITH VISOR OPEN: 54-63 cm WEIGHT GROSS: 13,0 kg NET : 1 1,0 kg ELECTRICAL SUPPL Y : V oltage (50Hz) 220-240 V POWER CONSUMPTION: 190 W F AN MOTO[...]

11 INST ALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood. Installation Requirements Befo[...]

12 A: Built-in Electric Hob: 650mm clearance B: Built-in Gas hob: 700mm clearance C: Slot-in Electric Cooker: 685mm clearance D: Slot-in Gas Cooker: 787mm clearance Hob Clearance Height A clearance height of 650mm (25 1/2 ” ) is required when installed above a built-in electric hob, or 700mm (27 1/2 ” ) when installed above a built-in gas hob. [...]

13 V enting The hood is more effective when used in the extraction setting (ducted to the outside). V enting kits may be purchased through your retailer or DIY store, and must be ducted to an outside vent of 100mm (4”) minimum. The ducting used must be manufactured from fire retardant material. When the hood is ducted externally the charcoal filt[...]

14 Fitting the Cooker Hood to the W all 1. Fit the brackets with the round ends facing downwards using the plastic rawl plugs and screws provided. 2. Once the brackets are secured, lift the hood squarely to the wall slightly higher than the brackets. Lower the cooker hood until it is located onto the two brackets. Ensure that the cooker hood is cor[...]

15 Failure to align the top edge of the decor panel with the template will prevent the visor from opening when installed. 3. Before drilling, use a tape measure to check the distances of the screw holes (as given on the template). The template may have altered due to dampness after manufacture. 4. Use the 6 x 15mm (1/2 ins) round headed screws prov[...]

16 In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Service Force Centre by telephoning: 08705 929929 Y our telephone call will be automatically routed to the Service Force centre covering your post code area. For the address of your local Service Force Centre and further information[...]

[...]

[...]

[...]

436002545 01 - 041222 © Electrolux plc 2002[...]