Zanussi ZI 9225 A инструкция обслуживания

REFRIGERA TOR ZI 9155 A ZI 9225 A 2222748-77 INSTRUCTION BOOKLET[...]

2 General Safety • This appliance contains hydrocarbons in it s cooling unit; maintenance and recharging must therefore only be carried out by authorised technicians. • T ake utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. • The appliance must not be located [...]

3 Content s Instructions for the User Important Safety Instructions . . . . . . . . . . . . . . . .2 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Before use / Setting the temperature . . . . . . . . . . .4 Fresh food refrigeration . . . . . . . . . . . . . . . . . . . . .4 The door shelves . . . . . . . . . . . . . . .[...]

4 Fresh food refrigeration T o obtain the best performance, do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour . Do not cover the shelves with any protective material, such as paper , cardboard or plastic, which could obstruct the air circulation. T o help you use yo[...]

5 Normal o perating s ounds Y ou may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear , to the cooling plate. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor . A thermostat controls the compressor [...]

Defrosting The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor , where it evaporates. Important T o avoid defrost water overflowing into the fridge, periodically clean the water discharge hole in the centre of the V shap[...]

7 Something not W orking? Before contacting your local Service Force Centre check the following points. IMPORT ANT : If you call out an engineer to a fault listed below , or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to appliance The light does[...]

8 Service and Sp are Part s In the event of your appliance requiring service, or if you wish to purchase spare part s, please contact your local Service Force Centre by telephoning:- 08705 929929 Y our telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Ce[...]

9 St andard guarantee conditions We, Zanussi, undertake that if within 12 months of the date of purchase this Zanussi appliance or any p art thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour , materials or carriage on condition that: • T[...]

10 ZI 9155 A ZI 9225 A POWER SUPPL Y VOL T AGE AND FREQUENCY 220-240 V / 50 Hz 220-240 V / 50 Hz TOT AL POWER ABSORBED 11 0 W 140 W A VERAGE DAIL Y UNITS ELECTRICITY (*) 0,41 kWh 0,44 kWh GROSS CAP ACITY 158 l 230 l NET CAP ACITY 154 l 228 l (*) This figure is based on standard test results in accordance with European S tandard EN153. Actual consum[...]

11 Door reversal The appliance’s door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove the relevant pins at the top and at the bottom. Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is[...]

12 If you fit your own plug, the colours of the wires in the mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows: Connect the Green and the Y ellow (earth) wire to the terminal in the plug which is marked with the letter «E» or the earth symbol , or coloured green and yello[...]

13 Dimensions of the recess ZI 9155 A ZI 9225 A Height of housing (1) mm 880 1225 Depth of housing (2) mm 550 550 Width of housing (3) mm 560 560 It is necessary that the cabinet has a ventilation recess with the following dimensions: Depth 50 mm Width 540 mm Building in PR0 540 50 3 2 1 For appropriate venting, follow indications in the figure. 50[...]

PR167 Ha Hb 8mm 14 6. Place guide (Ha) on the inside part of the furniture door , up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. 8. Open the appliance door and the furniture door at 90°. Insert the small square ( Hb ) into guide ( Ha ). Put together th[...]

15 10. Place the small square on the guide again and fix it with the screws supplied. Should the alignment of the furniture door be necessary , use the clearance of slots. At the end of this procedure , it is necessary to check if the door of the furniture closes properly . PR168 Hb 1 1. Fix cover ( Hd ) on the small square ( Hb ) until it clips in[...]

© Electrolux plc 2006[...]