Zanussi ZWO 2101 инструкция обслуживания

EN User manual Washing Machine ZWO 2101[...]

Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ 3 Technical information _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8[...]

• Only a qualified person must do the electrical installation, the plumbing and the installation of the appliance. This to prevent the risks of structural damage or inju ry. • Do not install or u se the appliance where the temperature is less than 0 °C. • When you install the ap pliance on a carpet floor, make sure that there is air circulat[...]

Technical information Dimensions Width / Height / Depth 595 / 850 / 390 mm Electrical conn ection: Voltage Overall power Fuse Frequency 220-240 V 2100 W 10 A 50 Hz Level of prot ection against ingress of solid particles and moist ure en- sured by the prot ective cover, except where the low voltage equipment has no protection agai nst moisture IPX4 [...]

Accessories 1 2 3 4 1 Inlet hose To connect the appliance to the cold water tap. 2 Large plastic caps To close the holes on the rear side of the cabinet after the removal of the transit bolts. 3 Plastic hose guide To connect the drain hose on the edge of a sink. 4 Small plastic caps To attach the protection cover to the bot- tom of the appliance. C[...]

Programme phase indicators 3 Indicator Description Washing phase indicator Rinsing phase indicator Spinning phase indicator End cycle indicator Easy Iron button 4 Press this button to prevent the creases in the fabrics. When you press this button, the appli- ance decrease the intensity of the washing phase and spin speed. Automatically, the spin sp[...]

Programme Temperature Type of load and soil Weight of load Programme phases Possible functions Cottons 30° C White and coloured cotton with light soil. max. 3.5 kg Wash Rinses Spin phase at the maxi - mum speed Synthetics 60° C Synthetic o r mixed fabric items with normal level of soil max. 1.7 kg Wash Rinses Spin phase at 800 rpm Sport 40° C Sp[...]

Programme Temperature Type of load and s oil Weight of load Programme phases Possible functions To cancel the programme that it operates or to deactivate the applianc e. Consumption values Programme Energy consumption (KWh) 1) Water consump- tion (litre) 1) Programme dura- tion (minutes) 1) White Cot tons 90 °C 1.50 43.50 102.5 Cottons 3 0 °C 0.2[...]

We recommend that you remove these stains before you put the items in the appliance. Special stain removers are available. Use the special stain remover that is applicable to the type of stain and fabric. Detergents and additives • Only use detergen ts and additives specially made for washing machines. • Do not mix different types of detergents[...]

Loading the laundry 1. Open the appliance door. 2. Put the laundry in the drum, one item at a time. Shake the items before you put them in the appliance. Make sure not to put too much laundry in the drum. 3. Close the door. Caution! Make sure that no laundry stays be- tween the seal and the door. There is a risk of water leakage or damage to the la[...]

4. Press the Start button to start the pro- gramme until the b utton indicator is on. Cancel a programme 1. Turn the programme knob to to cancel the programme and to deactivate the appli- ance. 2. Turn the programme knob again to activate the appliance. Now, you can set a new washing programme. The appliance does not drain the water. Change a funct[...]

Care and cleaning Warning! Disconnect the appliance from the mains sup- ply before you clean it. External cleaning Clean the appliance only with soap and warm water. Fully dry all the surfaces. Caution! Do not use alcohol, solvents or chemical products. Descaling The water we use contains limescale. If it be- comes necessary, use a water softener t[...]

Clean the pump if: • The appliance does not drain the water. • The drum cannot turn. • The appliance makes an unusual noise be- cause of the blockage of the drain pump. Warning! 1. Disconnect the mains plug from the mains socket. 2. Do not remove the filter while the appliance operates. Do not clean the drain pump if the water in the applianc[...]

• Clean the filter in the valve with a stiff brush or a towel. • Install again the inlet hose. Make sure that the couplings are tight to prevent leakages. • Open the water tap. Emergency drain Because of a malfunction, the ap pliance cannot drain the water. If this occurs, do steps (1) through (5) of 'To clean the drain pump'. If ne[...]

Problem Possible cause Possible soluti on The delay start is set. It is available only for models with the Delay start. To start immediately th e programme, cancel the delay start. The appliance does not fill with water. The water tap is closed. Open the water tap. The water inlet hose is damaged. Make sure that the water inle t hose has no damages[...]

Problem Possible cau se Possible solution The applia nce fills wit h water and drain immedi- ately. The end of t he drain hose is too low. Make sure that the drain h ose is in the cor- rect positio n. Refer to 'Instal lation'. The washing results are not sa tisfactory . The detergent you used was not sufficient or correct. Increase the de[...]

2. Remove the polystyrene packaging mate- rials. 3. Remove the internal film. 4. Open the door and remove all the items from the drum. 5. Put the front piece on the floor behind the appliance. Carefully put down the ap- pliance with the rear side on it. Make sure not to damage the hoses. 1 2 6. Remove the polystyrene protection from the bottom. A 1[...]

7. Install the plastic cover (A), removed from the top of the packaging, to the bottom of the appliance. Remove the adhesive strip and close the bottom of the appli- ance. Attach permanently the plastic cov- er to the bottom of the appliance with the small plastic caps that you can find in the user manual bag. 8. Pull up the appliance in vertical p[...]

• The appliance must be level and stable. Caution! Do not put cardboard, wood or equivalent materials below the appl iance feet to adjust the level. The inlet hose • Connect the hose to the appliance. Loose the ring nut to set it in the correct position. • Connect the water inlet hose to the cold water tap with 3/4 thread. Caution! Make sure [...]

• To a sink spigot. Refer to the illu stration. Put the drain hose in the spigot and tighten it with a clip. Make sure that the drain h ose makes a loop to prevent that remaining particles go in the appliance from the sink. • Directly to a built-in drain pipe in the room wall and tighten it with a clip. 20 www.zanussi.com[...]

21 www.zanussi.com[...]

22 www.zanussi.com[...]

23 www.zanussi.com[...]

www.zanussi.com/shop 155219380-B-032012[...]