Zenoah EB7001 инструкция обслуживания

GB-1 EB7001 G B EB7001 G B OWNER’S MANUAL BLOWER 115 40 00-73 (010)[...]

GB-2 EB7001 3 1 2 15 14 6 7 6 19 17 3 8 1 7 12 9 20 2 5 4 16 18 13 24 25 23 22 21 10 11 1. Par ts location SAFETY FIRST Instructions contained in warnings within this manual marked with a symbol concern cr itical points which must be tak en into consideration to pre v ent possible serious bodily injury , and f or this reason y ou are requested to r[...]

GB-3 EB7001 G B MODEL EB7001 Dimensions (LxWxH)** mm 365x485x495 Dry weight* kg 9.7 Fuel tank capacity liter 2.1 Engine type Air -cooled 2-cycle gasoline engine Displacement cm 3 62.0 Air filter 2 stage fresh flow filter system Carburetor Diaphragm, rotary valve type Ignition system C.D.I. Spark plug NGK BPM R7A (Noise-proof) Muffler Spark arrester[...]

GB-4 EB7001 W ARNING 1. Read this manual carefully un- til you completely understand and follow all safety and oper - ating instructions. 2. Keep this manual handy so that you may refer to it later when- ever any questions arise. Also note, if you have any questions which cannot be answered herein, contact the dealer fr om whom you purchased the pr[...]

GB-5 EB7001 G B 1. Operate power equipment only at r easonable hours-not early in the morning or late at night when people might be disturbed. Com- ply with times listed in local ordi- nances. 2. T o reduce sound levels, limit the number of pieces of equipment used at any one time. 3. Operate power blowers at the lowest possible throttle speed to d[...]

GB-6 EB7001 a) W atch out for children, pets, open windows or freshly washed cars, and blow debris safely away . b) Use the full blower nozzle exten- sion so the air stream can work close to the ground. c) Do not allow bystanders in work area. d) Do not point the blower tube in the direction of people or pets. e) Always check to be sure that no deb[...]

GB-7 EB7001 G B engine. Especiall y never f orget to cool down the engine bef ore refu- eling the machine. 10. In an emergency , pull up the lower portion of both strap buck- les to loosen the straps. Move yourself away from the unit. 11. After using blowers and other equipment, CLEAN UP! Dispose of debris in trash receptacles. MAINTENANCE 1. In or[...]

GB-8 EB7001 6. Set up FLEXIBLE HOSE and SWIVEL JOINT 1. Connect the blower and swivel joint with flexible hose. Clamp both ends of the flexible hose securely with the hardwar e supplied with the unit. NOTE A light lubricant may be used to ease assembly of flexible pipe to blower elbow . CONTROL HANDLE • Set up the control handle to the swivel joi[...]

GB-9 EB7001 G B 7. Fuel ■ RECOMMENDED MIXING RA TIO GASOLINE 50 : OIL 1 <when using ZENO AH g enuine oil> • Exhaust emission are controlled b y the funda- mental engine parameters and components (eq., carburation, ignition timing and port timing) with- out addition of an y major hard ware or the intr o- duction of an inert material during[...]

GB-10 EB7001 (1) (2) (3) 6. Once the engine is running, gradually open the choke if it was set closed, and let the engine run at idle speed for a minute to warm it up. NOTE When the engine fails to start after several attempts due to overchoking, open the choke and r epeat pulling the r ope. ADJUSTING IDLE SPEED • The idling speed is set for 2000[...]

GB-11 EB7001 G B WA RNING Make sure that the engine has stopped and is cool before performing any ser vice to the blower . Contact with rotating blower fan or hot muffler may r esult in a personal injury . AIR CLEANER • Never operate the blower without the air filter or with a deformed filter element because unfiltered dusty air will quickly ruin[...]

GB-12 EB7001 PROCEDURES TO BE PERFORMED AFTER EV - ER Y 100 HOURS OF USE 1. Remove the muffler , insert a screwdriver into the vent, and wipe away any carbon buildup. Wipe away any carbon buildup on the muffler exhaust vent and cylin- der exhaust port at the same time. 2. Tighten all screws, bolts, and fittings. AIR INLET NET IMPORT ANT •B lowing[...]

GB-13 EB7001 G B 9. Maintenance HARNESS If the harness is damaged it may break during use, thus causing the product to fall and r esulting in personal in- jury . Follow the instructions below to replace the harness with new one. 1. Pass the upper end of the harness through the hanger , marking the FLAPPED SIDE OUTSIDE. 2. Put the end of the harness[...]

GB-14 EB7001 Limited warranty Should any failure occur on the pr oduct under normal oper - ating conditions within the applicable warranty period, the failed part will be replaced or repair ed free of charge by a ZENOAH authorized dealer . W ARRANTY PERIOD: Six (6) months after purchased by end-user subject to 12 months from pr oduced month. (30 da[...]