JVC SP-UXG33 Bedienungsanleitung

MICRO COMPONENT SYSTEM UX-G33 —Consists of CA-UXG33 and SP-UXG33 UX-G30 —Consists of CA-UXG30 and SP-UXG30 INSTRUCTIONS GVT0171-001B [B] UX-G30[B].book Page 1 Tuesday, February 14, 2006 5:00 PM[...]

G-1 Warnings, Cautions and Others CAUTION— button! Disconnect the mains plug to shut the power off completely (the STANDBY lamp goes off). When installing the apparatus, ensure that the plug is easily accessible. The button in any position does not disconnect the mains line. • When the unit is on standby, the STANDBY lamp lights red. • When t[...]

G-2 Information for Users on Disposal of Old Equipment Attention: This symbol is only valid in the European Union. [European Union] This symbol indicates that the electrical and electronic equipment should not be disposed as general household waste at its end-of-life. Instead, the product should be handed over to the applicable collection point for[...]

1 Introduction Precautions Installation • Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C. • Install the System in a location with adequate ventilation to prevent internal heat buildup inside the System. • Leave sufficient distance between the System and the TV. • Keep the speakers away from [...]

2 Contents Introduction ............................................................... 1 Connections ................................................................ 3 Before Operating the System .................................... 6 Daily Operations—Playback .................................... 7 Listening to the Radio ........................[...]

3 Connections Supplied accessories After unpacking, check to be sure that you have all the following items: If any item is missing, consult your dealer immediately. • FM antenna (1) • AM loop antenna (1) • Remote control (1) • Batteries (2) Do not connect the AC power cord until all other connections have been made. PHONES AUX Rear view Fro[...]

4 1 1 1 1 AM/FM antenna To assemble the AM loop antenna To connect the AM loop antenna • If the AM loop antenna wire is covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl. For the better AM/FM reception • Disconnect the supplied FM antenna, and connect to an outdoor FM antenna using a 75 Ω wire with co[...]

5 2 2 2 2 Speakers To connect the speaker cords Make sure that both speakers are connected correctly and firmly. • When connecting the speaker cords, match the polarity of the speaker terminals: red cord to (+) and black cord to (–). • If the speaker cords are covered with vinyl, remove the vinyl to expose the tip of the speaker cord by twist[...]

6 Before Operating the System The indications on the display tell you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 1 Disc operation indicators • PRGM (Program Play): lights when Program Play mode is activated. • RND (Random Play): lights [...]

7 Daily Operations —Playback 1 Turn on the power. The STANDBY lamp on the main unit turns off. Without pressing STANDBY/ON ... • The System turns on by pressing one of the source buttons. • The System turns on and activates the AUX source by starting playback on an external device when QP Link is activated. (See page 9 for details.) 2 Select [...]

8 Listening to the Radio To select the band (FM or AM) To tune in to a station While FM or AM is selected... Frequency starts changing on the display. When a station (frequency) with sufficient signal strength is tuned in, the frequency stops changing. • When you repeatedly press the button, the frequency changes step by step. To stop searching m[...]

9 To select a track To select a group (MP3 only) 1 While disc play is stopped, activate the group select mode. 2 Select a group number. Group number and group name appear. To locate a particular portion While playing a disc, press and hold until the portion you want is reached. To locate a track directly 1 Activate the track number entry mode. 2 En[...]

10 Daily Operations —Sound&Other Adjustments Adjusting the Volume The volume level can be adjusted between “VOL MIN” and “VOLUME 1” – “VOLUME 40 (VOL MAX).” To drop the volume in a moment Adjusting the Sound To emphasize the sound—Sound Turbo This function emphasizes the sound. To reinforce the bass sound —AHB Pro You can re[...]

11 Changing the Display Brightness You can dim the display window. Adjusting the Audio Input Level If the sound from a component connected to the AUX jack is too loud or is too quiet, you can change the audio input level through the AUX jack (without changing the volume level). While AUX is selected as a source... Setting the Clock Without setting [...]

12 Advanced Radio Operations Receiving FM Stations with Radio Data System Radio Data System allows FM stations to send an additional signal along with their regular program signals. This System can receive the following types of Radio Data System signals. To show the Radio Data System information While listening to an FM station... Searching for a [...]

13 Switching Temporarily to a Program of Your Choice Automatically The Enhanced Other Networks function allows the System to switch temporarily to a preset FM station broadcasting a program of your choice (TA, NEWS, or INFO). • This function works while listening to an FM station providing the required signals. While listening to an FM station, s[...]

14 Advanced Disc Operations Programming the Playing Order— Program Play You can arrange the playing order of the tracks (up to 99) before you start playback. 1 Before starting playback, activate Program Play. 2 Select track numbers you want for Program Play. To select track numbers on an MP3 disc, enter the number in two digits. Refer to the foll[...]

15 To exit from Program Play Before playback or while playback is stopped... • Exiting from Program Play erases the stored program. Playing at Random—Random Play You can play all tracks at random. 1 Before starting playback, activate Random Play. 2 Start playback. To exit from Random Play Before playback or while playback is stopped... Playing [...]

16 Timer Operations Setting the Timer Using Daily Timer, you can wake up with your favorite music. • You can store three Daily Timer settings; however, you can activate only one timer at a time. • To exit from the timer setting, press TIMER as required. • To correct a misentry during the process, press CANCEL. You can return to the previous s[...]

17 3 Turn off the unit (on standby) if you have set the on- time. To turn off the Timer after its setting is done Since Daily Timer is activated at the same time everyday, you may need to cancel it on some particular days. 1 Select the Timer you want to cancel. 2 Turn off the selected Timer. To turn on the Timer again, repeat the above steps and pr[...]

18 Additional Information Learning More about This System Daily Operations—Playback (see pages 7 to 9) Listening to the Radio: • If you store a new station into an occupied preset number, the previously stored station in that number will be erased. • When you unplug the AC power cord or if a power failure occurs, the preset stations will be e[...]

19 Timer Operations (see pages 16 and 17) • When you unplug the AC power cord or if a power failure occurs, the timer will be canceled. You need to set the clock first, then the timer again. Troubleshooting If you are having a problem with your System, check this list for a possible solution before calling for service. General: Adjustments or set[...]

20 Specifications Amplifier section Output Power: 60 W (30 W + 30 W) at 6 Ω (10% THD) Speakers/Impedance: 6 Ω – 16 Ω Audio Input AUX: 500 mV/50 k Ω (at “AUX LVL 1”) 250 mV/50 k Ω (at “AUX LVL 2”) 125 mV/50 k Ω (at “AUX LVL 3”) Tuner section FM tuning range: 87.50 MHz – 108.00 MHz AM (MW) tuning range: 522 kHz – 1 629 k[...]

SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. Do read the operating instructions before you attempt to use t[...]