John Lewis JLDWW 906 manual

JLDWW 906 Dishwasher Instruction manual[...]

Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to kno[...]

• Keep all detergents in a safe place out of children’s reach. • Keep children well a way from the dishwasher when th e door is open. Correct use • This dishwasher is only intended for washing household utensils suitable for machine washing. • Do not put any solvents in the dishwasher. This could ca use an explosion. • Knives and other [...]

• 45°-70° Auto Wash Programme: This machine is fitted with a turbidity sensor which intelligently adjusts the temperature and rinsing cycles during the wash programme, dependin g on the degree of soiling on the dishes. This helps to reduce energy and wa ter consumption on lightly soiled loads. • Half load: This option is useful and economical[...]

Contents For the user Important safety information 2 Description of the appliance 6 Control panel 7 Washing programmes 9 When the dishwasher is first installed 11 The water softener 11 Filling with dishwasher salt 13 Filling with rinse aid 13 Adjusti ng the rins e aid dosa ge 14 Daily use 15 Loading cutlery and dishes 15 The lower basket 16 The cut[...]

Description of the appliance 1. Upper basket 2. Water hardness dial 3. Salt container 4. Detergent dispenser 5. Rinse aid dispenser 6. Rating plate 7. Filters 8. Lower spray arm 9. Upper spray ar m 10. Worktop 6[...]

Control panel 1. On/Off butto n 2. Programme selection buttons 3. Multi tab button 4. Half load button 5. Delay start buttons 6. Digital display 7. Programme lights and indicator lights 8. Function buttons The digital display indicates: • the level of hardness to which the water softener is set, • the approximate remaining time of the running p[...]

Multi tab button Allows the use of co mbi detergent tablets (3 in 1 - 4 in 1 - 5 in 1, etc...). See ''Multi tab function''. Function buttons In addition to the wa shing programme selected, the following functions can also be set using these button s: • setting the water softener level, • cancelling a washing programme or a d[...]

Press the On/Off button; if a programme light is illuminated, the last performed or selected programme is still set. In this case, to return to setting mode, the programme has to be cancelled. To cancel a set programme or a programme in progress Simultaneously press and hold the two Cancel buttons (B and C), until all the programme lights illuminat[...]

Programm e Degree of soil Type of load Programme description Rinse hold Any. Partial load (to be completed later in the day). 1 cold rinse (to avoid food scraps from sticking). This programme does not require the use of detergent. 1) During th e Auto washing pr ogramme the level of soiling on the dishes is d etermined by how cloudy the water is. Th[...]

When the dishwasher is first installed Before using your dishwasher for the first time: • Ensure that the electrical and water connections comply with the in stallation instructions • Remove all packaging from inside the appliance • Set the water softener level • Pour 1 litre of water into the salt container and then fill with dishwa sher s[...]

Water hardness Adjusting the water hardness setting Use of salt Clarke °TH mmol/l man ually electronically < 5 < 7 < 0,7 1 level 1 no Setting the water softener The water softener must be set in two ways: manually, using the wa ter hardness dial and electronically. Setting manually The dishwasher is factory set at position 2. 1. Open the [...]

Filling with dishwasher salt Warning! Only use salt specifically designed for use in dishwas hers. All other types of salt not specifically designed for use in a dishwasher , especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains of salt or[...]

2. Add the rinse aid in the container. The maximum level for filling is indicated by "max". The dispenser holds about 110 ml of rinse aid, which is sufficient f or between 16 and 40 dishwashing cycles, de pending upon the dosage setting. 3. Ensure that the lid is closed after every refill. Clean up any rinse aid spilt during filling with [...]

Daily use • Check if it's necessary to refill with dishwasher salt or rin se aid. • Open the door and slide o ut the baskets to load the dis hes. • Load cutlery and dishes into the dishwasher. • Fill with dishwasher detergent. • Select a wash progra mme suitable for the cutlery and di shes. • Start the wash programme. Loading cutle[...]

The lower basket The lower basket is design ed to take saucepans, lids, plate s, salad bowls, cutlery, etc. Serving dishes and large lids should be arranged around the edge of the basket, ensuring that the spray arms can turn freely. The rows of prongs in the lower basket can lie flat to allo w you to load pots, pans an d bowls. The cutlery basket [...]

1. Place the cutlery basket on a firm support (table, worktop) and unfold both handle parts. 2. After unfolding, fold back both handle parts. The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter) , salad bowls, cups and glasses. Arrange items on and underneath the cup racks so t[...]

Maximum height of the dishes in: the upper basket the lower basket With upper basket raised 20 cm 31 cm With upper basket lowered 24 cm 27 cm To move to the higher position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards until the mechanism is engaged and the basket is stable. To lower the basket to t[...]

20 = approximately 20 g of detergent 30 = approximately 30 g of detergent 3. All programmes with prewash need an additional detergent dose (5/10 g) that must be placed in the prewash detergent chamber (2). This detergent will be used during the pr ewash phase. When using detergent tablets; place the tablet in compartment (1). Detergent tab lets Det[...]

Multi tab function This appliance is equipped with the Multi tab function, that a llows the use of combi detergent tablets. These products are detergents with a combined cleaning, rinsing a nd salt functions. They can also contain other diff erent agents depending on which kind of tablets you choose ("3 in 1", "4 in 1", "5 [...]

5. To memorise the operation, switch off the dishwasher by pressing the On/off button. If you decide to revert back to the use of individual detergents we advise that you: 1. Deactivate the Multi tab function. 2. Fill up the salt container and the rinse aid dispenser again. 3. Adjust the water hardness setting to the highest setting an d perform 1 [...]

Setting and starting the programme with delay start 1. After having selected the washing programm e, press one of th e delay st art buttons until the flashing number of hours for the delay start appear in the digital display. The start of th e selected washing programme can be delayed for between 1 and 19 hours. 2. Close the dishwasher door, the co[...]

When the wash ing p rogram me has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Unloading the dishwasher • Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. • Empty the lower basket first and then the upper one; this will avoid[...]

4. Take hold of the coarse filter (A) by the handle with the hole and remove from the microfilter (B) . 5. Clean all filters thoroughly under running water. 6. Remove the flat filter from the base of the washing compartment and clean both faces thoroughly. 7. Put the flat filter back in the base of the washing compartment and ensure that it fits pe[...]

Frost precautions Avoid placing the machine in a location whe re the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house, etc...): 1. Unplug it. 2. Turn the water tap off. 3. Remove the water inl[...]

Fault code and malfun ction Possible cause and solution • appears in the digital display Anti-flood device is activated • Close the water tap and contact our extended warranty administrators, refer to Repair s-After Sales Service on the following pages. Malfunction Possible caus e and solution The programme does not start • The dishwasher doo[...]

The wash results are not satisfactory Water drops have dri ed onto glasses an d dishes • Increase rinse aid dosage. • The detergent may be the cause. Contact the detergent manufacturer’s consumer care line. 27[...]

Technical data Dimensions Widt h Height Depth 45 cm 85 cm 61 cm Electrical connection - Voltage - Overall power - Fuse Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door. Water supply pressure Minimum Maximum 0,5 bar (0,05 MP a) 8 bar (0,8 MPa) Capacity 9 place settings Weight 38 kg Instal[...]

Remove the machine ’s worktop by unscrewing the two rear retaining screws (1), pull the worktop from the back of the machine (2) and slide out the front slots, lifting the worktop (3). Insert the machine after adjusting the levelling with the adjustable feet. Whe n inserting the machine, ensure that the water inlet and drain hoses are not kinked [...]

The water pressure must be within the limits given in the "Te chnical data". Your local Water Authority will advise you on the average mains pressure in yo ur area. The water inlet hose must not be kinked, crushed, or entangled when it is being connected. The dishwasher features fill and drain ho ses which can be turned either to the left[...]

The drain hose can face either to the right or left of the dishwasher. Ensure the hose is not bent or squashe d as this could prevent o r slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could caus e the water to syph on back into the machine. If you use a drain hose extension it must be no l[...]

Electrical connection Warning! Safety standards re quire the appliance to be earthed. Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed. The fuse rating is also to be found on the rating plate. Always plug the mains pl[...]

4. The purchase date (found on your receipt). 5. The model and serial number of the appliance (found on the rating plate). So that you always have the se numbers at hand, we recomme nd that you make a note of them here: Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PNC : . . . . . . . . . . . . . . . . . . . . . . . . .[...]

34[...]

35[...]

John Lewis Partne rship 171 Victoria Street London SW1E 5NN www. johnlewis.com 117986680 - 01 - 072007 - Subject to change without notice[...]