Teka DW8 60 SWB manual

Contents 1 1. Safety and operati ng instructions ___________________________ 2 2. Installation an d hook-up ___________________________________ 5 3. Description of t he controls _________________________________ 9 4. Operating inst ructions ___________________________________ 16 5. Cleaning and ma intenance _______________________________ 28 6. Tro[...]

Safety instructions 2 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLI ANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULL Y READ ALL THE INSTRUCTI ONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED B Y A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REG[...]

Safety instructions 3 OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLU GGING IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR CHILDREN (LOCKS, DOORS, ETC.). THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT ( W[...]

Safety instructions 4 LEANING OR SITTING ON THE DISHW ASHER DOOR WHEN OPEN M A Y CAUSE THE APPLIANCE TO OVERTURN, PUTING PEOPLE AT RISK. NEVER LEAVE THE DISHWASHER DOOR OPEN; PEOPLE MIGHT TRIP OVER IT. DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE. [...]

Installation instructions 5 2. Inst allation and hook-up Remove the polystyrene bask et retainers. Position the appliance in the desired place of installation. The back or sides of the dish washer may be placed up against walls or oth er furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent [...]

Installation instructions 6 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long t ime, before connecting to the water supply check that the water is clear and free of impu rities, to prevent damage to the appliance. The dishwasher must always be connected to the water syste[...]

Installation instructions 7 2.2 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE. THE PLU[...]

Installation instructions 8 FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE E ARTHED. Fuse replacemen t If the mains lead of this appl iance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S .T .A. approved fuse to BS 1362 type and proceed as follo ws: 1. Remove the fuse cover A and fuse B . 2. Fit replacem[...]

User instructions 9 3. Description of the controls 3.1 Front panel All the dishwasher control are grouped on t he front panel. Programming and option selection are only possible with the door closed . 1 ON/OFF BUTTON 2 START/PAUSE BUTTON 3 SELECTION PROGRAMS BUTTON 4 PROGRAMS LIGHTS 5 “3/1” OPTION BUTTON (on some models only) 6 “3/1” OPTION[...]

User instructions 10 7 ½ LOAD WASH BUTTON (on some models only) 8 ½ LOAD WASH LIGHT (on some models only) 9 WATER HARDNESS ADJUSTMENT ON INDICATOR LIGHT The light flashes to indicate that the applia nce is in “water hardness adjustment” mode. SALT WARNIN LIGHT (on s ome models only) If the symbol is present, illumination of this light denotes[...]

User instructions 11 DURATION CONSUMPTION PROGRA M SELECTION T YPE AND GRADE DIRT PROGRESS PROGRA M MINUTES (2) WA TER LITRES (1) POWER KWh (2) SOAK PANS AND DISHES AWAI TING COMPLET ION OF THE LOAD Cold prewash 15' 5,5 0,02 ECO (*) EN 50242 DISHES W ITH NORMAL DIRT, EVEN WITH DR IED-ON RESID UES Cold prewash Wash at 50°C Rinse at 66°C Dry 1[...]

User instructions 12 3.2 Washing programs The dishwasher is equipped with a control panel, described in chapter "3. Description of the controls", from which it is possi ble to carry out all the power switch-on, switch-off and progr amming operations. Before starting a washing program make sure that: • The water supply tap is open. • T[...]

User instructions 13 END OF PROGRAM At the end of the program the beeper sounds briefly and the pr ogram lights 4 and 5 (marked "end") flash. INTERRUPTION A PROGR AM To interrupt a program in progress: • press the START/PAUSE button (2) ; the light of the program in progress remains on (confirmation beep); • you may no w restart the p[...]

User instructions 14 In case that the door is opened during the oper ation, to the next door closing it is going to be necessary to start the program as shown in paragraph “ S TARTI NG THE PROGRAM ”. The program will resume from the point in which it was interrupted. In case that the tu b temperature is higher than 50°C the program will start [...]

User instructions 15 TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT • Always try to run the dishwasher fully loaded . • Do not wash the dishes in running w ater. • Use the washing progr am that is most appropriate for each type of load. • Do not carry out any preliminary rinsing. • If available, connect the dis hwasher to a hot water [...]

User instructions 16 4. Operating instructions Once the dishwasher h as been correctly installed, prepa re for use as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and deterge nt. 4.1 Using the water softening system The amount of scale contain ed in the water (water hardness inde x) can cause [...]

User instructions 17 • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the r ege nerating salt container before starting the washing progra m . In this way, the excess saline solution will be immediately remove d by the water; the prolonged presence of s[...]

User instructions 18 WATER HARDNESS TABLE WATER HARDNESS German degrees (°dH ) French Degrees (° dF) SETTING 0 - 4 0 - 7 All lights off (no salt) 5 - 15 8 - 25 One light on 16 - 23 26 - 40 Two lights o n 24 - 31 41 - 60 Three lights on 32 - 47 61 - 80 Four lights on 48 - 58 81 - 100 Five lights on Contact your local water board for information on[...]

User instructions 19 ADDING THE RINSE AID The rinse aid he lps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatic all y added to the water during the final rinse c ycle, from the container situated on the inner side of the door. To add rinse aid: • Open the door. • Rotate the container cap anticlock[...]

User instructions 20 ADDING THE DETERGENT To open the detergent dispenser cap, l ightly press the button P . Add the detergent and clos e the cap carefully. During the washing cycle, the disp enser will be opened automatically. • When a program wi th hot prewash is selected (see program table), extra detergent must be placed in the cavity G/H (de[...]

User instructions 21 • "3/1" Products If you wish to use detergents which already contain salt and rinse aid, check whether your dis hwasher is fitted with the " 3/1 option button " on the " Controls description " page and then ref er to the section which explains how to use this funct ion. If the button is not provi[...]

User instructions 22 WARNING! • Make sure that the dishes are secu rely in place so that they cannot tip over or obstruct the rotati on of the spray arms during the washing cycle. • Do not place very small obj ects in the baskets as these could fall and obstruct the spray arms or the wash pump. • Containers such as cups, bowls, glasses and po[...]

User instructions 23 4.4 Using the baskets The dishwasher has a capacit y of 12 place-settings , including serv ing dishes. LOWER BASKET The lower basket receives the full force o f the lower spray arm, and should therefore be use d for the “t oughest” items with a heavier degre e of soiling. All types and combinations of loads are permitted, p[...]

User instructions 24 CUTLERY BASKET The basket has removable t op grids into which items of cutlery can be inserted to keep them properly spac ed and allow water to pass bet ween them effectively. The cutlery supports and c entral lid are in the ba g of accessories. The central lid is int ended to act only as a cover: do n ot place the cutlery in i[...]

User instructions 25 UPPER BASKET It is recommended to load the upper bask et with small- or medium-sized items such as glass es, small plates, tea or coffee cups, s hallow bowls and light objec ts made from heat resistant plastic. If the upper basket is used in the lowermost position, it can also be loaded with ser ving dishes, provided they are o[...]

User instructions 26 Depending on the mode ls, the basket may be equipped with some or all of the following accessories: - Supports for cups or long ob jects (ladles, spoons…), on the left; can be tipped to the vertical position when not in use. - Long-stemmed glass holder, on t he left; to use, simply lift and fix onto the hooks provided. - Cutl[...]

User instructions 27 ADJUSTING THE UPPER BA S KET The height of the top b asket can be adjusted to allow large dishes or pans to be placed in the bottom basket. The adjustment procedure ma y be type A or B , de pending on the dishwasher model purchased. Version A : pull-out with adjustment in t w o positions. • Pull out both the basket guides. ?[...]

User instructions 28 5. Cleaning and maintenance Before carrying out any work, a lways unplug the appliance from the electrical supply or switch off the all-pole disconnection device. 5.1 General warnings and recommendations Avoid the use of acidic or abrasi ve detergents. Clean the outer surfaces and door-linin g of the dishwasher regularly using [...]

User instructions 29 CLEANING THE FILTER UNIT • It is adv isable to periodically inspect the centre filter C and, if necessary, to clean it. To remove the filter, grip th e tabs, turn them anticlockwise and lift upwards; • push the centre filter D from the underside to remove it from the micro-filter: • separate the two parts which make up th[...]

User instructions 30 BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE: • Check that there are no deposits of sludge or rust inside t he water pipe: if there are, allow the water to run from the water s upply tap for a few minutes. • Plug the power cord back into the socket. • Reconnect the water intake h ose and open the tap again. TROUB[...]

User instructions 31 If the dishes fail to dry or remain dull, check that: • there is rinse aid inside the special c ontainer; • the rinse aid dispenser setting is correct; • the detergent used is of good quality an d has not lost its effectiveness (for example, throu gh incorre ct storage, with the box left open). If the dishes show signs of[...]

User instructions 32 6. T roubleshooting The dishwasher is capable of signall ing a number of faults through the simultaneous illumination of several i ndicator lights, with the following meanings: FAULT DESCRIPTI ON E1 Acquastop failure The anti-flooding sy stem has been activated. The system is tripped in case of w ater leaks. Contact the after-s[...]

User instructions 33 FAULT DESCRIPTI ON E7 Turbine flow-regulator malfunction The appliance is not able to "measur e" the amount of water loaded accurately. Interrupt the program and s witch off the dishwasher. Switch the dish wa s her back on, program it again and start the washing cycle. If the problem persists, contact the after-sales [...]

User instructions 34 TECHNICA L DATA Width 597 ÷ 599 mm Depth measured flush w ith the outer edge of the control panel Free standing: 600 mm Semi-integrated: 570 mm H e ig h t (dependi ng on models) Free standing: from 850 mm to 870 mm from 890 mm to 910 mm Semi-integrated: from 820 mm to 870 mm from 860 mm to 910 mm Capacity 12 Standard place set[...]