CDA CI860 manuel d'utilisation

Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu ci860 Freestanding W asher Dryer 8 + 6kg, 1400 Spin Manual for Installation, Use and Maintenance[...]

2 Important This appliance must only be used for the purpose for which it is intended, i.e. domestic use . Any other use could be dangerous and may lead to premature failure of the appliance. The CD A Group L td cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CD A reserve t[...]

3 IMPORT ANT INFORMA TION FOR CORRECT DISPOSAL OF THE PRODUCT IN A CCORD ANCE WITH EC DIRECTIVE 2002/96/EC. At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority dierentiated waste collection centre or to a dealer providing this service. Disposing of a household applianc[...]

4 Safety W arnings • If the plug or cord is damaged, do not connect the appliance to the mains power supply . If the cord is damaged it should be replaced by the manufacturer or appointed service agent in order to avoid a hazard. • T o remove the plug from the socket, pull on the body of the plug, not the cable. • Do not plug the appliance in[...]

5 W arnings T o avoid the risk of fire, electric shocks, injury or damage when using your washer dryer , please take the following precautions: • Please read all the instructions before using the washer dryer . • Do not wash items that have previously been cleaned, washed, soaked or treated with petrol, solvents for dry cleaning, other inflam[...]

6 R ecommendations • R esidues of detergent or softener left in the detergent drawer for long periods will dry and stick to the detergent drawer . T o prevent this put the detergent and softener into the detergent drawer just before washing. • It is recommended that the pre-wash programme should only be used for very dirty clothes. • Do not e[...]

7 Before First Use When your washer dryer has been correctly installed, we recommend that you pre-clean the machine. This is to check that the installation, the connections and the drainage are all correct, and to thoroughly clean the inside of the washer dryer before any wash programmes are run. Prior to pre-cleaning you should ensure the transit [...]

8 • Fasten all zips and buttons. • T urn garments, such as knitted fabrics, inside out. • Before placing the clothes in the drum, make sure all the pockets are empty . Any small objects may block the drain pump. • W e recommend loading the washer dryer to its full capacity for best water and energy eciency . • Whenever possible, we rec[...]

9 Detergents and Additives Y our washer dryer’ s detergent dispenser has three compartments, marked with symbols. For prewash detergent For main wash detergent For fabric conditioner , starch or other additives. Add the required amount of detergent and fabric softener into the specific sections of the detergent dispenser before starting the wash[...]

10 Liquid Detergent • Liquid detergent may be used in your washer dryer by using the liquid detergent adaptor . • Any programs that don’t include pre-wash may be run with liquid detergent. • Plug the liquid detergent adaptor into the second compartment of the detergent drawer and add the quantity liquid recommended by the detergent manufact[...]

11 Eco Note The use of more detergent than necessary will not improve your washing results, and will have a negative eect on the preservation of the environment. W e therefore recommend you follow the detergent manufacturer’ s instructions. Loading the W asher Dryer - Open the door . - Add the items to be washed separately , ensuring they are [...]

12 Control P anel A B C D E F G H A Programme selector knob B T emperature button C Spin speed button D Stain level button E Options button (prewash, extra rinses or anti-allergy) F Dry level button G Delay button H Start button g. 2[...]

13 S tarting a W ash Programme • T urn the “Programme selector” knob to the required programme . • Select the required adjustments and additional functions using the buttons “B” to “G” in g 2. as detailed below . • Press the “Start” button. When a wash programme is in progress, the programme can be paused by pressing the ?[...]

14 the programme listing on pages 20 & 21. Y ou can change the spin speed, if required, by pressing the “Spin speed” button a number of times. If you miss the speed you want you can come back round to it again by pressing a few more times. Extra functions Extra functions can be selected once the programme has been set. T o select any extra [...]

15 display . Note: If the prewash symbo l does not display on the screen it is because the prewash function is not available for the programme selected. Note: Prewash is not available for selection at the same time as extra rinses or the anti-allergy option. Extra rinses This function adds up to 3 extra rinse cycles to the programme, which is ideal[...]

16 Anti-allergy function Press the “Options ” button again to activate the anti-allergy function. The display will show . In this setting the machine rinses the washing in hot water: Note that the energy consumption of the machine increases when this function is used. When the “Options ” light is not illuminated this means that extra rinse [...]

17 T o set drying level Y ou can change the drying level, if required, by pressing the “Dry L evel” button a number of times. If you miss the level you want you can come back round to it again by pressing a few more times. L evel 1 ( showing on the display) is recommended for washing that is to be ironed. L evel 2 ( showing on the display) is r[...]

18 Note: If you choose to set a dened drying time this will automatically be at the default drying level for the programme selected. R efer to the drying programme list on page 22 for details of drying options available for each programme. Delay timer A delay of up to 23 hours can be set before the start time for the programme, in half hour incr[...]

19 Cancelling a programme If you need to cancel a programme after it has started running: • Switch the “Programme selector” knob to the “0” position: The machine will stop its washing operation. • T o discharge any water in the machine turn the “Programme selector” knob to any other programme: The water will be discharged and the ma[...]

20 W ash T emperature Options Detergent Compartment Index Programme Cold 30 40 40e 50 60 60e 70 80 90 A Whites A A A A A A A P 8 2 215 B ** Cotton Eco A A A A A P 8 2 220 C Eco 20°C P 4 2 105 D Synthetics A A P 3.5 2 135 E Wool A P 2.5 2 55 F Duvet A A P 2.5 2 105 Refresh P 1 N/A 30 Rinse P 8 N/A 50 Spin P 8 N/A 20 G Rapid 15 min A P 2 2 15 * H Da[...]

21 Index Laundry Type A Cottons & linens (Maximum 4kg for towels) 1400 Medium L ow, High A 1, 2, 3, A B ** Cottons & linens (Maximum 4kg for towels) 1400 Medium L ow, High A 1, 2, 3, A C Cottons & linens (Maximum 2kg for towels) 1400 Low 1, 2, 3, A D Synthetic mix ed textiles 800 High L o w, Medium A 1, 2, 3, A E Machine washable woolle[...]

22 Index Programme L aundry Type A Whites Cottons & linens (Maximum 4kg for towels) 6 1 2, 3 30 , 60, 120 B ** Cotton Eco Cottons & linens (Maximum 4kg for towels) 6 1 2, 3 30 , 60, 120 C Eco 20°C Cottons & linens (Maximum 2kg for towels) 4 1 2 30, 60 , 120 D Synthetics Synthetic mixed textiles 3.5 1 2, 3 30, 60 , 120 E Wool Machine wa[...]

23 Care and Maintenance Before beginning any care or maintenance you should always disconnect the appliance from the electricity supply , and also turn o the water supply . If a programme has been run recently , wait for the water in the appliance to cool down to prevent risk of scalding. W ater inlet lters There are filters on the tap side [...]

24 Pump Filter The pump filter system prevents ingress of lint or foreign objects into the drain pump, reducing the risk of damage. The pump filter should be cleaned regularly , every two to three months at least. T o avoid injury , do not carry out this operation when the wash water is at a temperature over 30ºC T o clean the lter: • Open [...]

25 Detergent Drawer Detergents may cause residue build up in the detergent drawer and the drawer housing over time. The drawer should be cleaned regularly to remove these residues. T o remove the drawer: • Pull the drawer out until it stops. • T o remove the drawer , press down on the syphon lid inside the drawer and remove from the housing (?[...]

26 Cleaning the W asher Dryer Exterior The exterior of the washer Dryer should be cleaned with warm soapy water or a gentle cleaning agent. Do not use abrasive cleaning products or solvents. It should then be dried thoroughly with a soft cloth. Please note - wipe any detergent spills immediately to minimise the risk of damage to the washer dryer ex[...]

27 Practical Information Alcoholic beverages: The stain should first be washed with cold water , then wiped with glycerine and water and be rinsed with water mix ed with vinegar . Shoe Polish: The stain should be slightly scratched without ruining the cloth, rubbed with detergent and rinsed. In case it is not eliminated, it should be rubbed with 1[...]

28 Practical Information Blood stain: Soak the item in cold water for 30 minutes. If the stain still does not disappear , soak in a mixture of water and ammonia (3 table-spoons of ammonia in 4 litres of water) for 30 minutes. Cream, ice-cream and milk: Soak the item in cold water and rub the stained area with detergent. If the stain has still not d[...]

29 Failure Code Probable failure The process to be done E01 The door is not shut properly . Shut the door properly so that you hear the click then press the “Start” button. If the error persists, unplug the machine, close the water tap and contact CD A Customer Care. E02 or W ater cut o or low water pressure. Make sure the tap is turned on a[...]

30 T roubleshooting All repairs which must be done on the machine should only be performed by authorised service agents. When a repair is required for your machine or you are unable to eliminate the failure with the help of the information given below: • Unplug the machine. • Close the water tap. • Contact CD A Customer Care. Fault Probable c[...]

31 Fault Probable cause Methods of elimination The machine is not draining water . The drain hose is obstructed or bent. Check the drain hose. The pump filter is obstructed. Clean the pump filter . The machine is vibrating. Not all transit bolts have been removed. Remove all the transit bolts. The machine is located on an uneven surface or is not[...]

32 Installation All four transit bolts, located at the rear of the appliance, must be removed prior to using the appliance to prevent damage. Cover the bolt holes with the plastic plugs supplied. Do not throw the transit bolts away . If you need to move the washer dryer after installation you should rst replace the transit bolts and spacers. Do [...]

33 Levelling T o reduce the noise from the washer dryer and to prevent unnecessary movement and vibration during use, ensure the washer dryer is level, using the adjustable feet. First, x and level the rear feet. When they are properly x ed, secure the plastic locknut tightly against the underside of the washer dryer . • Put the washer drye[...]

34 Connecting to the Mains W ater Supply • Fit the seal included in the hose packing at the end of the water inlet hose on the tap side. • Connect the water inlet hose to a ¾” BSP water tap. Then securely tighten the connecting nut by hand. • After connections are completed, check there are no leaks from the connection joints by turning on[...]

35 The drain hose must be securely fastened to the outlet to prevent any risk of the drain hose becoming detached and causing ooding. Once the appliance is connected to the water supply and the drain connection, ensure that the water inlet and drain hoses are not folded, twisted, crushed or elongated by stretching when moving the appliance into [...]

36 How to connect an alternative plug If the fitted plug is not suitable for your socket outlet, then it should be cut o and disposed of safely to prevent the risk of electric shock. A suitable alternative plug of at least 13 Amp rating to BS 1363 should be used. As the colours of the wires in the mains lead of this appliance may not correspond[...]

37 International W ashing Symbols W ash up to 90 °C W ash up to 60 °C W ash up to 30 °C Do not wash in a washing machine W ashing temperatur e Do not wash in a washing machine Lukewarm iron Medium hot iron Hot iron Do not iron Do not tumble dry Hang to dry Drip dry Dry flat Do not bleach Handy to bleach All of these are dry cleaning symbols. Th[...]

38 NO TES[...]

39 NO TES[...]

Please contact our Customer Care Department for Service on the details below . Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu[...]