Cisco IE 3000 manuale d’uso

1 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide • About This Gui de, page 1 • T aking Out What Y ou Need, page 2 • Connecting Expansion Mod ules, page 3 • Running Express Setup, p age 5 • Managing the S witch, page 9 • Installing the Sw itch, page 11 • Connecting to the Switch Ports[...]

Cisco IE 3000 Switch Getting Started Guide 2 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 For add itional inst allation and co nf iguration info rmation for Cisco IE 3000 switches, see the Cisco IE 3000 docume ntation on Cisco.com. For system requirements, important notes, limitatio ns, open and resolv ed bugs, and last-minute documentati[...]

3 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide Figure 1 Cisco IE 3 00 0 Shi pping Box Contents Connecting Expansion Modules The switch can operate as a standalone device with F ast Ethernet ports. Y ou can increase the number of Fast Ethern et ports by connecting the Cisco IEM-3000-8TM or the Ci[...]

Cisco IE 3000 Switch Getting Started Guide 4 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 Foll o w these steps to conn ect the expa nsion modules to the switch. Step 1 Remov e the right side panel by f irmly grasping bot h sides in the middle and pu lling it outward. If necessary , use a flat-blade scre wdri ver to pry open the side panel[...]

5 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide Running Express Setup When you f irst set up t he switch, you should use Exp ress Setup to enter the in itial IP information. Doing th is enables the switch to connect to local rout ers and the Internet. Y ou can then access t he switch through t he[...]

Cisco IE 3000 Switch Getting Started Guide 6 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 T o run Express Setup: Step 1 Make sure that noth ing is connected to the switch. During Express Setup, the switch acts as a DHCP server . If your PC has a static IP address, change your PC settin gs before you begi n to temporarily use DHCP . Step 2[...]

7 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide Step 6 Connect a Category 5 Ethernet cable (not pro vided) from the blinking switch por t to the Ethernet port on your PC. The port LEDs o n your PC and t he switch blink green w hile the sw itch configures the connection. Step 7 When the Setup LED [...]

Cisco IE 3000 Switch Getting Started Guide 8 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 Step 9 Enter the netw ork settings. Al l entries must be in Engli sh letters an d Arabic numbers. • Management Interface (VL AN) : W e recommend using the def ault, VLAN 1 . The management VLAN establi shes an IP conn ection to the swit ch. • IP [...]

9 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide Refreshing the PC IP Address After you complete Express Setup, yo u should refresh the PC IP ad dress: • For a dy namically assigned IP address, di sconnect the PC from th e switch, and reconnect the PC to the netw ork. The network DHCP serv er as[...]

Cisco IE 3000 Switch Getting Started Guide 10 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 3. Use the de vice manager to perform basic switch confi guration an d monitoring. See the d e vice manager online help for mo re information. 4. For more adv anced configuration, do wnload and run the Cisco Network Assistant, which is described in [...]

11 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide Using the Switch Console Port: Follo w these steps: 1. Connect the supplied RJ- 45-to-DB-9 ad apter cable (conso le cable) to the standard 9-pin serial port on the PC. Connect the other end of the cab le to the console port on the switch. 2. Start [...]

Cisco IE 3000 Switch Getting Started Guide 12 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 • Attaching the Po wer and Relay Connector , page 20 • Optional Procedures, page 21 Equipment That You Supply Obtain these necessary tools and equipment: • Ratcheting to rque flathead scre wdri ve r that ex erts up to 15-inch pound (in-lb ) of[...]

13 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide • Airflo w around the switch an d through the v ents is unrestricted. T o pre v ent the switch from overheating, thes e must be the minimum cl earances: – T op and bottom: 4.1 3 in. (105 mm) – Left and right: 3.54 in. (90 mm) – Front: 2.56 [...]

Cisco IE 3000 Switch Getting Started Guide 14 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 War n in g This unit is intended for installation in restricted access areas. A restricted access area can b e accessed only through the use of a speci al tool, lock and key , or other means of security . Statement 1017 War n in g This equipment mus[...]

15 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide War n in g When used in a Class I, Division 2, haza rdous location, this equipment must be mounted in a suitable enclosure with proper wiring method, for all power , input and output wiring, that complies with the governing electrical codes and in [...]

Cisco IE 3000 Switch Getting Started Guide 16 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 Mounting the Switch to a DIN Rail or to the Rack Adapter Foll o w these steps to mount the swit ch on a DIN rail or in a rack. Step 1 If you are moun ting th e switch in a rack, f irst secure the Cisco IE 3000 rack adapter to the ra ck. If mounting [...]

17 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide Grounding the Switch Foll o w these steps to conn ect the switch to a pr otecti ve ground. War n in g This equipment must be grounded. Neve r defeat the ground conductor or operate the equipm ent in the absence of a suitably installed ground co ndu[...]

Cisco IE 3000 Switch Getting Started Guide 18 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 Wiring the DC Power Source Follo w these steps to prepare the DC power cable. War n in g Before performing any of the following procedures, ensure that power is removed from the DC circuit. Statement 1003 Step 3 Insert the g round wire into the ring[...]

19 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide War n in g This product relies o n the building’ s installation for sho rt-circuit (overcurrent) protection. Ensu re that the prote ctive device is rated not greater than: 5A. Statement 1005 War n in g Only trained and qualifie d personnel should[...]

Cisco IE 3000 Switch Getting Started Guide 20 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 Attaching the Power and Relay Connector Foll o w these steps to connect t he DC po wer and relay conn ector to the switch: Caution The input v oltage source of the alarm circ uits must be an isolated source and limited to less than or equal to 30 VD[...]

21 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide Optional Procedures For detailed in struction s on these procedures, see the Cisco IE 3000 Swi tch H a rd w a re I n s t a l l a t i o n G u i d e on Cisco. com. • W iring the e xternal alarm relays • Connecting the swi tch to the optional PWR-[...]

Cisco IE 3000 Switch Getting Started Guide 22 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 Connecting to 10/100 and 10/100/1000 Ports Follo w these steps: For si mplif ied cablin g, the automatic med ium-dependent interf ace crossover (auto-MDIX) feature i s enabled b y def ault on the switch. W i th auto-MDIX enabled, the switch det ects[...]

23 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide Installing SFP Modules and Connecting to Ports Follo w these steps: For a li st of supported modules, see th e release notes on Cisco.co m. For detai led instructions on installing, remo ving, and connecting to SFP modu les, see the documentation t[...]

Cisco IE 3000 Switch Getting Started Guide 24 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 Connecting to Dual-Purpose Ports Only one port on a dual -purpose port can b e acti ve at a time. If both po rts are connected, the SFP module port has prior ity . Follo w these steps: Connecting to 100BASE-FX Ports Follo w these steps: Verifying Po[...]

25 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide In Case of Difficulty See these sections if you ha ve dif ficulty setting up your switch: • T roubleshooting Expr ess Setup, page 25 • Resetting the Switch, page 26 • Accessing Online Hel p, page 27 • For More Infor mation, page 27 Troubles[...]

Cisco IE 3000 Switch Getting Started Guide 26 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 Resetting the Switch Follo w these steps to return your switch to the factory default settings. These are reasons why you migh t want to reset t he switch: • Y ou installed the switch in your networ k and cannot connect to it because you assigned [...]

27 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide Accessing Online Help First look for a sol ution to your pro blem in the trou bleshooting section o f the switch hardw are installation guide or the switch softwa re conf iguration guid e on Cisco.com. Y ou can also access the Cisc o T echnical Sup[...]

Cisco IE 3000 Switch Getting Started Guide 28 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 Obtaining Documentation and Submitting a Service Request For i nformation on obtaining documentation, submittin g a service request, and gathering addi tional information, see t he monthly Wha t’ s Ne w in Cisco P r oduct Documentation , which als[...]

29 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide Note Y ou m ust hav e Adobe Acro bat Reader to v ie w and print PDF files. Y ou can do wnload the reader from Adobe’ s website: http://www .adobe.com 3. T o read translat ed and localized w arranty inform ation abou t your product, follo w these [...]

Cisco IE 3000 Switch Getting Started Guide 30 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 To Receive a Return Materials Authorization (RMA) Number Contact the comp any from whom you purc hased the product. If yo u purchased the product directly from Cisco, contact your Cisco Sales and Service Representativ e. Complete the informatio n be[...]

31 Cisco IE 3000 Sw itch Getting Started Guide OL-16234-01 Cisco IE 3000 Switch Getting Started Guide[...]

Cisco IE 3000 Switch Getting Started Guide 32 Cisco IE 3000 Switch Getting Started Guide OL-16234-01 CCDE, CCENT, Cisco E os, Cisco Lumin, Cisco Stadiu mVision, the Cisco logo, DCE, and Wel come to the Human Network are trademarks; Changing the Way We Work, Live, Pl ay, and Learn is a service mark; and Access Registrar, Aironet, AsyncOS, Bri nging [...]