Husqvarna 917.37581 manuale d’uso

Model No . 917.375810 CA UTION: Read and f ollow all Saf ety Rules and In struc tions bef ore operating this equipment Owner’ s Manual R O T AR Y LA WN MO WER 6.75 Horsepo wer P o wer-Propelled 22" Multi-Cut Husqv ar na, Charlotte, NC 28269 U .S.A. Visit our website: www .husqvarna.com[...]

2 W arranty ................................................... 2 Saf e ty Rules .......................................... 2-4 Prod uct Spec i fi ca tions .............................. 5 Assembly / Pre-Oper ation ........................ 6 Op er a tion ............................................. 7-11 Maintenance Sched ule .....................[...]

3 DO: • Mow across the f ace of slopes: ne v er up and down. Ex ercise extreme caution when changing direction on slopes. • Remov e obstacles such as rocks , tree limbs, etc. • W atch f or holes, ruts, or b umps. T all grass can hide obstacles . DO NO T : • Do not trim near drop-offs, ditches or embankments. The operator could lose f ooting[...]

4 W ARRANTY SECTION 1: LIMITED W ARRANTY Husqvarna F orest & Garden Company (“Husqvarna”) warrants Husqv arna product to the or iginal purchaser to be free from def ects in mater ial and workmanship from the date of purchase f or the “W arranty P er iod” of the product as set f or th below: 2 YEAR NON-COMMERCIAL W ARRANTY : Automatic Mo[...]

5 Serial Number : Date of Purchase: Gasoline Capacity / T ype: 1.6 Quar ts (Unleaded Regular) Oil T ype (API SG–SL): SAE 30 (above 32°F); SAE 5W -30 (below 32°F) Oil Capacity: 20 Ounces Spark Plug (Gap: .030") Champion J19LM or RJ19LM Blade Bolt T orque: 35-40 ft. lbs . • The model and serial numbers will be f ound on a decal on the rear[...]

6 ASSEMBL Y / PRE-OPERA TION Read these instructions and this manual in its entirety bef ore you attempt to assemb le or operate y our new la wn mower . IMPORT ANT : This lawn mo wer is shipped WITHOUT OIL OR GASOLINE in the engine. Y our new lawn mo wer has been as sem bled at the f actor y with the e xception of those par ts left unassembled f or[...]

7 Wheel adjuster (on each wheel) IMPORT ANT : This lawn mo wer is shipped WITHOUT OIL OR GASOLINE in the engine. KNO W Y OUR LA WN MO WER READ THIS OWNER'S MANU AL AND ALL SAFETY R ULES BEFORE OP ER AT ING Y OUR LA WN MO WER. Compare the illustrations with your la wn mower to f amiliar iz e yourself with the location of v ar ious controls and [...]

8 1. T ur n unit off and disconnect spark plug wire from spark plug. 2. T ur n nut on underside of driv e control to increase drive speed. 3. Operate mo wer to test drive speed. Readjust as required. 4. If condition f ails to improv e after the abov e steps (f orward speed remains the same), your driv e belt is wor n and should be re placed. The op[...]

9 Open mulcher door Discharge defl ector Mulcher plug SIDE DIS CHARG ING • Mulcher plug must be installed into rear discharge open ing of mower . • Open mulcher door and install dis- charge defl ector under door as sho wn. • Mow er is now ready f or discharging operation. • T o conv er t to mulching or bagging operation, dis charge defl [...]

10 NO TE: Initial oil fi ll requires only 18 oz. due to residual oil in engine from the manuf acturers 100% quality testing. When changing oil you ma y need 20 oz. 4. Inser t and tighten dipstick. IMPORT ANT : • Check oil le vel bef ore each use. Add oil if needed. Fill to full line on dipstick. • Change the oil after e very 25 hours of operat[...]

11 MULCHING MO WING TIPS IMPORT ANT : F or best performance, keep mo wer housing free of b uilt-up grass and tr ash. See “CLEANING” in the Maintenance section of this manual. • The special mulching b lade will recut the grass clip pings many times and reduce them in size so that as the y f all onto the lawn the y will disperse into the grass [...]

12 GENERAL REC OM MEN DA TIONS The warr anty on this lawn mow er does not cov er items that hav e been sub ject ed to operator ab use or negligence. T o receiv e full v alue from the warranty , operator m ust maintain unit as in str uct ed in this manual. Some adjustments will need to be made periodically to proper ly maintain y our unit. At least [...]

13 4. Use bloc k of wood between blade and lawn mo wer housing and tighten the blade bolt, turning clockwise . • The recommended tightening torque is 35-40 ft. lbs. IMPORT ANT : Blade bolt is heat treated. If bolt needs replacing, replace only with approv ed bolt shown in the Repair P ar ts section of this manual. T O SHARPEN BLADE NO TE : We do [...]

14 7. Continue adding small amounts of oil, rechecking the dipstic k until oil le vel settles at FULL. DO NO T ov erfi ll, or engine will smoke hea vily from the muf- fl er on star tup . 8. Alwa ys be sure to retighten oil dipstick bef ore star ting engine. 9. Re con nect spar k plug wire to spark plug. AIR FIL TER Y our engine will not r un prop[...]

15 T O ADJUST HANDLE The handle can be mounted in a high or low position. The mounting holes in the bottom of low er handle are off center for raising or lo wering the handle. 1. Remov e upper handle and wire tie(s) securing cable(s) to low er handle. 2. Remov e hair pin cotters from lower handle brac ket mount ing pin. 3. Squeeze lo wer handle in [...]

16 your la wn mow er to a Husqvarna or other qualifi ed service center for repair and/or ad just ment. IMPORT ANT : Nev er tamper with the engine gov er nor , which is f actor y set f or proper engine speed. Ov er speed ing the engine abov e the f actor y high speed setting can be dangerous. If y ou think the engine-gov er ned high speed needs adj[...]

17 gum deposits during stor age . Add stabilizer to gasoline in fuel tank or storage container . Alwa ys follo w the mix ratio f ound on stabilizer container . Run engine at least 10 min utes after adding stabilizer to allo w the stabilizer to reach the carburetor . Do not empty the gas tank and carburetor if using fuel stabiliz er . ENGINE OIL Dra[...]

18 Loss of power 1. Rear of mower housing or 1. Raise cutting height. blade dr agging in grass . 2. Cutting too much gr ass. 2. Raise cutting height. 3. Dir ty air fi lter . 3. Clean/replace air fi lter . 4. Buildup of grass , leav es, 4. Clean underside of mower and trash under mo wer . housing. 5. T oo much oil in engine. 5. Check oil le vel. 6[...]

36 HUSQV ARNA RO T AR Y LA WN MO WER - - MODEL NUMBER 917.375810 REP AIR P AR TS[...]

37 HUSQV ARNA RO T AR Y LA WN MO WER - - MODEL NUMBER 917.375810 KEY P ART NO . NO. DESCRIPTION KEY P ART NO . NO. DESCRIPTION 1 196403 Upper Handle Assemb ly (Includes Foam Grip) 2 183567 Engine Zone Control Cab le 3 850733X004 Brac ket, Upstop 4 166649 Mulcher Plug 5 66426 Wire Tie 6 189713X418 Handle Knob 7 750634 Scre w 8 194580X422 Control Bar[...]

38 HUSQV ARNA RO T AR Y LA WN MO WER - - MODEL NUMBER 917.375810[...]

39 HUSQV ARNA RO T AR Y LA WN MO WER - - MODEL NUMBER 917.375810 NO TE: All component dimensions given in U .S. inches. 1 inch = 25.4 mm. IMPORT ANT: Use only Original Equipment Manuf acturer (O .E.M.) replacement par ts. F ailure to do so could be hazardous, damage your la wn mower and v oid your warr anty . KEY P ART NO . NO. DESCRIPTION KEY P AR[...]

40 MODEL NUMBER 125K02-0654-E1 BRIGGS & STRA TT ON 4-CYCLE ENGINE 307 13 337 635 383 3 306 11 9 10 54 50 51 7 5 585 684 287 525 524 842 1 8 847 523 27 27 32 26 28 25 29 40 40 35 36 33 45 34 45 24 741 16 20 12 22 46 43 15 4 32A 718 868 2 871 870 869 584[...]

41 MODEL NUMBER 125K02-0654-E1 BRIGGS & STRA TT ON 4-CYCLE ENGINE 104 137 276 95 127 633 617 276 130 365 125 134 975 133 11 7 163 968 445 425 443 163 529 966 976 188 104 137 276 127 633 121 CARBURETOR OVERHAUL KIT 617 137 633 617 977 CARBURETOR GASKET SET 163 163 134 668 621 222 276 11 8 97 334 851 333 202 209 356 562 505 227 616 404 615 922 62[...]

42 MODEL NUMBER 125K02-0654-E1 BRIGGS & STRA TT ON 4-CYCLE ENGINE 332 304 305 363 455 23 55 456 58 60 459 689 597 608 65 592 969 190 670 957 972 1059 121 1 1210 601 187 78 37 613 81 300 604 564 1329 REPLACEMENT ENGINE 1330 REP AIR MANUAL 1058 OWNER’S MANUAL 1036 EMISSIONS LABEL 921 KEY P ART NO . NO . DESCRIPTION 1 697322 Cylinder Assembly 2 [...]

43 MODEL NUMBER 125K02-0654-E1 BRIGGS & STRA TT ON 4-CYCLE ENGINE KEY P ART NO . NO . DESCRIPTION 81 691740 Lock-Muffl er Screw 95 691636 Screw (Throttle V alv e) 97 696565 Shaft-Throttle 104 691242 Ø Pin-Float Hinge 117 498978 Jet-Main (Standard) 118 494870 Jet-Main (High Altitude) 121 498260 Kit-Carburetor Ov erhaul 125 498170 Carburetor 12[...]

SER VICE NO TES[...]

402548 Re v . 4 05.16.06 BY Printed in U .S.A. Para pedir s ervicio de reparac ión a dom icilio, y para ordenar piezas : 1-888-SU-HO GA R ® (1-888-784-6427) Au Canada pour ser vice en français: 1-800-LE- FOYER MC (1-800-533-6937) ww w.sea rs.ca To purchase a protection ag reement (U.S.A.) or mai ntenance agreement (Canada) o n a produ c t servic[...]