JVC NX-PN7 manuale d’uso

COMPACT COMPONENT SYSTEM NX-PN7 INSTRUCTIONS LVT1864-001 A [J] For customer use: Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. Model No. Serial No. cover_UX-PN7[J].fm Pa ge 1 Tuesday , April 15, 2008 1:57 PM[...]

G-1 Warnings, Cautions and Others Mises en garde, précautions et indications diverses The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric sh[...]

G-2 Note to CATV system insta ller: This reminder is provided to call the CATV system installer’s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as p ractical. [...]

G-3 Caution: Proper Ventilation To avoid risk of electric shoc k and fire, and to pre vent damage, locate the apparatus as follows: 1. Front: No obstructions and open spacing. 2. Sides/Top/Back: No obstructions should be placed in the areas s hown by the dimensions below. 3. Bottom: Place on the level surface. Maintain an adequate air path for vent[...]

1 Contents Introduction ........................ .................... ..... 2 Precautions ............ ............ ......... ............. ............ ...... 2 Getting Started ............... .................... ......... 3 Connections ............ ............ ......... ............. ............ ...... 4 Canceling the Display Demonstration ...[...]

2 Introduction Thank you for purcha sing a JVC product. Please read a ll instructions care fully before opera tion, to ensure yo ur complete unde rstanding and to obtain the best possible performa nce from the unit. Precautions Installation • Install in a plac e which is leve l, dry and neither too hot nor too cold—be tween 5°C and 35°C (41°[...]

3 Getting Started Supplied Accessories After unpacking, chec k to be sure that you have all the following items. Th e number in parentheses indica tes the quantity of each piece supplied. • Remote control (1) • Lithium coin battery CR2025 (1) (The battery has been installe d when shipped from the factory.) • FM antenna (1) • AM loop antenna[...]

4 Connections Connecting the Antenn as NOTES: • Make sure the FM antenna doe s not touch any other terminals, conne cting cords or the AC power cord. Also, keep the antenna away from me tallic parts of the unit, connect ing cords, and the AC power cord. This could cause poor re ception. • Keep the AM loop antenna cabl e wrapped around the AM lo[...]

5 Connecting the Video Cord to View a Video/Pictur e from iPod When viewing a video/picture from your iPod on your TV, use a comp osite video cord (not supplied) to conne ct the VIDEO OUT jack on the uni t and the compo site video input on your TV. Connecting the Power Cord Canceling the Display Demonstration When you connect the AC power cord for [...]

6 Basic Operations Main Unit Operating on the Main Unit Buttons Functions Turns on or off (standby) the power. Changes the color of the illum ination bars. (P.10) • For DEMO button, see page 5. Activates Sound Turbo. (P.10) Changes the source to FM, AM (P.15), or AUDIO IN (P.17). Display (P.7) STANDBY lamp Remote control sensor Dock A (P.12) Dock[...]

7 Display Information • Changes the source to iPod /iPod . (P.13) • Starts playback and pauses for iPod. (P.13) • iPod (P.13): Press: Reverse skip/forward skip Hold down: Reverse sea rch/forward searc h • FM/AM (P.15): Tunes in to a station. Adjusts the volume le vel (VOL MIN/VOL 1 to VOL 29/VOL MAX). Symbols Description iPod Lights up when[...]

8 Using Headphones Be sure to turn down the volume before conne cting headphones. • Connecting headphones will dea ctivate the speake rs. Remote Control Operating on the Remote Control Basic operations Buttons Main funct ions Turns on or off (standby) the power. Right side Stereo mini plug Headphones (not supplied) P.9 P.10 P.14 P.14, P.15 P.10 P[...]

9 To dim the display and the illu mination bars—DIMM ER You can change the brightness of the display and i llumination bars. To set the ECO mode Setting the ECO mode all ows you to reduce power consumpti on by turning off the display while on standby. • To cancel this function, press ECO/DIMMER again . “ECO OFF” appears for a while then the[...]

10 To change the color of the illumina tion bars You can change the color of th e illumination bars. • The color is memorize d for each source. • When the source is iPod or iPod , you can set the color of each illumin ation bar separately: the bar below the source iPod. To turn off the unit after a certain period of time—Sleep Timer • To ch[...]

11 Playing Back from iPod You can connect 2 iPod device s to the unit and enjoy sound and video from the iPod. Compatible iPod Types: * Only for still picture. If the iPod does not play correctly, upda te your iPod software to the latest version. • For details about updating your iPod, check on the Apple web site <http://www.apple.com>. iPo[...]

12 Connecting iPod Devices Connect the iPod t o dock A or B on the unit. You can have 2 iPod devices connecte d at the same time. • Make sure the unit is on standby when you connect a n iPod. NOTES: • Be careful not to dama ge the termina l on the dock whe n connecting/di sconnecting the i Pod. • Close the cover of the doc k when you do not c[...]

13 Operations For details, refer also to the instruc tion manual for iPod. *1 Not available for iPhone and i Pod touch. *2 Not equipped with iPhone and iPod t ouch. NOTES: • Before viewing a video/pic ture from your iPod on your TV, ma ke the appropriate vide o setting on the iPod. For detai ls of the sett ing, see the instruct ion manual for iPo[...]

14 * Not equipped with iPhone and iPod touch. NOTES: • JVC is not responsible for any loss of or damage to iPod that might result from the use of this product. • Do not touch or hit the terminals of the dock and of the iPod. It might cause damage to these terminals. • When you connect your iPod to the dock, ma ke sure the terminal on the doc [...]

15 Listening to FM/AM Broadcasts Basic Operations Buttons Function s On the Unit On the remote Selects FM or AM as the source. When an FM programme is broadcast in stereo, ST (stere o) lights up on the display (only when the rece ption is good). Press: Changes the frequency. Hold down and release: The unit starts sea rching for stations and stops w[...]

16 Presetting Stations You can preset 30 FM st ations and 15 AM st ations. NOTES: • When you unplug the AC powe r cord or if a power fa ilure occurs, the preset sta tions will be erase d in a few days. • If you store a new station ont o an occupied pre set number, the sta tion previously stor ed on that number will be erased. 1 Select FM or AM [...]

17 Playing Back from Other Equipment Connecting Other Equipment By using a stereo mini plug cord (not supplied), you can connec t other equipment with ana log audio output jacks, such as a portable audio playe r, etc. • Refer to the instruction manua l supplied with the equipment. NOTE: Make sure the unit is on standby when connecting or disco nn[...]

18 Setting the Clock and Timer Setting the Clock Set the built-in clock before using the Timer. • You can set the clock when the unit is turned on or on standby • To exit from the clock set ting, press CLOCK/TIMER as re quired. • To correct a misent ry during the process, press MENU/CANCEL. You can re turn to the previous step. • If there i[...]

19 Setting the Timer Using the Timer, y ou can wake u p with music, etc. • When using an iPod or other equipme nt as the playbac k source, connect it t o the unit beforehand. (P.12, P.17) • You can set the Tim er when the unit is turned on or on standby. • The unit is turned off automaticall y 2 hours after it is turned on by the Timer. 1 Act[...]

20 • To exit from the timer setti ng, press CLOCK/TIMER as required. • To correct a misent ry during the process, press MENU/CANCEL. You can re turn to the previous step. To cancel the Timer NOTE: The settings you have made are me morized though you cancel the Timer. 5 1 Adjust the hour then the minute for the on-time. 2 Select a playb ack sour[...]

21 Troubleshooting If you are having a proble m with your unit, check t his list for a possible solution befor e calling for service. General Power does not come on. The power plug is not inserted securely . Plug it in securely. (P.5) Adjustments or settings are sudd enly cancelled before you finish. There is a t ime limit. Re peat the proce dure a[...]

22 Specifications Accessories See page 3. Amplifier Output Power – without iPod 7.5 W per channel, min. RMS, driven into 8 Ω at 1 kHz, with no more than 10% total harmonic distortion – with an iPod 7.0 W per channel, min. RMS, driven into 8 Ω at 1 kHz, with no more than 10% total harmonic distortion – with two iPod devices 6.3 W per chann[...]

warranty_UX-PN7[J].fm Page 1 Thursday , January 10, 2008 9:55 AM[...]

warranty_UX-PN7[J].fm Page 2 Thursday , January 10, 2008 9:55 AM[...]

NX-PN7 COMPACT COMPONENT SYSTEM EN © 2008 Victor Company of Japan, Limited 0408YAMMDWBET cover_UX-PN7[J].fm Pa ge 2 Tuesday , April 15, 2008 1:57 PM[...]