-
Pagina 1
Operating and installation instructions Refrigerator with Dynamic cooling K 12820 SD edt To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. M.-Nr. 07 753 450 e n-G B[...]
-
Pagina 2
Guide to the appliance .............................................4 Caring for the environment ..........................................6 Warning and Safety instructions .....................................7 How to save energy ...............................................1 2 Switching on and off ..............................................1[...]
-
Pagina 3
Installation ......................................................3 0 Side-by-side installation .............................................3 0 Location .........................................................3 0 Climate range ..................................................3 0 Ventilation ......................................................[...]
-
Pagina 4
a On/Off button b Temperature selector button c Temperature display d Super cool button and indicator light e Dynamic cooling button and indicator light Guide to the appliance 4[...]
-
Pagina 5
a Dynamic cooling fan b Butter and cheese compartment c Egg tray d Adjustable shelves e Bottle rack f Bottle shelf g Condensate channel and drain hole h Fruit and vegetable containers Guide to the appliance 5[...]
-
Pagina 6
Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and can normally be recycled. Ensure that any plastic wrappings, bags etc. are disposed of safely and kept out of the reach of babies and young children. Danger of suffocation! Rather than just thro[...]
-
Pagina 7
This appliance complies with all relevant local and national safety requirements. Improper use can, however, present a risk of both personal injury and material damage. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before installation and before using it for the first time. They contain importa[...]
-
Pagina 8
Technical safety ~ Before setting up the appliance, check it for any externally visible damage. Do not install and use a damaged appliance. A damaged appliance is dangerous. ~ If the connection cable is faulty it must only be replaced by a service technician authorised by the manufacturer to protect the user from danger. ~ This appliance contains t[...]
-
Pagina 9
~ The electrical safety of this appliance can only be guaranteed when continuity is complete between it and an effective earthing system which complies with current local and national safety regulations. It is most important that this basic safety requirement is present and tested regularly, and where there is any doubt, the household wiring system[...]
-
Pagina 10
Correct use ~ Never store explosive materials in the appliance or any products containing propellants (e.g. spray cans). Thermostats switching on may produce sparks which could present a fire hazard. Flammable compounds could explode. ~ Do not operate any electrical equipment (e.g. an electric ice-cream maker) inside the appliance. Danger of sparki[...]
-
Pagina 11
Disposal of your old appliance ~ Before disposing of an old appliance, first make the door latch or lock unusable. This way you will prevent children from accidentally locking themselves in and endangering their lives. ~ Be careful not to damage any part of the pipework whilst awaiting disposal, e.g. by – puncturing the refrigerant channels in th[...]
-
Pagina 12
Normal energy consumption Increased energy consumption Installation site In a ventilated room. In an enclosed, unventilated room. Protected from direct sunlight. In direct sunlight. Not situated near to a heat source (radiator, oven). Situated near to a heat source (radiator, oven). Where the ideal ambient room temperature is approx. 20°C. Where t[...]
-
Pagina 13
Before using for the first time The stainless steel door (and sides, depending on model) and the stainless steel trim to the interior shelves and the door shelves have a layer of protective foil to prevent damage during transportation. ^ Do not remove this foil until the appliance has been installed or built in. ^ After removing the protective foil[...]
-
Pagina 14
It is very important to set the correct temperature for storing food in the appliance. Micro-organisms will cause food which is not stored at the correct temperature to deteriorate rapidly. Temperature influences the growth rate of these micro-organisms. Reducing the temperature reduces their growth rate. The temperature in the appliance will rise:[...]
-
Pagina 15
Super cool The Super cool function can be used to rapidly reduce the temperature in the refrigerator section to its lowest setting (depending on the room temperature). Switching on Super cool Super cool is particularly recommended for faster chilling of large amounts of fresh food or drink. ^ Press the Super cool button. The Super cool indicator li[...]
-
Pagina 16
Switching off Dynamic cooling ^ Press the Dynamic cooling button m . The Dynamic cooling indicator light will go out. The fan automatically switches off when the door is open. Super cool and Dynamic cooling 16[...]
-
Pagina 17
Different storage zones Due to the natural circulation of the air in the appliance, there are different temperature zones in the refrigerator. Cold, heavy air sinks to the lowest section of the appliance. Make use of the different zones when placing food in the appliance. This appliance has Dynamic cooling, which helps to keep an even temperature w[...]
-
Pagina 18
Food which should not be stored in a refrigerator Not all food is suitable for refrigeration, as some food is sensitive to cold. Cucumbers, for example, become glassy, aubergines bitter and potatoes sweet. Tomatoes and oranges lose their aroma, and the peel on citrus fruit hardens. Food which should not be stored in a refrigerator includes: – pin[...]
-
Pagina 19
– Examples of fruit and vegetables which react strongly to the natural gases given off by other types of fruit and vegetables are: Kiwis, broccoli, cauliflower, brussels sprouts, mangos, honeydew melons, apples, apricots, cucumbers, tomatoes, pears, nectarines and peaches. Example : Broccoli should not be stored with apples, as apples produce a l[...]
-
Pagina 20
Moving the shelves The shelves can be adjusted according to the height of the food. ^ Raise the shelf, and pull it forwards slightly until the notch at the side is in line with the shelf support. It can then be raised or lowered to the required level. The raised edge at the back must face upwards to prevent food from touching the back of the applia[...]
-
Pagina 21
Fruit and vegetable containers The fruit and vegetable containers are pushed in and out on telescopic runners, and can be completely removed if necessary. ^ Pull the container right out and then lift it up and off. Push the runners back in again to avoid injury or damage. To replace a container, ^ place it back on the fully extended runners a . The[...]
-
Pagina 22
The refrigerator defrosts automatically. Condensate and frost can build up on the back wall of the refrigerator whilst it is in use. You do not need to remove this, as it will defrost and evaporate automatically with the warmth generated by the appliance. The condensate is drained away via a channel and drain hole into an evaporation system at the [...]
-
Pagina 23
^ A range of Miele branded cleaning and conditioning agents is available from the Miele UK Spare Parts Department or via the internet at www.miele-shop.com. Never use cleaning agents containing abrasive substances such as sand, soda, acids or chemical solvents. "Non-abrasive" cleaning agents are also unsuitable as they can cause matt area[...]
-
Pagina 24
Ventilation gaps ^ The ventilation gaps should be cleaned regularly with a brush or vacuum cleaner. A build-up of dust will increase the energy consumption of the appliance. Door seal Do not use any oils or grease on the door seal as these will cause the seal to deteriorate and become porous over time. The door seal should be cleaned regularly with[...]
-
Pagina 25
Repairs to electrical appliances should only be carried out by a suitably qualified and competent person in strict accordance with current local and national safety regulations. Repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work. What to do i f... . . . the appliance does n[...]
-
Pagina 26
^ Unscrew the lamp b and replace it with a new one. Lamp specification: 220 - 240 V, E 14 fitting See the old lamp for the Wattage required. ^ Replace the lamp cover a . . . . the floor of the refrigerator is wet. The drain hole is blocked. ^ Clean the condensate channel and drain hole. If you still cannot remedy the fault having followed these sug[...]
-
Pagina 27
Normal noises What causes them Brrrrr... Humming noise made by the motor (compressor). This noise can get louder for brief periods when the motor is switching on. Blubb, blubb.... A gurgling noise can be heard when coolant is circulating through the pipes. Click.... Clicking sounds are made when the thermostat switches the motor on and off. Sssrrrr[...]
-
Pagina 28
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – your Miele Dealer or – Miele (see back cover for contact details). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. This information is given on the data plate inside your applianc[...]
-
Pagina 29
Electrical connection U.K. All electrical work should be carried out by a suitably qualified and competent person in strict accordance with current local and national safety regulations (BS 7671 in the UK). The appliance is supplied with a mains cable and moulded plug ready for connection to an a.c. single phase 220-240 V 50 Hz supply. Please ensur[...]
-
Pagina 30
Do not place any appliance which gives off heat, such as a toaster or microwave oven, on top of this appliance, as this would increase the appliance's energy consumption. Side-by-side installation To avoid a build-up of condensation and resultant damage, refrigerators and freezers should not generally be installed side-by-side next to other su[...]
-
Pagina 31
Ventilation Air at the back of the appliance gets warm. To ensure sufficient ventilation, the air inlet and outlet must not be covered or blocked in any way. They should be dusted on a regular basis. Installation ^ Remove the cable clip from the back of the appliance. ^ Check that all parts at the back of the appliance are unhindered. Carefully rem[...]
-
Pagina 32
Appliance dimensions ABC K 12820 SD ed 1850 mm 600 mm 630 mm Installation 32[...]
-
Pagina 33
The appliance is supplied right-hand hinged. If left hand door hinging is required, follow the instructions below. To change the door hinging you will need the following tools : – a cross-slotted screwdriver, – a flat-bladed screwdriver, – a selection of Torx screwdrivers, – a spanner. Two people are needed for changing the door hinging. Re[...]
-
Pagina 34
Changing over the door Make sure the door shelves are empty! ^ Close the appliance door. ^ Remove cover a by sliding it forwards from the back and then lifting it off. ^ Remove cover b by pulling it upwards. Caution. The door is not secure as soon as the hinge plate is removed. ^ Loosen screws d in upper hinge plate c and pull it upwards and off. ^[...]
-
Pagina 35
^ Remove cap h from the bearing bush in the door and refit on the opposite side. ^ Using a screwdriver, remove spring clamp i from underneath the door and fit it on the opposite side. ^ Remove cover a by pulling it forwards. ^ Pull cover b off. ^ Screw the foot into hinge pin c as far as it will go. ^ With the help of another person, carefully tilt[...]
-
Pagina 36
^ Screw hinge plate f into position on the opposite side using the two outer long slots only. Do not use the middle hole because you will not be able to align the door later on. ^ Refit cover b . ^ With the help of another person, carefully tip the appliance back and refit hinge pin c from below into hinge plate f on the left hand side. The notch a[...]
-
Pagina 37
Refitting the handle Please make sure you follow the instructions below carefully when you refit the handle. The door seal will be damaged if the handle is fitted incorrectly. ^ Loosely attach the handle to the opposite side of the door with the two front screws b . Mounting plate c must be positioned on the side of the door so that when the door i[...]
-
Pagina 38
The appliance door can be aligned to the housing using the outer long slots in the lower hinge plate. In the following illustration the door is not shown in the closed position to make it easier to see what you have to do. ^ Remove centre screw a from the hinge plate. ^ Slightly loosen both outer screws b . ^ Align the door by sliding the hinge pla[...]
-
Pagina 39
a Top box b Appliance c Housing unit d Wall The appliance can be installed in a kitchen run. To match the height of the rest of the kitchen, the appliance can be fitted with a suitable top box a . A ventilation gap of at least 50 mm depth must be allowed for behind the appliance across the entire width of the top box for air to circulate. The cross[...]
-
Pagina 40
Alteration rights reserved / 5109 K 12820 SD edt M.-Nr. 07 753 450 / 00[...]