Sony TA-AV571 manuale d’uso

1 Getting Started © 1997 by Sony Corporation 3-859-326- 11 (1) Operating Instructions T A-A V571 Integrated A V Amplifier Read this book first[...]

2 Getting Started WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. CAUTION TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS POLARIZED AC PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. INFORMATION This equipment has been tested and found to comp[...]

3 Getting Started T ABLE OF CONTENTS Getting Started Unpacking ....................................................................................................... 4 Hookup Overview ......................................................................................... 4 Audio/Video Component Hookups ...........................................[...]

4 Getting Started Unpacking Check that you received the following items with the amplifier: • Remote controller (remote) (1) • Size AA (R6) batteries (2) Inserting batteries into the remote Insert two size AA (R6) batteries in accordance with the + and – marking on the battery compartment. When using the remote, point it at the remote sensor [...]

5 Getting Started Tuner Tape deck Turntable • If your turntable has an earth lead To prevent hum, connect the earth lead to the y ground terminal on the amplifier. (continued) Amplifier Audio/V ideo Component Hookups Overview This section describes how to connect your audio and video (audio signal only) components to the amplifier, so you can lis[...]

6 Getting Started Speaker System Hookups Overview This section describes how to connect your speakers to the amplifier. Front (left and right) speakers are required but center and rear speakers are optional. The center and rear speakers enhance the surround effects. Connecting the active woofer will increase bass response. For specific locations of[...]

7 Getting Started Hookups Front speakers Rear and center speakers Active woofer Where do I go next? Go on to the next section to connect the AC power cord and complete your home theater system. / A C Hookups Connecting the AC power cord Connect the AC power cord from this amplifier and from your audio/video components to wall outlets. If you connec[...]

8 Amplifier Operations 4 Turn MASTER VOLUME to adjust the volume. * You cannot use the DBFB when you select PHONO. When you listen with headphones Connect the headphones to the PHONES jack. No sound is heard from your speakers. Selecting a Component To listen to a connected component, first select the function on the amplifier or with the remote. ?[...]

9 Amplifier Operations Recor ding This amplifier makes it easy to record to and from the components connected to the amplifier. You don’t have to connect playback and recording components directly: once you select a program source on the amplifier, you can record and edit as you normally would using the controls on each component. Before you begi[...]

10 Using Sound Fields When you use the remote Z The remote also lets you choose the surround mode. 1 Press SURROUND MODE repeatedly until the surround mode you wish to is displayed. Each time SURROUND MODE is pressed, the display changes as follows: To turn off surround sound Press SURROUND ON/OFF. You can find Dolby Surround-encoded software by lo[...]

11 Using Sound Fields Getting the Most Out of Dolby Pr o Logic Surround Sound To obtain the best possible Dolby Pro Logic Surround sound, first select the center mode. Then, adjust the volume of each speaker. Note that you must connect the rear speakers and/or a center speaker to do the following adjustments. SURROUND ON/OFF SURROUND MODE SURROUND [...]

12 Using Sound Fields Adjusting the delay time Z You can make the surround sound more effective by delaying the output from the rear speakers (delay time). You can adjust the delay time as follows. For example, if you’ve placed the rear speakers in a large room or apart from your listening position, set the delay time shorter. 1 Start playing a p[...]

13 Using Sound Fields Using Pr eset Sound Fields You can take advantage of sound fields simply by selecting one of the five pre-programmed ones according to the program you want to play. 1 Press one of the SOUND FIELD buttons so that the sound field you wish to is displayed. Select the appropriate sound field as follows: To turn off the sound field[...]

14 Additional Information T roubleshooting If you experience any of the following difficulties while using the amplifier, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. There’s no sound or only a very low-level sound is heard. / Check that the speakers and components ar[...]

15 Additional Information Specifications Audio power specifications POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With 8 ohm loads both channels driven, from 70 - 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.9 % total harmonic distortion from 250 milliwatts to rated output. Amplifier section Surround mode (8 ohms at 1[...]

16 Additional Information Surround sound Sound that consists of three elements: direct sound, early reflected sound (early reflections) and reverberative sound (reverberation). The acoustics where you hear the sound affect the way these three sound elements are heard. These sound elements are combined in such a way that you can actually feel the si[...]

17 Controls MASTER VOLUME 8 Jacks PHONES 8 Indicators DBFB 8 DOLBY PRO LOGIC 10 SOUND CONTROL (BASS/ TREBLE/CENTER/REAR) 8 SURROUND (DOLBY/HALL/ SIMULATED) 10 Other g 4 Index A, B Adjusting delay time 12 speaker volume 12 volume 8 Audio/video component hookups 5 C Center mode 11, 16 NORMAL mode 11, 16 PHANTOM mode 11, 16 3 CH mode 11, 16 WIDE mode [...]

18 Rear Panel Descriptions 1 y ground terminal 2 REAR SPEAKERS 3 AC power cord 4 SWITCHED AC OUTLET 5 CENTER SPEAKER 6 FRONT SPEAKERS 7 MIX 8 VIDEO 1 9 VIDEO 2 0 TAPE !¡ CD !™ TUNER !£ PHONO 12 3 4 5 6 7 8 9 0 !¡ !™ !£[...]

19 For buttons not described on previous pages and buttons with names different from the buttons on the amplifier. Remote Button Descriptions Operates TV TV TV TV/VCR VCR VCR VCR Function Selects track or disc numbers. Selects track numbers over 10.* Selects track numbers.** Selects disc numbers. Selects the band. Scans and selects stations. Skips [...]

20 Sony Corporation Printed in Malaysia Quick Reference Guide Selecting a Component Example: Playing a CD Using Pr eset Sound Fields Example: Listening to classic music on a CD v Choosing a Surround Mode Example: Listening to Dolby Pro Logic Surround on a Laser disc v Start playing. v Turn on the LD player. v Start playing. Turn on the CD player. v[...]