Travis Industries Space Saver IPI Fireplace 564 manuale d’uso

564 SS IPI Fireplace • Operation • Maintenance Tested and Listed by OMNI-Test Laboratories, Inc. Beaverton, Oregon Report # 028-F-80b-5 ANSI Z21.88a-2003 WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. - Do not store or use gasoli[...]

2 Introduction © Travis Industries 4081205 100-01211_000 Introduction We welcome you as a new owner of a 564 SS gas fireplace. This manual details operation and maintenance of this fireplace. Please familiarize y ourself with the Owner's Manual before operating your heater and save the manual for future reference. Important Information No oth[...]

Introduction 3 © Travis Industries 4081205 100-01211_000 Table of Contents Introduction and Important Information Introducti on ......................................................................... 2 Important In formati on .......................................................... 2 Installation Wa rnings .....................................[...]

4 Safety Precautions © Travis Industries 4081205 100-01211_000 IF YOU SMELL GAS: * Do not light any appliance * Extinguish any open flame * Do not touch any electrical switch or plug or unplug anything * Open w indow s and vacate building * Call gas supplier from neighbor's house, if not reached, call fire department This unit must be install[...]

Safety Precautions 5 © Travis Industries 4081205 100-01211_000 Do not place clothing or other flammable items on or near the heater. Because this heater can be controlled by a thermostat there is a possibility of the heater turning on and igniting any items placed on or near it. Light the heater using the built-in igniter. Do not use matches or an[...]

6 Operation © Travis Industries 4081205 100-01211_000 Before You Begin • Read this entire manual before you use your new fireplace (especially the section "Safety Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or even death. Location of Controls Lift up and swing the l[...]

Operation 7 © Travis Industries 4081205 100-01211_000 Starting the Fireplace for the First Time • Burn the heater at a high setting with the blower off for an extended period (up to 48 hours). This will cure the painted surfaces. Fumes from the paint curing and oil burning off the steel will occur. This is normal. We recommend opening a window t[...]

8 Operation © Travis Industries 4081205 100-01211_000 Adjusting the Flame Height This fireplace has an adjustable flame to tailor the look and heat output to your specific needs. It is adjusted by turning the flame adjust knob. HIGH LOW FLAME ADJUST Accent Light This fireplace has a built-in accent light that may be turned on and off and dimmed to[...]

Operation 9 © Travis Industries 4081205 100-01211_000 Adjusting the Optional Blower Speed The blower helps transfer heat from the heater into t he room. It will not turn on until the heater is up to temperature (approximately 15 minutes after starting). See the illustration below for instructions on adjusting the blower speed. NOTE: With the rear [...]

10 Operation © Travis Industries 4081205 100-01211_000 Normal Operating Sounds Gas Control Valve As the gas control valve is turned on and off you will hear a dull clicking sound. This is the valve opening up and shutting down. Blower Snap Disk This part can produce a clicking sound as it turns the blower on and off. The appliance may creak with c[...]

Maintenance 11 © Travis Industries 4081205 100-01211_000 Maintaining Your Fireplace's Appearance Fingerprints or other marks left on the optional plated surface may become etched in place if they are not wiped clean prior to turning the fireplace on. Clean the plated surface with denatured alcohol and a soft cloth (with the fireplace cool). O[...]

12 Maintenance © Travis Industries 4081205 100-01211_000 Accent Light Replacement Two accent lights are included in your fireplace to provide additional lighting. These bulbs will burn out over time. To replace, follow the directions below: • Shut off gas to the fireplace and let it cool for 15 minutes. • Remove the glass (see page 15) and log[...]

Maintenance 13 © Travis Industries 4081205 100-01211_000 Grill Installation and Removal Follow the directions below to install. Upper Grill Installation (FPX and Avalon) Hold the grill at an angle and insert the lower slot over the lower bushing on the fireplace (both sides) Swing the grill upwards to engage the upper slot. You will need to lift t[...]

14 Maintenance © Travis Industries 4081205 100-01211_000 Face Installation and Removal Some fireplaces have a face that fits over the glass frame. The face can be removed following the directions below. Phillips Screwdriver Four screws hold the face in place. The screws are accessed through the grills on the face.[...]

Maintenance 15 © Travis Industries 4081205 100-01211_000 Glass Frame Removal and Installation Warning: The appliance must be completely cool before removing the glass. Warning: Do not strike or slam the glass. Based upon the face being used, either: (a) swing the access door down and remove the top grill, (b) remove the face (unscrew or lift off -[...]

16 Maintenance © Travis Industries 4081205 100-01211_000 Glass Frame Removal and Installation (continued) The latch can come loose from the latch assembly. This occurs only when it is rotated. Follow the directions below to re-install the latch if it comes loose. Top of Firebox Hold the latch at an angle and insert it into the slot on the glass fr[...]

Maintenance 17 © Travis Industries 4081205 100-01211_000 Log Set Installation Log Set Overview When installed, the logs should appear as shown below. Rear Lo g Ri g ht Twi g Left Lo g Left Twi g Ri g ht Lo g[...]

18 Maintenance © Travis Industries 4081205 100-01211_000 Rear Log Installation The rear log has a flat notch on both sides that center it on the grate. Place the rear log on the grate and slide it all the way back until the log contacts the end- brackets on the grate.[...]

Maintenance 19 © Travis Industries 4081205 100-01211_000 Right Log Installation The left log has a groove that fits over the grate. Note how the left side of the log rests on the burner but does not cover any burner holes.[...]

20 Maintenance © Travis Industries 4081205 100-01211_000 Left Log Installation The left log has a groove that fits over the grate. Note how the right side of the log rests on the burner but does not cover any burner holes.[...]

Maintenance 21 © Travis Industries 4081205 100-01211_000 Left Twig Installation The left twig should be positioned so the front edge contacts the grate as shown above. This hole fits over the pin on the rear log.[...]

22 Maintenance © Travis Industries 4081205 100-01211_000 Right Twig Installation The right twig has two holes for the pins on the rear and right log. When in place the right twig will a pp ear as shown above.[...]

Maintenance 23 © Travis Industries 4081205 100-01211_000 Ember Installation A bag of embers is provided to further enhance the firebox. Place the embers on the firebox floor and on the burner. Do not place embers over any of the burner holes or air channels.[...]

24 Maintenance © Travis Industries 4081205 100-01211_000 Glass Cleaning The glass may be cleaned with a non- abrasive cleaner. To clean the inside of the glass, simply remove the glass frame, place it on a non-scratching surfac e, and clean the inside surface. If the outside surface of the glass frame requires cleaning, follow the directions below[...]

Maintenance 25 © Travis Industries 4081205 100-01211_000 Troubleshooting Table Problem: Possible Cause: Don't Call for Service Until You: Main Burners Will Not Start The ON/OFF switch is turned to "OFF" The remote control is not working correctly The thermostat is disc onnected or set too low No Propane in Tank Turn the ON/OFF switc[...]

26 Maintenance © Travis Industries 4081205 100-01211_000 Wiring Diagram CN4 CN3 PILOT SENSOR SP ARK ROD DIGIT AL FIREPLACE BURNER CONTROL CN2 GROUND VAL VE COMMAND POWER CN1 DIAGNOSTIC CN0 COMFORT CONTROL AA B A TTER Y TRA Y MAIN BURNER GREENSMART PILO T CONTINUOUS PILO T AC AD APTER Comfort Control V alve Red Red Black White Green Black Red Red B[...]

Limited 7 Year Warranty 27 © Travis Industries 4081205 100-01211_000 Register your TRAVIS INDUSTRIES, INC. Limited 7 Year W arranty online at traviswarranty.com , or complete the enclosed Warranty card and mail it within ten (10) days of the appliance purchase date to: TRAVI S I NDUSTRI ES, INC., 4800 Harbour Pointe Blvd. SW, Mukilt eo, W A 98275.[...]

28 Optional Equipment © Travis Industries 4081205 100-01211_000 Accessories The accessories listed below are available at y our Travis dealer. To locate a dealer, visit: www.travisproducts.com GreenSmart™ Remote / Thermostat This accessory allows for remote control of your fireplace (burner, flame heigh t, ac cent light).. It has a built-in ther[...]

Optional Equipment 29 © Travis Industries 4081205 100-01211_000[...]

30 Index © Travis Industries 4081205 100-01211_000 Index Accent Light R eplacement .................................................. 12 Accent Li ght ........................................................................ 8 Adjusting the Fl ame Hei ght ................................................. 8 Adjusting the Optional Blower Speed ......[...]