Go to page of
Similar user manuals
-
Indoor Fireplace
Napoleon Fireplaces GDI-30P
16 pages 0.71 mb -
Indoor Fireplace
Napoleon Fireplaces ZCVF36
12 pages 0.65 mb -
Indoor Fireplace
Napoleon Fireplaces fireplaces
24 pages 7.26 mb -
Indoor Fireplace
Napoleon Fireplaces EPA 1450
21 pages 1.03 mb -
Indoor Fireplace
Napoleon Fireplaces GD82NT
34 pages 7.27 mb -
Indoor Fireplace
Napoleon Fireplaces EF34H
12 pages 1.84 mb -
Indoor Fireplace
Napoleon Fireplaces GVF40N
24 pages 5.01 mb -
Indoor Fireplace
Napoleon Fireplaces GE38PT-M
28 pages 3.31 mb
A good user manual
The rules should oblige the seller to give the purchaser an operating instrucion of Napoleon Fireplaces NZ25, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.
What is an instruction?
The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of Napoleon Fireplaces NZ25 one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.
Unfortunately, only a few customers devote their time to read an instruction of Napoleon Fireplaces NZ25. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.
What should a perfect user manual contain?
First and foremost, an user manual of Napoleon Fireplaces NZ25 should contain:
- informations concerning technical data of Napoleon Fireplaces NZ25
- name of the manufacturer and a year of construction of the Napoleon Fireplaces NZ25 item
- rules of operation, control and maintenance of the Napoleon Fireplaces NZ25 item
- safety signs and mark certificates which confirm compatibility with appropriate standards
Why don't we read the manuals?
Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of Napoleon Fireplaces NZ25 alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of Napoleon Fireplaces NZ25, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the Napoleon Fireplaces service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of Napoleon Fireplaces NZ25.
Why one should read the manuals?
It is mostly in the manuals where we will find the details concerning construction and possibility of the Napoleon Fireplaces NZ25 item, and its use of respective accessory, as well as information concerning all the functions and facilities.
After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.
Table of contents for the manual
-
Page 1
WS-415-71 / 09.07.00 1 INST ALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER. THIS FIREPLACE HAS BEEN TESTED AND LISTED BY WARNOCK HERSEY L TD. TO ST ANDARDS: ULC S610-M87, UL 127-1992, FOR ZERO CLEARANCE FI REPLACES, TO ULC S639-M87 FOR STEEL LINER ASSEMBLIES FOR SOLID FUEL BURNING MASONRY FIREPLACES AND T O CAN/ULC-S627[...]
-
Page 2
WS-415-71 / 09.07.00 2 PLEASE RET AIN THIS MANU AL FOR FUTURE REFERENCE Congratulations on the purchase of your Napoleon hi-tech, high efficient solid fuel burning fireplace! It has been extensively tested in Canadian and American laboratories . PG 2 - 5 INTRODUCTION Warranty General Instructions General Information Care of Glass & Plated Parts[...]
-
Page 3
WS-415-71 / 09.07.00 3 NAPOLEON wood fireplaces are manufactured under the strict Standard of the World Recognized ISO9002 Quality Assurance Certificate. NAPOLEON products are designed with superior components and materials, assembled by trained craftsmen who take great pride in their work. The complete fireplace is thoroughly inspected by a qualif[...]
-
Page 4
WS-415-71 / 09.07.00 4 INTRODUCTION GENERAL INFORMA TION This is the most efficient, sim- ple and trouble free woodburning system we know of and works as follows: Primary combustion air enters through the air control inlet box regulated by a draft control, travels up the side through a duct and enters the top center of the combustion chamber into a[...]
-
Page 5
WS-415-71 / 09.07.00 5 CARE OF GLASS AND PLA TED PA R T S If the glass is not kept clean permanent discolouration and / or blemishes may result. Normally a hot fire will clean the glass. The most common reasons for dirty glass in- clude: not using sufficient fuel to get the stove thoroughly hot, using green or wet wood, closing the draft so far tha[...]
-
Page 6
WS-415-71 / 09.07.00 6 These options may be incorporated with one another . If the optional blowers are to be installed, make provision dur- ing framing to route a 1 10 volt power line to the fireplace. Detailed installation instructions are included with each venting kit. LOCA TION AND CLEARANCES The fir eplace must be installed a gainst finished [...]
-
Page 7
WS-415-71 / 09.07.00 7 HEARTH EXTENSION An acceptable 16" x 50" non-combustible (ie: brick, stone or ceramic tile) hearth extension must be installed. Ensure that the gap between the fireplace and a factory-built hearth extension is sealed with sand/cement grout or covered with a metal strip (or both) to prevent sparks and embers from fal[...]
-
Page 8
WS-415-71 / 09.07.00 8 FIGURE 10 - 4 ELBOWS FIGURE 9 - 2 ELBOWS FIGURE 8 - STRAIGHT UP No Off-Set. Minimum overall chim- ney height is 15 feet. Single off-set with two 15°, 30° or 45° elbows. Minimum overall chimney height is 15 feet. Double off-set with four 15°, 30° or 45° elbows. Minimum overall chim- ney height is 15 feet. CHIMNEY INST AL[...]
-
Page 9
WS-415-71 / 09.07.00 9 1. Move the fireplace into position. Try to center the ex- haust flue of the fireplace, midpoint between two joists to prevent having to cut them. Use a plumb bob to line up the centre. 2. Cut and frame an opening in the ceiling to provide a minimum clearance of 2" between the outside of the chim- ney and any combustible[...]
-
Page 10
WS-415-71 / 09.07.00 10 FINISHING FIREBRICK REMO V AL: The fireplace is shipped with the firebricks in place, how- ever if you need to remove them (ease of installation, re- placement, etc), follow this sequence: Remove the ashwell grate. This allows the bricks to be removed in the following order--the four bottom bricks, the bricks along the rear [...]
-
Page 11
WS-415-71 / 09.07.00 11 OPTIONAL BLOWER INST ALL A TION NST ALLA TION TO BE DONE BY A QUALIFIED INST ALLER and must be electrically connected and grounded in ac- cordance with local codes. In the absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE. 1. Turn off any elec- trical power to the fire- place (if applicable). Open th[...]
-
Page 12
WS-415-71 / 09.07.00 12 NZ25 FEA TURES CONTROLLING COMBUSTION AIR: If the outside combustion air kit is not used, air may still be drawn directly into the fireplace through the lower louvres. Outside and inside air may be combined by pulling the outside air lever out as far as possible, and turning the lever 90° to its locking position. Figure 22.[...]
-
Page 13
WS-415-71 / 09.07.00 13 ASH REMO V AL PROCEDURES A bed of ashes approximately 1 inch deep should be left on the firebox bottom to help maintain a hot charcoal bed. When the fire has burned down and cooled, remove any excess ashes. T o use your ash pan, pull the ash dump handle forward to an open position. Rake the excess ashes over the grate and in[...]
-
Page 14
WS-415-71 / 09.07.00 14 FIRE EXTINGUISHERS AND SMOKE DETECT ORS All homes with a solid fuel burning fireplace should have at least one fire extinguisher in a central location, known to all, and at least one smoke detector in the room containing the fireplace. If it sounds an alarm, correct the cause but do not de-activate or relocate the smoke dete[...]
-
Page 15
WS-415-71 / 09.07.00 15 REPLACEMENT P ARTS P ART N O. DESCRIPTION NZ-H333 BLACK DOOR C / W HANDLE & GASKET NZ-H333G GOLD PLA TED DOOR C / W HANDLE & GASKET WS-300-04 DOOR GLASS ONL Y EP-562.010 DOOR GASKET EP-562.016 GLASS GASKET WS-325-07 LARGE SPRING HANDLE WS-325-02 SMALL SPRING HANDLE GA GD-715.1 1 UPPER LOUVRE - POLISHED BRASS EP-NZ-01[...]
-
Page 16
WS-415-71 / 09.07.00 16 TROUBLE SHOOTING Build your fire on the floor of the firebox and be- hind the log retainer only . Do not block or restrict the hot air outlets or air inlets . This will cause the fir eplace to ov erheat. Keep fires away from the door . DOs : 1. Build a hot fire. 2. Use only dry wood 3. Several pieces of medium sized wood are[...]