English dropdown-ico

ParaBody 889 manual

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16

Go to page of

Similar user manuals

A good user manual

The rules should oblige the seller to give the purchaser an operating instrucion of ParaBody 889, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.

What is an instruction?

The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of ParaBody 889 one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.

Unfortunately, only a few customers devote their time to read an instruction of ParaBody 889. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.

What should a perfect user manual contain?

First and foremost, an user manual of ParaBody 889 should contain:
- informations concerning technical data of ParaBody 889
- name of the manufacturer and a year of construction of the ParaBody 889 item
- rules of operation, control and maintenance of the ParaBody 889 item
- safety signs and mark certificates which confirm compatibility with appropriate standards

Why don't we read the manuals?

Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of ParaBody 889 alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of ParaBody 889, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the ParaBody service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of ParaBody 889.

Why one should read the manuals?

It is mostly in the manuals where we will find the details concerning construction and possibility of the ParaBody 889 item, and its use of respective accessory, as well as information concerning all the functions and facilities.

After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.

Table of contents for the manual

  • Page 1

    1 889 WEIGHT ST ACK OPTION CLASS H PAR T # 7305301 REV . A Revision: 06/19/02 USER’S GUIDE W ARNING: Read and follow all directions for each step to insure proper assembly of this product. V ersion: 889108[...]

  • Page 2

    THERE IS A RISK ASSU MED BY IND IVIDUALS W H O USE THIS TY PE OF EQUIPMENT. TO MINIMIZE RISK F OLLOW THE SE RULES ! 1. Before u sing, read al l the w arnings and in structions on the use of this mach ine. Use only for in tended exercise. DO NOT mo dify the m achine. 2. Obtain a medica l exam bef ore begi nning any exercise pro gram. 3. Keep body a [...]

  • Page 3

    IMPOR T ANT NOTES Please note: T ools Required for Assembly * Thank you for purchasing the ParaBody 889 W eight Stack Option. Please read these instructions thoroughly and keep them for future reference. This product must be assembled on a flat, level surface to assure its proper function. * 3/4” wrench * 9/16” wrench * Ratchet with 3/4” and [...]

  • Page 4

    4 P AR TS LIST PA R T # LEA6814309 LEA6800610 LEA6814009 LEA6813709 LEA6801110 LEA6816501 LEA6274410 LEA6725310 LEA3116201 LEA3116101 LEA6832801 LEA6671002 LEA6692601 LEA3103102 LEA3103302 LEA6405201 LEA6972201 LEA6177001 LEA3119301 LEA6236701 LEA6412001 KEY 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 QTY 1 1 1 1 1 2 1 1 5 1 1 1 2 4 2 4 1[...]

  • Page 5

    STEP 2: FIGURE 2 • Insert two 2” END CAP (16) into the ends of the ST ACK BASE (3) as shown in FIGURE 2. • Attach four 3/4 X 1-1/2” GLIDES (24) to the inside of the tube on the ST ACK BASE (3) as shown in FIGURE 2 using the following steps: • Thoroughly clean all surfaces where the 3/4 X 1-1/2” GLIDES (24) are to be attached. • Remove[...]

  • Page 6

    6 FIGURE 4 STEP 4: • SECUREL Y assemble the ST ACK BASE (3) and the UPRIGHT (1) to the LOWER CROSS SUPPOR T using two 3/8 X 4” BOL TS (38), four 3/8” W ASHERS (30), and two 3/8” LOW HEIGHT LOCK NUTS (29). See FIGURE 4. 3/8 X 4” 38 29 1 LOWER CROSS SUPPOR T 3 UPRIGHT FRAME 30 30 • NOTE: It may be necessary to loosen the 1/2 X 3-1/4” BO[...]

  • Page 7

    7 0 1 2 34 5 6 1/2 1/2 1/2 1/2 1/2 1/2 FIGURE 5 STEP 5: • Insert two GUIDE RODS (6) into the ST ACK BASE (3) as shown in FIGURE 5. Lubricate the GUIDE RODS (6) with a silicon or teflon spray that is available at most hardware stores. • Slide two WEIGHT ST ACK CUSHIONS (26) down over the GUIDE RODS (6). See FIGURE 5. • Using EXTREME CARE slide[...]

  • Page 8

    8 STEP 6: FIGURE 6 • LOOSEL Y assemble the T OP BOOM (4) to the UPPER CROSS SUPPOR T using two 3/8 X 4” BOL TS (38), four 3/8” W ASHERS (30) and two 3/8” LOCK NUTS (31). See FIGURE 6. • Insert two 3 X 2” END CAPS (13) into the ends of the TOP BOOM (4). See FIGURE 6. • SECUREL Y tighten all connections made up to this point. 38 3/8 X 4[...]

  • Page 9

    9 0 1 2 34 5 6 1/2 1/2 1/2 1/2 1/2 1/2 STEP 8: FIGURE 8 • Route the 1 15-3/4” CABLE (12) through the T OP BOOM (4) as shown in FIGURE 8. (NOTE: It may be necessary to r emove the 3/8 X 2-3/4” BOL T to ensure CABLE is r outed over the T OP of the BOL T .) • SECUREL Y assemble three 3-1/2” PULLEYS (9) into the slots of the T OP BOOM (4) usi[...]

  • Page 10

    STEP 9: FIGURE 9 10 31 • Place one 3-1/2” PULLEY (9) into the loop of the CABLE (12) below the second and third PULLEY of the TOP BOOM (4) as shown in FIGURE 9. • LOOSEL Y assemble two 3/16 X 1-3/4 X 5-1/4” PLA TES (23) to each side of the 3-1/2” PULLEY (9) using one 3/8 X 2” BOL T (35), two 3/8” W ASHERS (30), and one 3/8” LOCK NUT[...]

  • Page 11

    11 STEP 10: FIGURE 10 • Route the threaded end of the 124” CABLE (1 1) through the slot of the UPRIGHT (1) then SECUREL Y assemble one 4-1/2” PULLEY (10) to the UPRIGHT (1) using two 3/8 X 2-3/4” BOL TS (32), two 3/8” FLANGE SP ACERS (33), two 3/8” W ASHERS (30), and two 3/8” LOCK NUTS (31). (NOTE: The CABLE (1 1) should be r outed be[...]

  • Page 12

    12 STEP 1 1: FIGURE 1 1 • Loop the 124” CABLE (1 1) around one 3-1/2” PULLEY (9) as shown in FIGURE 1 1. • LOOSEL Y assemble the 3-1/2” PULLEY (9) to the 3/16 X 1-3/4 X 5-1/4” PLA TES (23) using one 3/8 X 2” BOL T (35), two 3/8” W ASHERS (30), and one 3/8” LOCK NUT (31). See FIGURE 1 1. • SECUREL Y thread the end of the 124” C[...]

  • Page 13

    13 STEP 12: FIGURE 12 Thank you for pur chasing the Parabody 889 WEIGHT ST ACK OPTION. If unsure of pr oper use of equip- ment, call your local Parabody distributor or call the Parabody customer service department at (800) 328-9714. • Attach the LA T BAR (8) to the ball end of the upper CABLE (12) using one 5/16” SNAP HOOK (34) as shown in FIGU[...]

  • Page 14

    MAINTENANCE MODEL #________________________ SERIAL #_________________________ DA TE OF PURCHASE: _____________ DEALERS NAME: _________________ DEALERS PHONE #_______________ 14 * W e recommend cleaning your product (pads and frame) on a regular basis, using warm soapy water . T ouch-up paint can be purchased from your ParaBody customer service repr[...]

  • Page 15

    15 NOTES: LIMITED W ARRANTY ParaBody extends the following LIMITED W ARRANTY to the original owner of the ParaBody products. The W arranty terms apply to IN HOME USE ONL Y . 1. LIMITED W ARRANTY ON FRAME AND WELDS. If the frame of the ParaBody product or a weld should crack or break, it will be repair ed or replaced by ParaBody . T erms: Lifetime ?[...]

  • Page 16

    INTERNA TIONAL OFFICES Life FitnessAtlantic BV Atlantic Headquarters Bijdorpplein 25-31 2992 LB Barendrecht The Netherlands Phone: (180) 646 666 Fax: (180) 646 703 Life Fitness Japan 8/F , Nippon Brunswick Building 5-27-7 Sendagaya Shibuya-Ku, T okyo 151-0051 Japan Phone: 81 (3) 3359-4309 Fax: 81 (3) 3359-4307 Life Fitness (UK) Ltd. Queen Adelaide [...]