Electrolux TBUL 140 manual

2222683-04 OPERA TING AND INST ALLA TION INSTRUCTIONS FREEZER TBUL 140[...]

2 General Safety • This appliance contains hydrocarbons in it s cooling unit; maintenance and recharging must therefore only be carried out by authorised technicians. • T ake utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. • The appliance must not be located [...]

Instructions for the User Important Safety Instructions . . . . . . . . . . . . . . . .2 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Before use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Setting the temperature . . . . . . . . . . . . . . . . . . . . . .4 Fresh food refrigeration . . . . . . . . [...]

Operation 4 Fresh food refrigeration T o obt ain the best performance, do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour . Do not cover the shelves with any protective material, such as paper , cardboard or plastic, which could obstruct the air circulation. T o help[...]

Normal Operating Sounds Y ou may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear , to the cooling plate. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor . A thermostat controls the compressor , an[...]

6 Defrosting The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located below the appliance, where it evaporates. Important T o avoid defrost water overflowing and dripping onto the food in the fridge, periodically clean the water discharge hole (F) situated under the salad dr[...]

7 When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply , empty all foods and clean the appliance, leaving the door ajar to prevent unpleasant smells. Something not W orking? Before contacting your local Service Force Centre check the following points. IMPORT ANT : If you call out[...]

8 Service and Sp are Part s In the event of your appliance requiring service, or if you wish to purchase spare part s, please contact your local Service Force Centre by telephoning:- 08705 929929 Y our telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Ce[...]

9 St andard guarantee conditions We, T ricity Bendix, undertake that if within 12 months of the date of purchase this T ricity Bendix appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour , materials or carriage on condit[...]

Positioning The appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located on the inside right of the appliance. The following table shows which ambient temperature is correct for each climate classification. SN +10°C to +32°C ST +18°C t[...]

11 Door reversal T o reverse the opening direction of the door , proceed as shown in the figures: Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitt[...]

12 If you fit your own plug, the colours of the wires in the mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows: Connect the Green and the Y ellow (earth) wire to the terminal in the plug which is marked with the letter «E» or the earth symbol , or coloured green and yello[...]

13 Building-in instructions Before carrying out any work, remove the plug from the power socket. Grid prep aration Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure). T o position the grid on the appliance proc[...]

14 B 4 1 5. Screw appliance into place and retain the cabinet with screws (I) through the securing brackets into the worktop or adjacent woodwork as necessary . 4. The joint cover (B) is to be assembled after having installed the appliance in the recess. 2. Push the appliance into place. The plug socket necessary for connection of the appliance to [...]

15 7 ab c C click click 8 b = = 9 I c Möbeltür Innenseite a Upper part of kitchen furniture panel I 27,5 cm 27,5 cm 55 cm 10 F 1 2 3 45 ° 11 = = 10 12 1 2[...]

Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. • For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=890 mm and a plinth height dimensi[...]

[...]

[...]

[...]

T ricity Bendix, 55-77 High Street, Slough, Berkshire SL1 1DZ Consumer care telephone number……08705 950950 © Electrolux plc 2006[...]