Emerson CF725GES00 manual

Part No. F40BP73690000 Form No. BP7369 U.L. Model No.: CF725 READ AND SA VE THESE INSTRUCTIONS Net W eight: 23.4 Lbs. VIENNE ™ 52” Ceiling Fan Owner's Manual CF725GBZ00 CF725GES00 Model No. INSTRUCTION TO THE USER (if device contains a digital device) This equipment has been tested and found to comply with the limits for a Class B digital [...]

2 W ARNING: T o avoid fire, shock, and serious personal injury , follow these instructions. Safety Instructions 1. Read your owner ’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accident[...]

3 This Manual is Designed to Make it as Easy as Possible for Y ou to Assemble, Install, Operate and Maintain Y our Ceiling Fan Do not install or use fan if any part is damaged or missing. Call T oll-Free: 1-800-654-3545 ! W ARNING This product is designed to use only those parts supplied with this product and/or any accessories designated specifica[...]

1. T wo 1-1/4” threaded studs 2. T wo knurled knobs 3. T wo lockwashers 4. Three wire connectors 5. One clevis pin 6. One hairpin clip 7. Eleven M5 x 18mm oval head screws 8. Sixteen M5 x 6mm slotted Phillips washer head screws 4 m. One loose parts bag containing: NOTE: Place the parts from the loose parts bags in a small container to keep them f[...]

5 General Y our Emerson ceiling fan comes supplied with a SW102 Fan/Light W all Control and a Remote Control Receiver . This system allows you to regulate your ceiling fan speed and light intensity . NOTE: An optional Emerson Electric SR100 Remote Control may also be used to control your ceiling fan. Ceiling Fan Procedur es IMPORT ANT : Before asse[...]

6 4. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 3). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 10. PIN HANGER BALL SETSCREW DOWNROD Figure 3 HAIRPIN CLIP MOTOR COUPLING SETSCREW (2) CLEVIS PIN DO[...]

7 REINST ALL THREE M4 x 15mm P AN HEAD SCREWS AND RUBBER WASHERS UPPER HOUSING RING MOTOR AND UPPER HOUSING ASSEMBL Y Figure 5 9. Make sure the grommet is properly installed in the coupler cover , then slide the coupler cover on the downrod until it rests on the motor and upper housing assembly (Figure 6). 10. Place the ceiling canopy over the down[...]

8 T o reduce the risk of fire, electric shock, or personal injury , mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt. ! W A[...]

9 1. Position the supply wires to the left side of the outlet box (Figure 10); position the fan wires to the right side. Partially insert the remote control receiver (flat side up) until one end rests on the hanger ball as shown in Figure 10. NOTE: Make all wiring connections using wire connectors (supplied). Make sure that all connections are tigh[...]

T o avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling canopy and the ceiling. ! W ARNING SW102 F AN/LIGHT WALL CONTROL (SUPPLIED) BLACK BLACK WHITE RED BLACK WHITE HANGER BALL GREEN WIRE (GROUND) FROM HANGER BALL AND HANGER BRACKET TWO-CONDUCTOR CABLE (WITH GRO[...]

10. Screw in two 60-watt (maximum) candelabra bulbs (supplied) in the light fitter sockets (Figure 14). 11 . Remove the finial nut, hex nut and washer from housing downlight assembly . 12. Position the glass over the threaded nipple. Slide the washer onto the threaded nipple and gently tighten the hex nut to secure the glass and washer . Install fi[...]

Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility of an electrical shock. ! W ARNING The use of any other control not specifically approved for this fan could result in fire, shock and personal injury . ! W ARNING This product is designed to use only those parts supplied with this pr[...]

T rouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. Check main and branch start. blown. circuit fuses or circuit breakers. W ARNING: Make sure main power is turned off. 2. Loose power line 2. Check line power connections connections to the fan. to fan. 3. Code switches in remote 3. Check that both[...]

Repair Parts 9 3 2 1 5 4 12 19 16 8 10 20 11 13 6 7 17 14 16 22 15 18 21 23 FAN OFF LOW MED HI LIGHT Before discarding packaging material, be certain all parts have been removed. HOW TO ORDER REP AIR P ARTS WHEN ORDERING REP AIR P ARTS, AL W A YS GIVE THE FOLLOWING INFORMA TION: • P ART NUMBER • NAME OF ITEM • P ART DESCRIPTION • MODEL NUMB[...]

Part Numbers Key Model No. Model No. N o . Description CF725GBZ00 CF725GES00 * Hanger Pack, Consisting of: 761655-75 761655-76 1 Hanger Bracket — — 2 Hanger Ball — — 3 Downrod — — * Parts Bag, Containing: 763737 763737 4 Wire Connector (3) — — 5 Threaded Stud, 1-1/4” (2) — — 6 Knurled Knob, 8-32 (2) — — 7 Lockwasher , #8 ([...]

LIMITED WARRANTY What The War ranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. Y ou must be the original pur chaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor , this warranty will l[...]