Epson L1000 manual

EPSON AMERICA, INC. EPSON Product Support Bulletin Subject: 24 Pin Printer Error and Beep Codes Date: 4/3/91 PSB No: P-0076 Page(s): 1 of 4 Originator JV Epson printers issue beep tones when certain error conditions exist. Those beeps can assist you in locating and repairing customer’s printers. The following error codes are listed by product nam[...]

PSB No: P-0076 Page: 2 of 4 LQ-800, LQ-1000, L750 1 beep: BEL code 1 beep: A Control Panel setting is accepted 3 beeps: Paper End detected 5 beeps: Abnormal carriage movement (.5 sec. pause between beeps) 5 beeps: LQ-860 +35V supply is abnormal 1 beep: BEL code (.5 sec. beep) 1 beep: A Control Panel setting is accepted 3 beeps: Paper End detected 5[...]

PSB No: P-0076 Page: 3 of 4 LQ-2500 NOTE: Printers with LCD displays use error messages along with beeps to inform the user of problems. The following messages will help you to troubleshoot problems. A blank LCD screen with the Power-on LED lit can be caused by a bent pin on one of the PROM S or jumper J1 may be set incorrectly. 1 beep: BEL code 5 [...]

PSB No: P-0076 Page: 4 of 4 LQ-2550 cont. 03 10 11 12 20 A ‘Verify After Write” check to the SRAM has failed. The SRAM could be bad. This is a motor control error. Four possible areas of failure are: a. CR home condition not detected at power up b. Platen gap motor HP not detected correctly c. Friction/Tractor feed switching error d. Physical o[...]

Product Support Bulletin Subject: Power Specifications Date: 2/7/90 PSB No: P-0060 Page: 1 of 2 Originator: RFB The following information is a list of the power requirements for the Epson 9 and 24 pin printers and laser printers. 504 VA maximum[...]

PSB No: P-0060 Page: 2 of 2 Product 1 Voltage 1 Max. Current Consumption 1 Power Consumption 1 BTU/HR LX810 1 12ov .7 Amp 84 VA maximum I 286.69 T750 120v 1.0 Amp 120 VA maximum 409.56 TlOOO 120v .7 Amp 84 VA maximum 286.69 If the power requirements of a particular Epson printer is not listed please refer to the appropriate User's Manual for t[...]

EPSON EPSON AMERICA, INC. INFORMA Product Support Bulletin Subject: Tractor Pin Alignment Date: 5/15/89 PSB No: P - 0044 Page: 1 of 1 Originator: RP bd The purpose of this bulletin is to insure the proper installation and alignment of the FX- 850/1050 and LQ- 850/1050 push tractor assemblies. There are two possible ways to install the tractor frame[...]

P RODUCT S UPPORT B ULLETIN PSB NO.: P-0035 DATE: 11/29/88 PAGE: 1 of 3 SUBJECT: LQ-850/950/1050 PRINTER QUESTIONS Q: How do I get the short tear off feature to work? A: The first step is to turn the dip switch 2-7 to the "ON" position. Then there are two ways to activate the short tear off. The first way is to send a form feed at the end[...]

NUMBER: P-0035 PAGE: 2 of 3 Q: A: Q: A: Q: A: Q: A: Q: A: Q: A: Q: A: What fonts are built into the LQ-850/950/1050? Draft Roman(10cpi, 12cpi, 15cpi) Roman Proportional Sans Serif(10cpi, 12cpi, 15cpi) Sans Serif Proportional Are there any optional fonts available? Courier(10cpi, 12cpi, 15cpi) : Font Module #7400A Prestige(10cpi, 12cpi, 15cpi) : Fon[...]

NUMBER: P-0035 PAGE: 3 of 3 Q: A: Q: A: Q: A: Q: A: Q: A: Q: A: Q: A: What if I want to install an optional serial interface board? Install the optional interface as detailed in the User's Manual. Then set the dip switches on the printer to the parallel position and then set the dip switches on the optional interface board to enable it. Which [...]

EPSON EPSON AMERICA, INC. SERVICE P RODUCT S UPPORT B ULLETIN PSB NO.: P-0028 DATE: 8/1/88 PAGE: 1 of 1 SUBJECT: PDOS FOR THE LQ-850/950/1050 PRINTERS The following contains information on using the LQ-850/ 1050 PDOS diagnostics (#B765108801 for MS-DOS compatible, #B765108901 for QX-16 computers) to troubleshoot the LQ- 850/950/1050 series printers[...]

EPSON EPSON AMERICA, INC. SERVICE P RODUCT S UPPORT B ULLETIN PSB NO.: P-0020 DATE: 5/6/88 PAGE: 1 of 2 SUBJECT: LQ-850/1050 PAPER THICKNESS LEVER Reports from the field and from various repair locations show that a large percentage of print head failures could be caused by an incorrect paper thickness setting. The following table shows general gui[...]

NUMBER: PO020 PAGE: 2 of 2 FIGURE 1.1 Location of paper thickness lever and settings in the LQ-850/ LQ 1050 printers. New label to be inc beginning in April FIGURE 1.2 luded in LQ-850/1050 printers produced 1988.[...]

EPSON EPSON AMERICA, INC. INFORMATION Product Support Bulletin Subject: Epson Dot - Matrix Printer Options and Accessories Date: 8/1/89 Page: 1 of 2 PSB No: P-0017B Originator: RFA 9 - PIN DOT MATRIX OPTIONS LX-810 FX-850 FX-1050 DFX-5000 TRACTOR UNITS PULL TRACTOR C800061 7311 -A 7312-A 8309-A CUT SHEET FEEDERS SINGLE BIN C806121 7339-A 7340-A DOU[...]

PSB No: P-0017B Page: 2 of 2 24 - PIN MATRIX OPTIONS TRACTOR UNITS PULL TRACTOR CUT SHEET FEEDERS SINGLE BIN DOUBLE BIN INTERFACE BOARDS SERIAL - 0K BUFFER - 8K BUFFER PARALLEL - 32K BUFFER IEEE 488 - 8K BUFFER CABLES STANDARD IBM PARALLEL SERIAL DB-25 TO DB-9 SERIAL DB-25 TO DB-25 SERIAL DIN-6 TO DB-9 SERIAL DIN-6 TO DB-25 APPLE ][e, DB-25 TO DIN-[...]

EPSON AMERICA, INC. EPSON Product Support Bulletin Subject: Quick Reference for Printer Acoustic Noise Levels Date: 6/5/91 PSB No: P-0016D Page(s): 1 of 2 Originator: SLS Sound intensity is measured in units called Bels (named after Alexander Graham Bell,) or more commonly in tenths of this fundamental unit: decibels. In making noise measurements a[...]

PSB No: P-0016D Page: 2 of 2 MODEL NOISE LEVEL LQ-860 55 dB(A) LQ-1050 55 dB(A) LQ-2550 55 dB(A) LASER PRINTERS[...]

EPSON EPSON AMERICA. INC. SERVICE P RODUCT S UPPORT B ULLETIN Date: 3/1/88 Subject: Epson Printer/Ribbon Compatibility Number: P-0013A PURPOSE: This list will assist in ribbons to printers. the correct matching of Epson The numbers listed below are the Epson part numbers and can be used to order ribbons. This list supercedes PSB-013. EAI # 7751 N/A[...]