ACTi ACM-1231 инструкция обслуживания

MegaPixel IP Outdoor IR Bullet Camera (with DC 12V / PoE / AC 24V) ACM-1230 series Ver. 081016 Hardware User’s Manual[...]

0-1 0 PRECAUTIONS 1. Read these instructions All the safety and operating instructions should be read before the product is operated. 2. Heed all warnings All warnings on the product and in the instruction manual should be adhered to. The symbol indicates the following item s, please carefully read the description next to each symbol. a. Failure to[...]

0-2 and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harm ful interference to radio communications. Operation of this equipment in a reside ntial are a is likely to cause harmf ul interference in which case the user will be required to correct th e interference at his own exp[...]

0-3 Table of Contents 0 PRECAUTIONS________________________________________________ 0-1 Trademarks ________________________________________________________________ 0-1 Liability ___________________________________________________________________ 0-1 FCC/CE R egulati on __________________________________________________________ 0-1 1 INTRODUCTION __[...]

1-1 1 INTRODUCTION 1.1 Package Contents ACM-1230 series Power Adaptor (Option) (DC12V / PoE / AC24V) Product CD Terminal Block for Power Warranty Card 1[...]

1-2 1.2 Features and Benefits This IP device is a cutting-edge digi tal video transmission device. It can compress and transmit real tim e images with outstanding im ages quality (SXGA, 1280x1024) at reasonable bandwidth through a standard TCP/IP network. That is because it is Ethern et ready and has the powerful ARM9 SoC with excellent system perf[...]

1-3 delivers better sensitivity and responds f aster than software motion detection. z Bundle Powerful Surveillance Software To extend the capabilities of this IP d evice, a powerful surveillance program is included in the package and is very free to use. Users can easily utilize the existing PC to be a digital video recorder. Schedule recording an[...]

1-4 1.3 Safety Instructions z Don’t use the po wer supply with other voltages This device is likely to be damaged or damage other equipm ents / personnel, if you use a power supply w ith different voltage than the one included with this device. All warranty of this product will be voided in the situations above. z Don’t open the housing of the [...]

1-5 operating Instructions in this ma nual. Adjust only those controls that are covered by the instru ction manual as an improper adjustment . Other controls m ay result in damage and will often require extensive work by a qualif ied technician to restore the video product to its normal operation. z Safety Check Upon completion of any service or re[...]

1-6 1.4 Physical Description 1. Power Input If your power input is DC12V. Please follow the description on the connector to connect to power. If your power input is AC24V. Please follow the description on the connector to connect to power. PIN NAME DESCRIPTION 1 N 2 L AC Power Input 3 GND E-Ground of power PIN NAME DESCRIPTION 1 12V DC Power Input [...]

1-7 2. Audio Input / Output The IP device supports audio i nput and output, with terminal block. 3. Reset Button Step 1: Switch off IP device by di sconnecting the power cable Step 2: Press and continue to hold th e Reset Button. Reconnect the power cable while continui ng to hold the reset button. Step 3: Keep holding the reset butto n depressed f[...]

1-8 1.5 Basic Connections Follow the procedures below to conn ect the IP device to the respective apparatuses. 1. Connect the power adaptor to IP device 2. Connect IP device’s ethern et port to an Ethernet (RJ45 connectors). If your IP device has PoE built-in, you can re gard it as a PD and connect it directly to a PSE device like PoE switch. 3. [...]

1-9 1.6 Installation Procedure 1.6.1 Loosen the screws, and remove cam era back 1.6.2 Connect cables through conduit hole[...]

1-10 1.6.3 I/O connecting Reference section 1.4 Physical Description for detail spec of I/O connecting. 1.6.4 Install camera back and tighten the screws[...]

1-11 1.6.5 Loosen the screws and remove sunshield 1.6.6 Install the camera onto bracket[...]

1-12 1.6.7 Rotate camera box counter-cl ockwise t o remove camera cover 1.6.8 Adjust the focus / zoom - Zoom adjust lever - Focus adjust lever[...]

1-13 1.6.9 Install sunshield and camera cover back[...]

1-14 1.7 Product Specification[...]